ShenZhen HongFa Technology CBH508 Bluetooth Earphone User Manual
ShenZhen HongFa Technology Co., Ltd. Bluetooth Earphone Users Manual
Users Manual
STEREO HEADPHONE With Bluetooth® Wireless Technology Owner’s Manual PLEASE READ BEFORE OPERATING THIS EQUIPMENT. Model: CBH508X Size: 148.5(W) x 210(H)mm (A5) s) FCC INFORMATION: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuahtto part 15 ofthe FCC RulesThese limits are designed to provide residential protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation, Ifthis equipment does cause harmful interference to radio ortelevision reception, which can be determined by turning the equipment off and on. the user is encouraged to try to correct the interference by one or more of the following measures: 0 Reorient or relocate the receiVing antenna. 0 Increase the separation between the equipment and receiver. 0 Connectthe equipment into an outlet on the circuit different from thatto which the receiver is connected. 0 Consultthe dealer or an experienced radio/TV technician for help FCC NOTICE: To assure continued compliance. follow the attached installation instructions and use only shielded cables when connecting to other devices Modifications not authorized by themanufacturer may void user’s authority to operate this device. Location of Controls 1. MIC (M|crophone) 4. Indicators 2. LINE IN Jack 5. LI) Button 3. DC IN Jack 6. Toggle Switch Battery Recharge: The unit has a built-in Li-ion rechargeable battery, recharge it before use or when the battery is consumed as follow- 1. Connecl the small plug from the supplied USB Connection Cable to the DC IN Jack (Micro USB Port) on the unit. 2. Connect the other plug to the USB Port on the Computer or any USB Charger having DC 5V output (Computer and USB Charger not included). 3 During charging, the Red Charging lndicator will illuminate. When finished, it will turned off. \\’/ Notes: Your battery will last longer if you follow these simple guidlines for charging and storing it. A. Before tirsttime use, charge the unit approximate 2 hours until the unit is fully charged. B. Recharge and store the device within the temperature range of 5°C~35°C (40°F~95°F). C. Do not overcharge ( longer than 24 hours ). Excessive charging or discharging may shorten the battery's life. D. Battery life naturally shortens slowly over time. E. The rechargeable battery incorporated in this product is not replaceable. Operation: BT(BLUETO0TH}: In first time use or re-pairing to a new BT Device, pairing it as below: 1. Press and hold the “Q ” Button on the unit approximate 1 second to power on the unit. The Blue Indicatorwill illuminate and blink. 2. Power on the external BT Device and enter to BT searching mode. Start pairing as the on screen instructions on the external BT Device. After paired, the Blue Indicator will stop blinking. 3, Plays the music in the paired BT Device as usual. Notes: 0 When the external BT Device searched the unit, our model number"CBH508X" will appear on the display of external BT Device. . Pairing code “0000" or"1234” may need to enter. Normal operation after paired: 1. Press and hold the “(b " Button on the unit approximate 1 second to power on the unit. The Blue Indicator will illuminate and blink. 2. Wait a few seconds until the unit auto paired to the external BT Device. The Blue Indicator will stop blinking. 3. Plays the music in the connected BT Device as usual, rm \‘ / 4. During playback: 0 Press the Toggle Switch to pause; press again to resume normal playback. 0 Slide the Toggle Switch to front (or rear) and hold to adjust the volume level as desire. ' Slide the Toggle Switch to front (or rear) then release to skip tracks. Repeat the same procedures until the desired tracks was selected and play. 5. Ifthe unit is paired to a cell phone. When a call is incoming, press the Toggle Switch to hook off then speakerto the MIC (Microphonelto answerthe phone. When finished, press the Toggle Switch to hook on then the unit will auto resume to playback. 6. To power off, press and hold the “(U " Button approximate 3 seconds until the Red Indicator is illuminate and blink then release the button. LINE IN: Listen music from the external Audio Player as tollows: 1. Connect one end ofthe supplied Audio Connection Cable to the LINE IN Jack on the unit. 2. Connectthe other end to the Phones Jack; Line OutJack orAUX OutJack on the external Audio Player. 3. Press and hold the “0 " Button on the unit approximate 1 second to power on the unit. The Blue IndicatorWill illuminate. 4. Plays the music on the externalAudio Player as usual. 5 During playback, slide the Toggle Switch to front (or rear) and hold to adjust the volume level as desire. (Make sure the volume level ofthe connected externalAudio Player is set to high. Otherwise, sounds from this unitwill weak.) 6. To power off, press and hold the “ 0)” Button approximate 3 seconds until the Red Indicator is illuminate and blinkthen release the button. IMPORTANT: Ifthe Audio Connection Cable was inserted into the LINE IN Jack, the BT (Bluetooth) function will be auto turned off. Unplug the connection cable from the LINE IN Jack before use BT. m, Troubleshooting: Can't be power on The built-in battery was consumed. Recharge the battery. No sound Volume was set to mininum level. Slide the Toggle SWitch to front (or rear) and hold to adjustthe volume level as desire. Sound distortion Volume level too high. Slide the Toggle SWitch to front gor rear and hold to adJuvs the vo ume level as desne. BT not functioning The External BT Device had not paired to the unit. Paired the External BT Devicetothe unit as previous procedures. The External BT Device too farfrom the unit. Place the External BT Device close to the unit. Specifi ations: Power Source:... lmpedance of Earpiecez... Audio Power BT Version BT Effective Range:. Accessories: 1 x User‘s Manual 1 x USB Connection Cable (For charging only) 1 x Audio Connection Cable with 3.5mm Stereo Plugs ............ Built-in DC 3 3.7 V; 400 mAH (1 ABWH) rechargeable Li-ion battery, recharge by DC : 5V through Micro USB Port ...32 ohm, 25 mW x 2 22 mW per channel SPECIFICATIONS AND ACCESSORIES ARE SUBJECT TO CHANGE WITHOUT NOTICE ........... V4.l+EDR .32 Feet in open area Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with part 15 ofthe FCC Rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference, and (2) this device must acceptany interference received, including interference that may cause undesired operation. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-Iocated or operating in coniunction With any other antenna or transmitter. LIMITED WARRAN Craig warrants this product to be free from manufacturing defects in material and workmanship under normal use for a period of 90 days from date of purchase. If service is required, please return the product to the store where it was purchased for exchange; or, pack the unit in the original packing material with all accessories if applicable, a copy of your sales receipt and a Cashier's check or Money Order for $3.00 (to cover shipping and handling costs) payable to Craig Electronics lnc. For consumers in Canada, please make sure that the cashier check or money order is redeemable through a U.S. bank. Ship your product freight pre-paid. Your unit will be repaired, replaced or if the unit can not be repaired or replaced, a refund will be forwarded to you within fourweeks of receipt of your unit. Please ship your unit to: Craig Electronics Inc. 1160 NW 163 Drive Miami, Fl 33169 This warranty is void if the product has been: a) Used in a commercial application or rental. b) Damaged through misuse, negligence, or abuse. c) Modified or repaired by anyone other than an authorized Craig serVice center. d) Damaged because it is improperly connected to any other equipment. Note: This warranty does not cover: a) Ordinary adyustments as outlined in the Owners Manual which can be performed by the customer. b) Damage to equipment not properly connected to the product. c) Any cost incurred in shipping the product for repair. d) Damage to the product not used in the USA. This warranty is not transferable and only applies to the original purchase. Any implied warranties, including the warranty of merchantability, are limited in duration to the period of this expressed warranty and no warranty whether expressed or implied shall apply to the product thereafter. Under no circumstance shall Craig be liable for any loss or consequential damage arising out of the use of this product. This warranty gives specific legal rights. However, you may have other rights which may vary from state to state. Some states do not allow limitations on implied warranties or exclusion of consequential damage. Therefore, these restrictions may not apply to you. To Obtain SerVice on your Product email:service@craigelectronicscom Printed in China CBH508X7WC7EDHV17AOUS m,
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.6 Linearized : Yes Encryption : Standard V4.4 (128-bit) User Access : Print, Extract, Print high-res Author : Administrator Create Date : D:20160826100026Z Modify Date : 0000:01:01 00:00:00 XMP Toolkit : Adobe XMP Core 5.2-c001 63.139439, 2010/09/27-13:37:26 Format : application/pdf Creator : Administrator Title : CDR说明书(添加了文字)谢工用 Creation Date--Text : Mod Date--Text : Producer : Corel PDF Engine Version 14.0.0.653 Creator Tool : CorelDRAW Metadata Date : 2016:09:07 08:59:17-07:00 Document ID : uuid:7c809f96-bf6d-47a4-9344-ea6b63116564 Instance ID : uuid:f60b4740-3b84-4ac0-89d3-dba6e093794e Page Count : 8EXIF Metadata provided by EXIF.tools