Signal Communications CTE-991209 Audio Monitoring System User Manual

Download:
Mirror Download [FCC.gov]
Document ID	87971
Application ID	Fz0WmTerdefnphqfLhIHbA==
Document Description	User Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	115.01kB (1437655 bits)
Date Submitted	2000-02-24 00:00:00
Date Available	2000-03-13 00:00:00
Creation Date	2000-01-27 16:57:42
Producing Software	Acrobat 3.0 Scan Plug-in
Document Lastmod	2000-01-27 16:58:47
Document Title	User Manual
Document Creator	Acrobat 3.0 Scan Plug-in

CAM ERIO Te/eEAR
User Guide
Notice:
Signal Communications Limited reserves the right to make improvements to the
product described in this manual at any time and without notice.
This manual is copyrighted All right are reserved. This manual may not be copied,
reproduced or translated in whole or part consent form Signal Communications Limited.
Third party trademarks are the property of their respective holders,
Copyright © 1999 Signal Communications Limited.
All rights reserved.
Version 1.0
FCC Statement on Class B
W4 Kfllfifi
Changes or modifications to this unit not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
MZIE
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur In a particular installation. if this
equipment does cause harmful interference to radio or television reception, which can be determine
by turning the equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
0 Reon'ent or relocate the receiving antenna.
0 Increase the separation between the equipment and receiver.
0 Connect the equipment into an outlet on a circuit different from that to which the receiver is
needed.
O Consult the dealer or an experienced radio/TV technician for help.
Shielded cahies must be used with this unit to ensure compliance with the Class B FCC Ilmits.
Table of Contents
INTRODUCTION
SYSTEM REQUIREMENTS
0 What You Need
0 (AMERIO Te/sEAR Transmitter
o RS-232 connection definition
SECTION 3
INSTALLING CAMERIO Te/eEAR
0 Hardware Installation
0 Software Installation
CAMERIO Ta/sEAR Reception Softwaxe
Main Screen
Connect to the Transmission Unit
Disconnect from the Transmission Unit
Selecting Audio Channels
Mute
SECTION 5
SPECIFICATION
0 Physical
- Electrical
0 Others
(AMERIO Te/eEAR User Guide Page 1
SECTION 1
INTRODUCTlON
CAMERIO TeleEAR is an audio monitoring system which consists of a
’ transmission unit and a reception software.
CAMERIO Te/eEAR transmission unit can accept up to 4 audio input signals. It
compresses the signals and transmits the compressed digital voice data through a
RS—232 serial port to the reception side.
CAMERIO Te/eEAR reception software runs on a PC. It receives the compressed
digital voice data from the transmission unit and decompresses it to recover the
voice and output to the PC loudspeaker.
Channel 1
Microphone
i Audio Line In Inputs
Channel 2
speaker
speaker
Channel 3
Channel 4
IBM or Compatible PC
CAMERIO TeIeEAR
Figure l: The configuration of the CAMERIO TeIeEAR audio monitoring system
Introduction
w Tim‘s,
(AMERIO Te/eEAR User Gulde Page 1
SECTION 2
SYSTEM REQUIREMENT
What You Need
‘ To install and operate the CAMERIO Te/eEAR transmission unit and reception
sofiware, the following items are required:
0 CAMERIO Te/sEAR Transmission unit
- Supports up to 4 audio channels.
0 Audio sources with RCA jack or condenser microphone.
o RSZ32 Cable
- Shielded, DTE (Data Terminal Equipment) — DTE RS232 cable.
0 IBM PC/AT compatible computer with
- Pentium 133MHz processor or above
- 8MB RAM or above
- True color display card
- Serial Port
- Sound Card
- Windows 95, 98 or NT operating system
0 Speakers
- Microphone jack PC speaker
- RCA jack speaker for transmission unit
0 CAMERIO Te/eEAR Reception Software
- Installed in the PC.
System Requlrement
(AMERIO Te/eEAR User Gmde Page 3
CAMERIO Te/eEAR Transmission Unit
Audio Input Channels:
- Channel 1 is multiplexed by a microphone or Line In audio source.
- Channel 2—4 is Line In audio sources.
Audio Output Channels:
- Line Out audio channel.
Aux In and Aux OutPorts:
1 DB-9 male connector and l DB-9 female connector for connecting to RSZ32 cables.
Power Jack:
A 2.1mm DC power jack for power supply.
RSZ32 connection diagram
TeleEAR lac-(DRES)
1 RXD Km 3
3 TXD TXD 2
1 CD >< CD 8
4 DTR DTR 20
5 (TN n —— ONT) 7
7 RT S X BIS 4
X ("TS (ITS 5
System Requirement
(AMERIO Te/eEAR User Guide Page 5
SECTION 3
INSTALLING CAMERIO Te/eEAR
Hardware Installation
Setup Procedure:
I.
2.
Turn off the CAMERIO Te/eEAR Transmission Unit, PC and all audio sources.
Plug the audio sources to the appropriate channels. It is preferable to plug a
microphone in Channel 1.
Connect the Aux In Port of the Transmission Unit to the COM Port of the PC by a
R8232 cable. Tighten the screws to ensure proper connection.
Plug the round end of the AC adaptor into the socket marked POWER on the
Transmission Unit, it can suppon 9V — 12V supply voltage.
Turn on the Transmission Unit, the audio sources and the PC.
Software Installation
Insert the floppy disk into the floppy drive and execute SETUP.EXE. To complete the
setup procedure, please follow the on screen instructions. Afier the installation, restart
the PC.
System Requirement
(AMERIO Te/eEAR User Guide
System Requirement
(AMERIO Te/eEAR User Guide Page 5
SECTION 4
CAMERIO TeIeEAR RECEPTION
SOFTWARE
To start the reception software, select TeleEar from Programs in the Start menu. The
main screen of the reception software is shown in Fig. 4.1.
= TeieEA anephon Sofia
4.1. Main Screen of TeleEAR Reception Software
Connect to the Transmission Unit
To connect the Transmission Unit, make sure the Transmission Unit is on, then click the
Connect button or select Connect from the pull down menu. A menu shown in Fig. 4.2
will pop up to let you select the COM Port erg. Direct to COM 1, please check what
COM Port of your PC you are using to connect to the Transmission Unit. Please make
sure you have chosen the correct baud rate (must be 38400bps) from Properties.
, Cnnliol Port
Fig. 4.2 Control Port
CAMERIO Reception Schware
(AMhRIO TclcEAR User Guide Page ii
Afier successful connection, a statement ‘Connected’ will be displayed on the status bar.
If the channel is active, you can hear the sound from the audio source. The screen will
changed and shown in Fig. 4.3.
l ieEAH Reception sonata-e
Fig 4.3. Connected to the Transmission Unit
Disconnect from the Transmission Unit
To disconnect the Transmission Unit, click the Disconnect button or select Disconnect
from the pull down menu A statement ‘Disconnecting. . .’ will be displayed on the status
bar.
Select Audio Channels
There are two modes for selection of audio channels, automatic and manual, You can
select the mode from channel switching
Automatic Mode:
The audio channels will be auto switched sequentially, the switching time can be
specified from 5 seconds to 60 seconds
Manual Mode:
You need to specify the audio channels to listen by checking the appropriate box
against the channel, or by selecting it from the pull down menu.
Mute
While listening to the sound, you can mute it simply by clicking the Mute button or Mute
from the pull down manual,
CAMERIO Reception Software
(AMERIO Te/eEAR User Guide
SECTION 5
SPECIFICATION
Physical
Dimension 25mm(L) x 183mm(W) x 43mm(H)
Weight Likg (AC adaptor not included)
a Casing Metal
Electrical
0 AC Adaptor Input: 110V AC GOHZ, Output: 9V DC 300mA
0 Transmission Unit Input: 9V —12VD DC 300mA
Others
0 4 audio channels, channel 1 is multiplexed by a microphone and a Line In audio
source. Channel 2 to Channel 4 are Line In audio sources
Selectable audio sources
1 Line Out audio output, local feedback form audio inputs
EIA-232D interface
Data format: none parity, 8 data bits and 1 stop bit
Speclfieation

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.2
Linearized                      : No
Modify Date                     : 2000:01:27 16:58:47
Creator                         : Acrobat 3.0 Scan Plug-in
Producer                        : Acrobat 3.0 Scan Plug-in
Create Date                     : 2000:01:27 16:57:42
Page Count                      : 12

EXIF Metadata provided by EXIF.tools