Sensys Gatso Netherlands RT3 RT3 Antenna User Manual Addendum

Gatsometer BV RT3 Antenna Addendum

Contents

Addendum

FCC INFORMATION (additional)
Module integration instructions:
This device is intended only for integration under the following conditions: (I).The antenna must be
installed such that 20 cm is maintained between the antenna and users. (II). The transmitter module may
not be co-located or operating in conjunction with any other transmitter or antenna. (III). The module shall
be only used with the external antenna(s) that has been originally tested and certified with this module,
custom design antennas may not be used without re-certification.
As long the conditions above are met, further transmitter testing will not be required. However, the
integrator is still responsible for testing the end-product (¨host¨) towards any additional compliance
requirements required with this module installed (for example, digital device emissions, PC peripheral
requirements, etc.).
Validity of using the module certification:
In the event that these conditions cannot be met, then the FCC authorization for this module in
combination with the host equipment is no longer considered valid and the FCC ID of the module cannot
be used on the final product. In these circumstances, the integrator will be responsible for re-evaluating
the end-product (including this modular transmitter) and obtaining a separate FCC authorization.
End product labeling:
The final end-product must be labeled in a visible area with the following: “Contains FCC ID: TVO-RT3”.
Information that must be placed in the end user manual:
The integrator has to be aware not to provide information to the end user how to install or remove this RF
module in the user's manual of the end-product which integrates this module. The end user manual of the
final end-product shall include all required regulatory information/warning as shown in this manual.
INDUSTRY CANADA INFORMATION (additional)
This device complies with RSS-210 of the Industry Canada Rules.
This class B digital apparatus complies with Canadian ICES-003
This equipment should be installed and operated with a minimum distance of 20 cm between the radiator
and your body.
The final end-product must be labeled in a visible area with the following: “Contains IC: 6271A-RT3”.
AVIS D’INDUSTRIE CANADA (supplémentaire):
Cet appareil est conforme à la norme CNR-210 des règlements d’Industrie Canada.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada
Avis d’Industrie Canada sur l’exposition aux Rayonnements: Cet équipement doit être installé et utilisé à
une distance minimale de 20 cm entre le radiateur et votre corps.
Le produit final final doit être étiqueté dans un endroit visible par le texte suivant: "Contains IC: 6271A-RT3".

Navigation menu