Sharp HRO00235 LTE, WCDMA, GSM Smart phone with Bluetooth, WLAN, NFC and GPS User Manual FCC statements

Sharp Corporation LTE, WCDMA, GSM Smart phone with Bluetooth, WLAN, NFC and GPS FCC statements

Contents

FCC statements

Download: Sharp HRO00235 LTE, WCDMA, GSM Smart phone with Bluetooth, WLAN, NFC and GPS User Manual FCC statements
Mirror Download [FCC.gov]Sharp HRO00235 LTE, WCDMA, GSM Smart phone with Bluetooth, WLAN, NFC and GPS User Manual FCC statements
Document ID3023636
Application IDL61beS7HEqFxQ1Ni9z3OCQ==
Document DescriptionFCC statements
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize22.83kB (285422 bits)
Date Submitted2016-06-10 00:00:00
Date Available2016-11-20 00:00:00
Creation Date2016-05-20 11:27:29
Document Lastmod2016-05-26 08:59:17
Document TitleFCC statements

shv35_u.book
23 ページ
2016年5月20日
金曜日
FCC Notice
- This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
- Changes or modifications not expressly approved by the manufacturer
responsible for compliance could void the user's authority to operate the
equipment.
- The device is electronically labeled and the FCC ID can be displayed via the
About phone & the Authentication under the Settings menu.
■ Information to User
This equipment has been tested and found to comply with the limits of a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation; if this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of
the following measures:
1. Reorient/relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
4. Consult the dealer or an experienced radio/TV technician for help and for
additional suggestions.
Warning
The user is cautioned that changes or modifications not expressly approved by
the manufacturer could void the user's authority to operate the equipment.
■ FCC RF Exposure Information
Your handset is a radio transmitter and receiver. It is designed and
manufactured not to exceed the emission limits for exposure to radio frequency
(RF) energy set by the Federal Communications Commission of the U.S.
Government.
The guidelines are based on standards that were developed by independent
scientific organizations through periodic and thorough evaluation of scientific
studies. The standards include a substantial safety margin designed to assure
the safety of all persons, regardless of age and health.
The exposure standard for wireless handsets employs a unit of measurement
known as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC
is 1.6 W/kg.
Highest SAR value:
Model
FCC ID
At the Ear
On the Body
SHV35
APYHRO00235
1.04 W/kg
1.05 W/kg
This device was tested for typical body-worn operations with the back of the
handset kept 1.0 cm from the body. To maintain compliance with FCC RF
exposure requirements, use accessories that maintain a 1.0 cm separation
distance between the user's body and the back of the handset. The use of belt
clips, holsters and similar accessories should not contain metallic components
in its assembly.
The use of accessories that do not satisfy these requirements may not comply
with FCC RF exposure requirements, and should be avoided.
The FCC has granted an Equipment Authorization for this model handset with
all reported SAR levels evaluated as in compliance with the FCC RF emission
guidelines. SAR information on this model handset is on file with the FCC and
can be found at (http://transition.fcc.gov/oet/ea/fccid/)under the Display Grant
section after searching on the corresponding FCC ID (see table above).
Additional information on Specific Absorption Rates (SAR) can be found on the
FCC website at (http://www.fcc.gov/encyclopedia/radio-frequency-safety).
23
shv35_01.fm
[23/23]
午前9時12分

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.7
Linearized                      : No
Create Date                     : 2016:05:20 11:27:29+09:00
Modify Date                     : 2016:05:26 08:59:17+09:00
Has XFA                         : No
Language                        : en
XMP Toolkit                     : Adobe XMP Core 5.4-c005 78.147326, 2012/08/23-13:03:03
Metadata Date                   : 2016:05:26 08:59:17+09:00
Format                          : application/pdf
Document ID                     : uuid:096e6f02-650b-4163-8672-26e4a4aca7b8
Instance ID                     : uuid:845b3d30-5398-4f6d-b63b-1bfefd22d81e
Page Mode                       : UseNone
Page Count                      : 1
EXIF Metadata provided by EXIF.tools
FCC ID Filing: APYHRO00235

Navigation menu