Sharp HRO00080 Cellular Phone User Manual Operation Manual 2

Sharp Corporation Cellular Phone Operation Manual 2

Operation Manual 2

SUPPLEMENTARY MANUAL SH9020CContentsGPS .............................................................................. 2Specifications.............................................................. 2Battery Time........................................................... 2Safety Precautions and Conditions of Use................. 2Declaration of Conformity........................................ 2SAR....................................................................... 2FCC NOTICE........................................................... 3
2GPSGPSFor a detailed explanation on how to operate the GPS functions, refer to the following web site:http://xxxSpecificationsBattery TimeNote•The above values were calculated with the battery installed.•Continuous Talk Time is an average measured with a new, fully charged battery, with stable signals.•Continuous Standby Time is an average measured with a new, fully charged battery, when the phone is closed without calls or operations, in standby with stable signals.•Talk Time/Standby Time may vary by environment, status, settings, etc.Safety Precautions and Conditions of UseDeclaration of ConformityHereby, Sharp Telecommunications of Europe Limited, declares that this SH9020C is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC.A copy of the original declaration of conformity can be found at the following Internet address:http://www.sharp-mobile.comSARRadio wave exposure and Specific Absorption Rate (SAR) informationThis mobile phone model SH9020C has been designed to comply with applicable safety requirements for exposure to radio waves. These requirements are based on scientific guidelines that include safety margins designed to assure the safety of all persons, regardless of age and health.The radio wave exposure guidelines employ a unit of measurement known as the Specific Absorption Rate, or SAR. Tests for SAR are conducted using standardised methods with the phone transmitting at its highest certified power level in all used frequency bands.Continuous Talk Time Up to XXX minutesContinuous Standby Time Up to XXX hours (when the phone is closed)Charging Time (when the phone is turned off)Approximately XXX minutes (when charging with the AC charger)
Safety Precautions and Conditions of Use 3While there may be differences between the SAR levels of various phone models, they are all designed to meet the relevant guidelines for exposure to radio waves.The SAR data conforms to the limit recommended by the International Commission on Non-Ionizing Radiation Protection (ICNIRP), which is 2 W/kg averaged over ten (10) grams of tissue.The highest SAR value for this model phone tested by Sharp for use at the ear is 0.475 W/kg (10g).FCC NOTICEThis device complies with part 15 of the FCC Rules.Operation is subject to the following two conditions:(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.Information to UserThis equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.However, there is no guarantee that interference will not occur in a particular installation; if this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:1. Reorient/relocate the receiving antenna.2. Increase the separation between the equipment and receiver.3. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.4. Consult the dealer or an experienced radio/TV technician for help.CAUTION: Changes or modifications not expressly approved by the manufacturer responsible for compliance could void the user’s authority to operate the equipment.FCC RF Exposure InformationThe tests are performed in positions and locations (e.g., at the ear and worn on the body) as required by the FCC for each model. The highest SAR value for this model phone when tested for use at the ear is 0.141 W/kg and when worn on the body is 0.411 W/kg.Body-worn Operation; This device was tested for typical body-worn operations with the back of the phone kept 1.5 cm from the body. To maintain compliance with FCC RF exposure requirements, use accessories that maintain a 1.5 cm separation distance between the user's body and the back of the phone. The use of belt-clips, holsters and similar accessories should not contain metallic components in its assembly. Use of other accessories may not ensure compliance with FCC RF exposure guidelines.

Navigation menu