ShenZhen KaiXingHui Technology RC100 Wireless Charger User Manual 2
ShenZhen KaiXingHui Technology Co.,Ltd. Wireless Charger 2
User manual
Product Introduction
Wireless charger RC100 is an intelligent product. There is no need to plug
your phone‘s charger port in or out. Just simply place your devices on RC100
pad and you are free to enjoy your wireless and limitless charging experience
now!
Product Outline
PowerInput
Anti-slipperyRubberband
Applicable Devices
Instructions
2. Connecting power with USB port, the indicator
will flash for seconds when power is on.
Package Contents
Wireless Charger(RC100)
USB cable
Product Specification
Input: 5V,1500mA
Output: 5V,1000mA
Charging Distance: ≤10mm
Charging Efficiency: ≥73%
Size: 89.6mmX8.4mm
Attention:
1.Keep the charger away from water and other liquid.
2.Please make sure the power is cut off before you start to clean
the charger.
3.Use the charger under temperature only between 0-45°C.
LEDindicatorarea
Wireless Charger
User Manual
User Manual
RC100
3.① Locate your phone on charging pad and make
sure it at sweet spot for effective charging.
②When the phone is charged successfully,
the LED indicator will flash for 30 seconds
then off to keep the whole charging process
sleep-friendly.
4
56
iPhone X/iPhone 8/iPhone 8 plus, SamsungGalaxyNote8/Note5,
S8/S8+/S7/S7 edge/S6/S6 edge/S6 edge+,GoogleNexus 4/5/6, LG V30
and more.
1. For best charging on sweet spot, please use 2A adapter (NOT INCLUDED) or
Original adapter and cables.
1
23
FCC I D: 2A O S URC100
FCC StatementFCC Statement
The device complies with part 15 and 18 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including interference
that may cause undesired operation.
Changes or modifications not explicitly approved by the party responsible for compliance
could void the user's authority to operate this equipment.
Note: this equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following
measures:
--- Reorient or relocate the receiving antenna.
--- Increase the separation between the equipment and receiver.
--- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
--- Consult the dealer or an experienced radio/TV technician for help.
The equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This device has been tested for human exposure limits and found compliant
at a minimum distance of 10cm during operation.Thus during the operation of device
a distance of 10cm must be respected in every direction.