Seiko Epson AP013 Expanded sensor User Manual 05 Short Term Confidential 2

Seiko Epson Corporation Expanded sensor 05 Short Term Confidential 2

Contents

05 (Short-Term Confidential) User Manual-2

Download: Seiko Epson AP013 Expanded sensor User Manual 05  Short Term Confidential   2
Mirror Download [FCC.gov]Seiko Epson AP013 Expanded sensor User Manual 05  Short Term Confidential   2
Document ID3475176
Application IDNjprsQRo9YdW5M83SCDOkg==
Document Description05 (Short-Term Confidential) User Manual-2
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize11.06kB (138212 bits)
Date Submitted2017-07-21 00:00:00
Date Available2018-01-17 00:00:00
Creation Date2017-07-13 13:35:40
Producing SoftwareAcrobat Distiller 10.1.2 (Windows)
Document Lastmod2017-07-13 13:35:40
Document TitleMicrosoft PowerPoint - 別紙_FCCIC Manual TR_MB8 MB00.pptx
Document CreatorPScript5.dll Version 5.2.2
Document Author: 38775

**Explanation that an SAR examination is unnecessary with Portable
equipment**
TREUM
Sensor solor GPS watch
Use for EPSON sensor solar GPS Watch “TREUM
This GPS watch comes with a dedicated sensor.
When you start to use the product, Please read the TREUM Users
Manual page at “Preparing to Measure expanded sensor
CAUTION:Risk of explosion if battery is replaced by an incorrect type.
CAUTION:Dispose of used batteries according to the instructions.
FCC /IC Notices
This transmitter must not be co‐located or operated in
conjunction with any other antenna or transmitter
Certification information
Model:MB00
Model:TR‐MB8
FCC ID : BKMAP012
IC: 1052E‐AP001
FCC ID : BKMAP013
IC: 1052E‐AP002
※dedicated sensor
This device complies with part 15 of FCC Rules and Industry Canada’s licence‐exempt
RSSs. Operation is subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Le présent appareil est conforme à la partie 15 des règles de la FCC et aux normes des
CNR d‘Industrie Canada applicables aux appareils radio exempts de licence.
L’exploitation est autorisée aux deux conditions suivantes : (1) l‘appareil ne doit pas
produire de brouillage, et (2) l’appareil doit accepter tout brouillage subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.
Caution:
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This equipment complies with FCC/IC radiation exposure limits set forth for
an uncontrolled environment and meets the FCC radio frequency (RF)
Exposure Guidelines and RSS‐102 of the IC radio frequency (RF) Exposure
rules. This equipment has very low levels of RF energy that are deemed to
comply without testing of specific absorption ratio (SAR).
Cet équipement est conforme aux limites d’exposition aux rayonnements
énoncées pour un environnement non contrôlé et respecte les règles les
radioélectriques (RF) de la FCC lignes directrices d'exposition et
d’exposition aux fréquences radioélectriques (RF) CNR‐102 de l’IC. Cet
équipement émet une énergie RF très faible qui est considérée conforme
sans évaluation du débit d’absorption spécifique (DAS).
**Explanation of the EMC demand part of the United States. **
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However,there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of
the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Manufacture by SEIKO EPSON CORPORATION
Address: 3‐5, Owa 3‐chome, Suwa‐shi , Nagano‐ken 392‐8502
Japan
http://www.epson.com
Importer/Contact:Epson America , Inc.
Address: 3840 Kilroy Airport Way Long Beach, CA 90806 U.S.A
http://www.epson.com/cgi‐bin/Store/jsp/index.do

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.5
Linearized                      : Yes
Author                          : 38775
Create Date                     : 2017:07:13 13:35:40+09:00
Modify Date                     : 2017:07:13 13:35:40+09:00
XMP Toolkit                     : Adobe XMP Core 5.2-c001 63.139439, 2010/09/27-13:37:26
Creator Tool                    : PScript5.dll Version 5.2.2
Producer                        : Acrobat Distiller 10.1.2 (Windows)
Format                          : application/pdf
Title                           : Microsoft PowerPoint - 別紙_FCCIC Manual TR_MB8 MB00.pptx
Creator                         : 38775
Document ID                     : uuid:62e77126-f317-4e3f-8b0b-555409b71c8d
Instance ID                     : uuid:d376ed49-e38e-4659-bffe-514f5f67b4b0
Page Count                      : 1
EXIF Metadata provided by EXIF.tools
FCC ID Filing: BKMAP013

Navigation menu