Serome Electronics SRE01035 ADSL Modem User Manual Manual VisionNet708
Serome Electronics Inc. ADSL Modem Manual VisionNet708
Contents
- 1. users manual 1
- 2. users manual 2
users manual 1
VisionNet 708 User’s Manual VisionNet 708 ADSL Ethernet Modem A D S L Modem Manual Copyright 2002 DQ Technology Inc. All Rights Reserved. No part of this publication may be reproduced or distributed in any form or by any means, or stored in a database or retrieval system, without the prior written permission of DQ Technology, Inc. A D S L Modem Manual Contents Chapter 1. Introduction ▣ What is ADSL -- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 5 ▣ VisionNet 708 Layout and LED Description -- - - - - - - - - - - - - - - - - - 6 ▣ VisionNet 708 Specification ------- - - - - - - - - - - - - - - - - - - - - - - - - 9 Chapter 2. Before Installation ▣ Safety Check- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 1 1 ▣ The climate condition Check- - - - - - - - - - - - - - - - - - - - - - - - - - - 1 1 ▣ System Requirement Check - - - - - - - - - - - - - - - - - - - - - - - - - - - 1 2 ▣ VisionNet 708 Package Check - - - - - - - - - - - - - - - - - - - - - - - - - - - - 1 3 Chapter 3. Installation Of VisionNet 708 ▣ Installation VisionNet 708 - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 1 5 ▣ Connect and Disconnect the Internet - - - - - - - - - - - - - - - - - - - 3 0 A D S L Modem Manual Chapter 1. Introduction This chapter provides the brief concept of ADSL, and the external form and specification of VisionNet 708. This chapter covers the following topics: ◈ What is ADSL ◈ VisionNet 708 Layout and LED Description ◈ VisionNet 708 Specification A D S L Modem Manual ◈ What is ADSL ADSL (Asymmetric Digital Subscriber Line) is a technology for transmitting digital information at a high bandwidth on existing phone lines to homes and businesses. Unlike regular dialup phone service, ADSL provides continuously available, "always on" connection. ADSL is asymmetric in that it uses most of the channel to transmit downstream to the user and only a small part to receive information from the user. ADSL simultaneously accommodates analog (voice) information on the same line. ADSL is generally offered at downstream data rates from 512 Kbps to about 8 Mbps, upstream data rates up to 1Mbps. ADSL was specifically designed to exploit the one-way nature of most multimedia communication in which large amounts of information flow toward the user and only a small amount of interactive control information is returned. A D S L Modem Manual ◈ V isionNet 708 Layout and LED Description VisionNet 708 (Front view) A D S L Modem Manual Location Label Status Description ① POWER VisionNet 708 power status It’s On when VisionNet 708 is connected to PC which is working. ② USB USB is awake USB connected PC which is working ③ Tx/Rx Data transmission It’s flashing whenever data is transmitted over VisionNet 708 ④ SYNC ADSL Line initialization and synchronization ⑤ LAN VisionNet 708 LAN status It’s remain on after ADSL line synchronization achieved It’s On when VisionNet 708 is connected to PC LAN which is working. ⑤ PPP PPP Connected status It’s On when VisionNet 708 is connected to PPP which is working. 뒷 면 Location Lable ① LINE ② PHONE Port Function ADSL Line Port Connects telephone Line cable in ADSL line. Telephone Connects the telephone cable in your Connection Port telephone. ③ Console Console Port Console Setting Port. (Option) ④ Ethernet Ethernet Port Connects Ethernet cable from the LAN port in your PC. ⑤ USB USB Port ⑥ DC IN DC IN Port ⑦ Power Power Switch Ethernet Firmware Upgrade (Option) Connects Adaptor VisionNet 708 Ethernet Power On/Off A D S L Modem Manual ◈ V isionNet 708 Modem Specification Specification Size (outfit) Power (V / A) Operating Temperature ADSL Standards compliant Connection Speed Modulation 200mm X 147mm 600mA 18V 5℃ ~ 45℃ ANSI T1.413 Issus 2, ITU G.DMT(G.992.1), ITU G.Lite(G.992.2) Down Stream(Rx) : 8Mbps(Max) , Up Stream(Tx) : 860Kbps (Max ) DMT (Discrete multi-tone) Telephone Line(RJ 11) connector 2 port , Ethernet 1 port, Connector USB Line 1 port, Interface Operating System Ethernet Interface Windows 98/ 98SE/ME/NT 4.0/2000/XP, Macintosh, Linux, UNIX compliant PPP Over ATM (RFC 2364) Protocol Bridged Ethernet Over ATM (RFC 1483) Classical IP Over ATM (RFC 1577) P V C value range VPI: 0~255 , VCI :0~65,535 <> The connection speed of VisionNet 708 may vary depending on your ADSL service, the ADSL line condition, your PC specification and the distance between ADSL modem and Central Office of your local ADSL service provider. A D S L Modem Manual Chapter 2. Before Installation This chapter provides basic safety information before installation. Please read this chapter very carefully before installation. This chapter covers following topics : ◈ Safety Check ◈ The climate condition Check ◈ System Requirements Check ◈ VisionNet 708 Package Check A D S L Modem Manual ◈ Safety Check Before installing and using VisionNet 708, please the following topics must be checked first. ★ Safety check related to the electricity, heat and water. ☞ VisionNet 708 is Ethernet type ADSL modem, so you must connect VisionNet 708 to the Ethernet Port in your PC. ☞ VisionNet 708 must be located in safe space such as near non-grounded extension cable, torn power cable and very close to the power outlet. ☞ VisionNet 708 generates the heat when it is operating. It must not be exposed to heat trap conditions. ☞ It must not be used near water, like a bathtub, kitchen sink or in a wet basement. These environments could damage VisionNet 708 or effect the performance of VisionNet 708. ◈ The climate condition Check For installing VisionNet 708 in safe and being used properly, please be aware of the climate Condition first. VisionNet 708 is connected either Desktop PC or Laptop PC, so check the climate conditions of your PC and follow those instruction first. It’s recommendable that VisionNet 708 is being used in same temperature and humidity. The range of operating VisionNet 708 is ☞ Operating temperature : 5 ~ 45 ℃ ☞ relative humidity : 10 ~ 85 % (non-condensation case) 10 A D S L Modem Manual ◈ System Requirements Check Before installing and using VisionNet 708, please the following topics must be checked first. ★ PC Operating System ☞ Windows 95 ☞ Windows 98 ☞ Windows 98SE ☞ Windows Millennium Edition ☞ Windows 2000 Home Edition & Professional ☞ Windows XP Home Edition & Professional ☞ Macintosh, Linux, UNIX System Specification (Recommended). The performance of VisionNet 708 depends on your system specification, s o following specification is recommended. ◉ OS : Windows 98/98SE ◉ CPU :Pentium III 350MHz or higher ◉ System Memory(RAM): 64MB or higher ◉ LAN Card : Connect Ethernet Port 11 A D S L Modem Manual ◈ V isionNet 708 package Check When opening VisionNet 708 Package, please check the following items in the Package. VisionNet 708 (ADSL Ethernet Modem) User’s manual Direct UTP Cable (RJ-45) Power Adaptor USB Cable (USB-AB) Items : Quantity VisionNet 708 (ADSL Ethernet Modem) : 1 Power Adaptor :1 USB Cable (USB-AB) : 1개 User’s manual :1 Direct UTP Cable (RJ-45) : 1 Telephone Line Cable (RJ-11) :1 Manual and USB Driver CD :1 12 CD Telephone Cable (RJ-11) A D S L Modem Manual Chapter 3. Installation of VisionNet 708 This chapter provides the brief concept of ADSL, and the external form and specification of VisionNet 708. This chapter covers the following topics: ◈ Installation VisionNet 708 ◈ Connect and Disconnect the Internet 13 A D S L Modem Manual ◈ Installation VisionNet 708 1. Start Internet Explorer to view or reset the configuration of the ADSL And type 10.0.0.2 at [Open] and click [OK] button. 2. Enter “a d m i n ” at [User Name], “v i s i o n n e t ” at [Password] as below and click [OK] button to proceed. 14 A D S L Modem Manual ⑴ ADSL Home Page : appearing home page of VisionNet 708 ADSL and Device, DSL, WAN Interfaces, LAN Interfaces, Services Summary 15 A D S L Modem Manual ⑵ DSL : You can find the connecting of ADSL and CRC, HEC ⑶ ATM VCC : Circumstance in ATM VCC Configuration you can set the Value of VPI VCI 16 A D S L Modem Manual ⑷ Bridging : You should use Enable when you do the EoA(Bridge Mode) in Bridge configuration. 17 A D S L Modem Manual ⑸ LAN : You can find and adjust the IP Address and Subnet Mask of LAN in LAN Configuration, the IP Address and Subnet Mask of USB in USB Configuration. 18 A D S L Modem Manual ⑹ NAT : If you use the ADSL in Router, [NAT] should be in condition “Enable” - NAT Configuration ⑺ DNS : In DNS Configuration. You should set the [DNS Sever] when using static 19 A D S L Modem Manual IP(IPoA) (Provided by ISP) ⑻ Commit & Reboot : It is Saving the adjust of ADSL click the [commit] button. 20 A D S L Modem Manual ⑼ PPP : PPP Configuration set the PPPoA & PPPoE of ADSL. After adjusting you should click the [Submit] button, and change the [Commit&Reboot], you should saving the configuration in circumstance of Commit and Reboot 21 A D S L Modem Manual ⑽ User Password Configuration : This page is modify [User Password] of ADSL. You be sure that click [Submit] button, and save that you did in [Commit & Reboot]. 1. Using t h e P P P ( P P P o E & P P P o A ) M o d e 22 A D S L Modem Manual 1-1. Click [WAN] tap. Click “PPP” in upward row of this page, and you can find [ A d d ] button in next page. 23 A D S L Modem Manual 1-2. modifying in [ P P P I n t e r f a c e - A d d ] .page l ATM VC : aal5-1(setting value in ATM VC Provided by ISP) l Protocol : Choice PPPoA or PPPoE l [ U s e D h c p & U s e D N S ] setting [ E n a b l e ] condition. l Insert in the ID & Password from Provided ISP, and Click [Submit] button. l You be sure that save you did in [ C o m m i t & R e b o o t ] . 24
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.3 Linearized : No Modify Date : 2002:07:18 12:11:53-04:00 Create Date : 2002:07:18 12:11:31-04:00 Title : Manual_VisionNet708_.PDF Author : moon Creator : Microsoft Word Producer : Acrobat PDFWriter 4.0 for Windows Page Count : 24EXIF Metadata provided by EXIF.tools