| Download: |  |
| Mirror Download [FCC.gov] | |
| Document ID | 3811891 |
| Application ID | Vk/ofRhkOS0+TA4nghhdEQ== |
| Document Description | User Manual |
| Short Term Confidential | No |
| Permanent Confidential | No |
| Supercede | No |
| Document Type | User Manual |
| Display Format | Adobe Acrobat PDF - pdf |
| Filesize | 129.26kB (1615740 bits) |
| Date Submitted | 2018-04-11 00:00:00 |
| Date Available | 2018-04-11 00:00:00 |
| Creation Date | 2018-04-09 17:51:27 |
| Producing Software | Adobe Acrobat Pro 11.0.0 Paper Capture Plug-in |
| Document Lastmod | 2018-04-09 18:12:56 |
| Document Title | User Manual |
| Document Creator | Adobe Acrobat 11.0 |
For user'
5 safet弘 please
read this manual before using the headset.
The following matters should be paid attention to when
using headset:
Please avoid long 四term use of high volume mode, because it willlead
to hearing loss caused by noise.
If you are in bad condition of potential danger, please stop using
headset, in order to ensure safety.
Users should reasonably control the volume and time when listening
to the headset.
The volume should not be too high ,otherwise you can' t hear the
voice around. If volume is too high that may appear tinnitus, please
lower down the volume.
Don't listen to the music while driving.
Use dry soft cloth to clean the headset! Should avoid the headset into
the water, that will cause headset damage.
If you feel obvious discomfort, stimulation , or other adverse reaction
when using the headset, stop using it immediately .
The headset should not be stored or used in temperature below
15 c(5 F) or higher than 55 c(131 。町， otherwise will reduce the battery
life.
Charging and Battery:
Before charge this headset with charging cable, please check whether
the charge cable is origina l.
Warning:
Please charge the headsets with original charging cable, it may
damage the battery or the headset if you are using improper
charging cable.This headset has built-in rechargeable battery, so do
not attempt to remove the battery from the headset to avoid
damaging it.
1. Before charging , it' s better to turn off the headset.
2. Insert the USB charging cable to earpiece jack, the other end of the
USB port into the USB charger or any other devices to start charging.
The red light flashing means it is charging.
ONjOFF
Volume + j
Next
Microphone
LED Indicator
.四 .
Volume - j
Previous
Multifunctional
Button ( MFB )
3. The headset needs about 4 hours for fully charging , the red light
goes off when fully charged.
I Package content:
• Headset 1pcs
• Earbud 2pcs
• USB charging cable 1pcs
• User Manual 1pcs
ON/OFF
1. When the headsets is off, push the power button to "ON" the
blue light flashes one time; the headset prompts "power on" with
vibration.
2. Push the power button to "0FF" , the headset prompts "power
off" and the red light flashes one time.
nr-o•,•
•
•
&矿也
←
问H
r川 '
蹄
阳川
ihyl
lt川U
I &Tk
飞、/
世
FF嗣 hmH
E画Irbudll阳t崎d
&u~on (的
J dH
Mb
mMJ
问坦
- 配'
白翩
咱
P-M
Bluetooth connection steps:
1. Please keep your headset and mobile phone as close as you can ,
within 1 meter.
2. Push the power button to "0N" , LED flashes blue one time and
the headset prompts power on
In 5 seconds the headset enters
LED flashes red and blue
pairing mode and it prompts Pairing
alternately.
/l
/l
/l
3.Turn on
SX-888.
/l
Bluetooth
/l
•
/l.
in setting(your device) and find headset name
4. Click SX-888 Bluetooth headset gets connected with your mobile
phone automatically. Some may require pass code which is 0000.
Pairing the headset with 2 mobile phones
1. After successfully pairing with the first mobile phone, turn off the
Bluetooth function on the mobile phone. Push the power button to
OFF" to turn off the headset
/l
2. Same procedure to get the 2nd mobile phone paired with the
Bluetooth headset.
3. Turn on the Bluetooth function of the 1st mobile phone; choose
飞X-888" to finish the pairing status with the 2nd mobile phones.
Note:
1 、 With
you perviously paired device' s Bluetooth turned on and in
range , turn on SX-888. The headset will automatically reconnect to
the same Bluetooth device that connected last time. If you have a
previously paired device that does not auto-reconnect navigate to
the Bluetooth settings menu on your device , turn on the Bluetooth
feature , and select SX-888" from your list of paired Bluetooth
devices.
/l
2 、 Pairing
time exceeds 3 minutes, SX-888 will automatically shut
down; in 3 minutes back to the effective distance can automatically
return to the last connected device .
3 、 If
connected with two moblie phones, only one mobile phone
supports wireless music and you can start conversation for both
mobile phones. Battery check up through iPhone.
Answer & End call / Incoming call vibration remind
Answer phone call :
When there is an incoming call , the headset will promp t: Incoming
call" with vibration. Phone number"134......... "will be broadcasted.
Click MFB to answer or just operate on your mobile phone.
End Call :
Press the MFB button to hang up calls, or directly hang up on your
mobile phone, it will prompt" Call ended".
Reject call :
When there is an incoming call , headphone will broadcast the phone
number with vibration. Double click the IIMFB" to reject, or just
reject it on your mobile phone.
Last number redial :
Double click 11M FB" button.
Call Transfer :
Switch toggle the volume 11
between phone and headset.
"two times to transfer incoming call
Voice Dial :
Switch toggle
two times and say IIcall XXX" , mobile phone will
automatically dial this number (the number 沁()( should be saved in the
mobile phone). Some mobile phones may not support this function.
11
11
Hang up the phone call and answer other incoming call
If there is an incoming call when you are answering a phone call ,
double click the MFB and you can hang up the phone call and
answer the incoming cal l.
EQ Shift:
Switch toggle the volume
"two times when playing music to
have different sound effect (high bass boost, normal , low pitch
boost). Default setting is high bass boost. Choose your favorite
sound effect base on your habit and music style.
11
Chinese/English Shift :
Long press 11M FB" and switch toggle
Chinese and English.
11
"to change between
Power prompt :
Each time turning on SX-888, it will report headset battery power
remaining such as battery full" ，、attery level high" ，、attery
level medium" ，、attery levellow" "recharge headset" .
J/
Play/Pause
During music playing , Short press
again MFB back to play .
During music playing , switch toggle
songs.
J/
MFB" to pause music, and click
11
+/
"one times to change
During the call or listening to music, user can long switch toggle
or
button to adjust the volume.
11
11
11
11
Mobile phone anti-Iost indicator
When the headphone connected with smart phone, if the distance
between device and headphone out of 10 m , headset will prompt
"Beyond the range of connections" . If coming back to the working
distance within 3 min or after, the headset will reconnect Automatically
with smart phone. If not coming back to the working distance in 10
min , headphone will be power off, please switch the button to the
OFF then switch to ON ,headset will reconnect with smart phone.
Restore Factory Settings
Turn off the headset and in charge state, long press "MFB" button for
three seconds, the blue light flashes three times, it will back to
Factory setti ng.
Technicallndex
•
•
•
•
•
•
•
•
•
•
Correspond With : V4.1
Support : HSP. HFP. A2DP. AVRCP
Transmitting Power: Class 2
Working Distance :三 10m
Frequency Range : 2.402GHz-2.480GHz
Charging time :三 3.5 Hours
Standby Time :三 180 Hours
Talk Time :兰 12 Hours
Music Time :注 10 Hours
USB power supply :三 5Vj1A
Wa rn i ng
The power adapter for charging the product is 5V/lA , if
use high voltage power adapter for charging the machine,
there is the risk of burning machine!
Tips:
Wrong way of setting back the wire
Press the Earbud Retract Button
directly. In this way, the earbuds
will hit the headset aggressively.
...•••
•••
•••
Correct way of setting back the wire
In order to prolong the working life of the headset, please setback the wire slowly,
and follow the steps shown below.
Press the Earbud
Hook the wire
by your hands.
Let go of your ____...
curved fingers. ........
.........
.........
@争. Rm ω u川
t忱t 阳
let the Earbuds
setback i n you r
hands.
Press the Earbud
• • Ret r act But忱t 阳
allow the 陀
res
纣t of
the earbuds to
retract inside
headset.•
FCC Statemen t
This device complies w ith part 15 of the FCC Rules. Operation is subject to the following
two conditi ons:
(1) This dev ice may not cause harmful interference, and (2) this device must accept any
interference received , in cluding interference that may ca use undesired operati on.
Any Changes or modifications not expressly approved by the party responsibl e for
compliance cOllld void the l lser's allthority 10 operate the eqllipment
Note: Th is equipment has bee门 tested and found 10 ∞mply vtith the limlts lor a Class B
digital device , pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against hð l1Tl ful interferenιe in a residential installation. This
自(jlll[lm阳11 (J白mm'llf!s IIS自S Fl nÒ r.il n rFlc1 IFll f! mc1 lo !f f!C(l JAnC:y f!n白íOY p, nc1 1I nol tnS11l1l削
and u!;cc in accord ancc with thc instrllctions , may CaUGC harlllflll intorfcrcnco to mdio
叫 II I IIUII I叫川岛 Howev明 ， tl1 el e i:; IIU yu制II lee 11 削 ilJ lel reJ e lJL:e will Jlul 0(;ιlIJ 111(:J
particular installation. li thls eqUlpll1 ent does cause hall1)ful interference to radio or
television reception. eqllipll1 ent generates, uses a nd can radiate radlo freqllency energy
Fl nò. il not inSTFlIlp. ò AnÒ IISf!c1 in Flr.r.oròflnr.p. wilh th f! instrll rtion旦. Il1Fly C'.FI IISf! Imrml l1 l
i ntcrfcrcn∞ to radio commllnicatioll~. Howcvor, thcrc is no gllarantcc that intcrfcrcncc
willllul UC:(;UI ill él ~élI lil;uléll i m;[él ll
Source Exif Data:
File Type : PDF
File Type Extension : pdf
MIME Type : application/pdf
PDF Version : 1.6
Linearized : No
Create Date : 2018:04:09 17:51:27+08:00
Creator : Adobe Acrobat 11.0
Modify Date : 2018:04:09 18:12:56+08:00
XMP Toolkit : Adobe XMP Core 5.4-c005 78.147326, 2012/08/23-13:03:03
Metadata Date : 2018:04:09 18:12:56+08:00
Creator Tool : Adobe Acrobat 11.0
Format : application/pdf
Document ID : uuid:5d1d6b2a-6e16-4915-a50c-b209c88d52b7
Instance ID : uuid:b143193b-eff0-4083-8f73-7473e8d4d9a1
Producer : Adobe Acrobat Pro 11.0.0 Paper Capture Plug-in
Page Count : 10
EXIF Metadata provided by EXIF.tools