Contents
- 1. User Manual 1
- 2. User Manual 2
User Manual 1
FCC Not cé - This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. — Changes or modifications not expressly approved by the manufacturer responsible for compliance could void the user’s authority to operate the equipment. 5In_f_oi_:r_n_a_t_i0n to User This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation; if this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: 1. Reorient/relocate the receiving antenna. 2. Increase the separation between the equipment and receiver. 3. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 4. Consult the dealer or an experienced radio/TV technician for help. I FCC RFExposure Infor Your handset is a radio transmitter and receiver. It is de3|gned and manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by the Federal Communications Commission of the US. Government. The guidelines are based on standards that were developed by independent scientific organizations through periodic and thorough evaluation of scientific studies. The standards include a substantial safety margin designed to assure the safety of all persons, regardless of age and health. The exposure standard for wireless handsets employs a unit of measurement known as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6W/kg. Highest SAR value: Jamel t 599 is. t . fiAttheEaia On the. ~ . .. . SH005 APYHROOO111 0.628W/Kg 0.445W/Kg This device was tested for typical body-wom operations with the back of the handset kept 1.5 cm from the body. To maintain compliance with FCC RF exposure requirements, use accessories that maintain a 1.5 cm separation distance between the user's body and the back of the handset, The use of beltclips, holsters and similar accessories should not contain metallic components in its assembly. The use of accessories that do not satisfy these requirements may not comply with FCC RF exposure requirements, and should be avoided. The FCC has granted an Equipment Authorization for this model handset with all reported SAR levels evaluated as in compliance with the FCC RF emission guidelines. SAR information on this model handset is on file with the FCC and can be found at http:llwww.fcc.gov/oet/fccid under the Display Grant section after searching on the corresponding FCC ID (see table above). Additional information on Specific Absorption Rates (SAR) can be found on the Cellular Telecommunications & Internet Association (CTIA) Website at httpzllwwwphonefactsnet. it El 411
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.5 Linearized : Yes XMP Toolkit : 3.1-702 Modify Date : 2009:11:24 10:43:53+09:00 Create Date : 2009:11:18 13:11:30+09:00 Metadata Date : 2009:11:24 10:43:53+09:00 Format : application/pdf Document ID : uuid:4d064edf-04a8-4efa-a2fe-34b1851b58a9 Instance ID : uuid:101475e1-5a39-4089-a70e-ce32c02d1515 Page Count : 1EXIF Metadata provided by EXIF.tools