ShenZhen Esky Trade ESKYSZ02 2 Channels Square Transmitter User Manual

Users Manual

FCC REGULATORY STATEMENT

This product may be used for model airplane or surface (boat, car, robot) use, if on

the correct frequency. It is not intended for use in any application other than the

control of model for hobby and recreational purposes.

Exportation precautions:

When this product is exported from the country of manufacture, its use is to be

approved by the laws governing the country of destination which govern devices that

emit radio frequencies. If this product is then re-exported to other countries, it may

be subject to restrictions on such export. Prior approval of the appropriate

government authorities may be required. If you are purchased this product from an

exporter outside your country, and not the authorized distributor in your country,

please contact the seller immediately to determine if such export regulations have

been met.

Use of this product with other than models may be restricted by Export and Trade

Control Regulations, and an application for export approval must be submitted. In

the US, use of 72MHz (aircraft only), 75MHz (ground models only) and 27MHz

(both) frequency bands are strictly regulated by the FCC. This equipment must not

be utilized to operate equipment other that radio controlled models. Similarly, other

frequencies (except 50MHz, for HAM operators) must not be used to operate

models.

FCC regulation against to change the crystal within the transmitter to a different

channel. All such transmitter crystal changes must be performed by a certified radio

technician. Failure to properly tune a system to its new channel may result in

decreased range and may also result in interference to other types of frequency user

on adjacent channels. Doing so also voids the usage authorization.

Manufacturer is not responsible for unauthorized modification, adjustment and

replacement of parts on this product

The Following Statement Applies to the Receiver (For FCC)

This device complies with part 15 of the FCC rules.

Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and

2. This device must accept any interference received, including interference that may

cause undesirable operation.