Sercomm SZSMK01 ZigBee Smoke Detector User Manual

Sercomm Corporation ZigBee Smoke Detector Exhibit 08 Users Manual

a href="https://usermanual.wiki/Sercomm" itemprop="url"> Sercomm >

Exhibit 08 Users Manual

1 SZ-SMK01 ZigBee SMOKE ALARM Installation Guide The SZ-SMK01 is a Smoke Alarm that is designed to detect smoke, which maybe a signal of a fire. This device can provide more time by making alarms for you and your family to escape before a fire spreads. Specification Batter Type 3V lithium battery (CR123A 3V) Operating Temperature -10 C to 50 C (14° - 122°F) Operating Humidity 10% to 85% Non-condensing Alarm Audibility At least 85 dB at 3 meters Dimention 120mm (diameter) x 53mm (depth) Package Contents LEDs  Stand-by Mode: The device is under normal operation if the red LED flashes once for 1034 seconds. When the device senses smoke, the red LED will flash continuously and rapidly while sounds an audible alarm with 3 beeps, pause and 3 beeps.  Low Battery Mode: The red LED flashes and the device begins to chirp once in 43 seconds. This warning should last for up to 30 days. Please replace the battery before power is running out to secure your protection.  Malfunction (Error) Mode: The yellow LED flashes three times and the device generates 3 beeps within 43 seconds. This indicates the device is malfunctioned and needs to be repaired or serviced.  Tamper Mode: The device will generate 3 beeps and the yellow LED is steadily on if the smoke alarm is not mounted into the bracket properly within 5 minutes after the battery is installed.
2Intallation Battery Installation/Replacement 1. Open the battery cover of the device. 2. Install the supplied battery correctly. 3. Close the battery cover. 4. Install the bracket. Note: you will hear a chirp after install the bracket which indicates the device is receiving battery power. Recommended Battery Type Please use the following suggested battery. Use of a different battery may cause a detrimental effect on alarm operation.  CR123A 3V battery Locations to install your SZ-SMK01 Smoke alarms should be installed in accordance with the NFPA Standard 72 (National Fire Protection Association, Battery march Park, Quincy, MA 02169). For complete coverage, smoke alarms should be installed in all rooms, halls, storage areas, basements, and attics in each family. Minimum coverage is one device in each floor and another one in sleeping area.  Install a smoke alarm in the hallway outside every bedroom area. For example, two alarms are required for homes with two bedroom areas.  Install a smoke alarm on every floor of a multi-floor home or apartment.  Install at least two alarms in a household.  Install a smoke alarm inside every bedroom.  Install smoke alarms at both ends of a bedroom hallway if the hallway is more than 40 feet (12 meters) long.  Install a smoke alarm inside every room where a person sleeps with the door partly or completely closed, since smoke could be blocked by the closed door and a hallway alarm may not wake up the person if the door is closed. Do not place the device in the following areas:  Combustion particles are the by-products of something that is burning. Thus, in or near areas where combustion particles are present you do not install the smoke alarms to avoid nuisance alarms, such as kitchens with few windows or poor ventilation, garages where there may be vehicle exhaust, near furnaces, hot water heaters, and space heaters.  Do not install smoke alarms less than 20 feet (6 meters) away from places where combustion particles are normally present, like kitchens. If a 20-foot distance is not possible, e.g. in a mobile home, try to install the alarm as far away from the combustion particles as possible, preferably on the wall. To prevent nuisance alarm alarms, provide good ventilation in such places. Within 5 feet (1.5 meter) of open flame appliances such as furnaces, stoves and fireplaces
Download:
Mirror Download [FCC.gov]
Document ID1922012
Application IDanEyJfnuuwwVn3rYJ3JbEw==
Document DescriptionExhibit 08 Users Manual
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize15.71kB (196367 bits)
Date Submitted2013-03-21 00:00:00
Date Available2013-03-21 00:00:00
Creation Date2013-03-15 15:11:00
Producing SoftwareAcrobat Distiller 9.5.3 (Windows)
Document Lastmod2013-03-15 15:11:00
Document TitleMicrosoft Word - SZ-SMK01_QIG_20130121 _User Manual_.doc
Document CreatorPScript5.dll Version 5.2.2
Document Author: kayla.lin
FCC ID Filing: P27SZSMK01

Navigation menu