Signal Technology RTCB2400 RTCB2400 Radio Module User Manual
Signal Technology Corporation RTCB2400 Radio Module
user manual
January 23, 2008
Crane WMS
VantedgePoint
Safety and Product Information
Remote Telemetry Controller - Battery
Operated
Information in this document, including URL and internet website references, is subject to change without notice. Complying with all applicable
copyright laws is the responsibility of the user. Without limiting the rights under copyright, no part of this document may be reproduced, stored or
introduced into a retrieval system, or transmitted in any form or by any means (electronic, mechanical, photocopying, recording or otherwise), or for any
purpose, without the express written permission of Crane WMS. Crane WMS may have patents, patent applications, trademarks, copyrights or other
intellectual property rights covering subject matter in this document. Except as expressly provided in any written license agreement from Crane WMS,
the furnishing of this document does not give you any license to these patents, trademarks, copyrights, or other intellectual property.
©2007 Crane WMS. All right reserved.
Crane WMS & VantedgePoint are registered trademarks of Signal Technology in the United States and other countries.
January 23, 2008
Regulatory Information
This device complies with Part 15 of the FCC Rules subject to the following two conditions; (1) This
device may not cause harmful interference and (2) This device must accept any interference
received, including interference that may cause undesired operation.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. The antennas should be installed and operated with minimum distance 20cm from all
persons and must not be co-located or operating in conjunction with any other antenna or
transmitter. End-users and installers must be provided with antenna installation instructions and
transmitter operating conditions for satisfying RF exposure compliance.
FCC Notice
Changes or modifications to this device not expressly approved by the manufacturer could void the
user’s authority to operate the equipment. For more details on legal combinations of power levels
and antennas, contact Crane WMS.
Limited Warranty
Wireless Remote Telemetry Controller - Battery Operated
The seller warrants to the end user (Customer) that this hardware product will be free from defects
in workmanship and materials, under normal use and service, for 1 year from the date of purchase
from the seller or its authorized reseller. The seller’s sole obligation under this express warranty
shall be at the seller’s option and expense to repair the defective product or part, or to deliver to the
Customer an equivalent product or part to replace the defective item. If neither of the two foregoing
options is reasonably available, the seller may in its sole discretion, refund to the Customer the
purchase price paid for the defective product. All products that are replaced will become the
property of the seller. Replacement products may be new or reconditioned.
Wireless Remote Telemetry Controller Software
The seller makes no warranty or representation that its software will meet the Customer’s
requirements or work in combination with any hardware or software application provided by third
parties, that the operation of the software will be uninterrupted or error free, or that all defects in the
software will be corrected.
January 23, 2008
Safety Information
1. Do not use this apparatus near water.
2. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus
(including amplifiers) that produce heat.
3. Do not defeat the safety purpose of the polarized or grounding type plug. A polarized plug has
two blades with one wider than the other. A grounding-type plug has two blades and a third
grounding prong. The wide blade or the third prong is provided for your safety. If the provided plug
does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.
4. Protect the power cord from being walked on or pinched particularly at plugs, convenience
receptacles, and the point where they exit from the apparatus.
5. Only use attachments/accessories specified by the manufacturer.
6. Refer all servicing to qualified service personnel. Servicing is required when the unit has been
damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or
objects have fallen into the unit, the unit has been exposed to rain or moisture, does not operate
normally, or has been dropped.
7. No open flame sources, such as lighted candles, should be placed on the apparatus.
8. The unit shall not be exposed to dripping or splashing. No objects filled with liquids, shall be
placed on the unit.
9. The unit is for indoor use only. Operation outside requires the use of an appropriate sealed
enclosure.
Warnings
Follow instructions to avoid interference problems. Do not operate your device in any location
where posted notices prohibit its use. These locations include any facility that may be using
equipment that is sensitive to external RF energy.
If you have a pacemaker, consult your physician before installing or operating this device.
Some digital devices may interfere with some hearing aids. In the event of such interference, you
may want to consult your hearing aid manufacturer or physician to discuss alternatives.
Device Disposal
The Remote Telemetry Controller device should not be placed in household waste bins. Please
check local regulations for information on the disposal of electronic products in your area.
January 23, 2008
Contact Information
Visit us online: www.cranewms.com
Call our office: (972) 964-5178
Fax our office: (972) 964-5968
Email us: sales@cranewms.com
support@cranewms.com