Signal Technology RTV2400 RTV2400 Radio Module User Manual RTC Safety and Product Information

Signal Technology Corporation RTV2400 Radio Module RTC Safety and Product Information

User Manual

Crane WMS VantedgePoint Safety and Product Information Remote Telemetry Vending Unit Information in this document, including URL and internet website references, is subject to change without notice. Complying with all applicable copyright laws is the responsibility of the user. Without limiting the rights under copyright, no part of this document may be reproduced, stored or introduced into a retrieval system, or transmitted in any form or by any means (electronic, mechanical, photocopying, recording or otherwise), or for any purpose, without the express written permission of Crane WMS. Crane WMS may have patents, patent applications, trademarks, copyrights or other intellectual property rights covering subject matter in this document. Except as expressly provided in any written license agreement from Crane WMS, the furnishing of this document does not give you any license to these patents, trademarks, copyrights, or other intellectual property. ©2007 Crane WMS. All right reserved. Crane WMS & VantedgePoint are registered trademarks of Signal Technology in the United States and other countries. January 23, 2008
Regulatory Information This device complies with Part 15 of the FCC Rules subject to the following two conditions; (1) This device may not cause harmful interference and (2) This device must accept any interference received, including interference that may cause undesired operation. FCC Radiation Exposure Statement This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. The antennas should be installed and operated with minimum distance 20cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter. End-users and installers must be provided with antenna installation instructions and transmitter operating conditions for satisfying RF exposure compliance. Caution FCC approved RF operation of this equipment is permitted only with the approved antennas, cable and connectors provided with this product. Use of unauthorized antennas, modifications or attachments could damage the device and/or may result in your device not complying with local regulatory requirements in your country. Antenna Installation FCC regulates that this product may be used with a 5.5 dBi (or less) Omni directional antenna. User should only use antennas supplied by Crane WMS. FCC Notice Changes or modifications to this device not expressly approved by the manufacturer could void the user’s authority to operate the equipment. For more details on legal combinations of power levels and antennas, contact Crane WMS. Limited Warranty Wireless Remote Telemetry Vending Unit The seller warrants to the end user (Customer) that this hardware product will be free from defects in workmanship and materials, under normal use and service, for 1 year from the date of purchase from the seller or its authorized reseller. The seller’s sole obligation under this express warranty shall be at the seller’s option and expense to repair the defective product or part, or to deliver to the Customer an equivalent product or part to replace the defective item. If neither of the two foregoing options is reasonably available, the seller may in its sole discretion, refund to the Customer the purchase price paid for the defective product. All products that are replaced will become the property of the seller. Replacement products may be new or reconditioned. Wireless Remote Telemetry Controller Software The seller makes no warranty or representation that its software will meet the Customer’s requirements or work in combination with any hardware or software application provided by third parties, that the operation of the software will be uninterrupted or error free, or that all defects in the software will be corrected. January 23, 2008
Safety Information 1. Do not use this apparatus near water. 2. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. 3. Do not defeat the safety purpose of the polarized or grounding type plug. A polarized plug has two blades with one wider than the other. A grounding-type plug has two blades and a third grounding prong. The wide blade or the third prong is provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet. 4. Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. 5. Only use attachments/accessories specified by the manufacturer. 6. Refer all servicing to qualified service personnel. Servicing is required when the unit has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the unit, the unit has been exposed to rain or moisture, does not operate normally, or has been dropped. 7. No open flame sources, such as lighted candles, should be placed on the apparatus. 8. The unit shall not be exposed to dripping or splashing. No objects filled with liquids, shall be placed on the unit. 9. The unit is for indoor use only. Operation outside requires the use of an appropriate sealed enclosure. Warnings Follow instructions to avoid interference problems. Do not operate your device in any location where posted notices prohibit its use. These locations include any facility that may be using equipment that is sensitive to external RF energy. If you have a pacemaker, consult your physician before installing or operating this device. Some digital devices may interfere with some hearing aids. In the event of such interference, you may want to consult your hearing aid manufacturer or physician to discuss alternatives. Device Disposal The Remote Telemetry Controller device should not be placed in household waste bins. Please check local regulations for information on the disposal of electronic products in your area. January 23, 2008
Contact Information Visit us online: www.cranewms.com Call our office: (972) 964-5178 Fax our office: (972) 964-5968 Email us: sales@cranewms.com support@cranewms.com January 23, 2008

Navigation menu