ShenZhen Scimagic Development Technology SMG-002 Remote Control User Manual SMG 822 Specification

ShenZhen Scimagic Development Technology Co., Limited Remote Control SMG 822 Specification

User Manual

SMG-002 Specification1) IC chip: Learning code 15272) Working voltage: 12V3) Working current: 8~10mA4) Frequency: 433.92mhz5) Working power: ≤10MW6) Working distance: 10-100meters(spacious)7) Static current: 08) Battery voltage: 27 A9) Modulation: ASK10)Temperature Range: - 40 ℃to + 85 ℃As long as your original remote control is the same frequency and same chip as ourremote control. it will working.Before working, it need programming with your remote control receiver.the way ofprogramming depend on your original receiver. Usually your receiver have themanual show you how to make programming.FCC STATEMENT :This device complies with Part 15 of the FCC Rules. Operation is subject to thefollowing two conditions:(1) This device may not cause harmful interference, and (2) This device must acceptany interference received, including interference that may cause undesired operation.Warning: Changes or modifications not expressly approved by the party responsiblefor compliance could void the user's authority to operate the equipment.NOTE: This equipment has been tested and found to comply with the limits for aClass B digital device, pursuant to Part 15 of the FCC Rules. These limits aredesigned to provide reasonable protection against harmful interference in a residentialinstallation. This equipment generates uses and can radiate radio frequency energyand, if not installed and used in accordance with the instructions, may cause harmfulinterference to radio communications. However, there is no guarantee thatinterference will not occur in a particular installation. If this equipment does causeharmful interference to radio or television reception, which can be determined byturning the equipment off and on, the user is encouraged to try to correct theinterference by one or more of the following measures:Reorient or relocate the receiving antenna.Increase the separation between the equipment and receiver.Connect the equipment into an outlet on a circuit different from that to which thereceiver is connected.Consult the dealer or an experienced radio/TV technician for help.

Navigation menu