SignalFire Telemetry GWDIN DIN Mount Gateway User Manual

SignalFire Telemetry, Inc. DIN Mount Gateway

a href="https://usermanual.wiki/SignalFire-Telemetry" itemprop="url"> SignalFire Telemetry >

User Manual.pdf

 Rev 1.3  SignalFire Telemetry   1     Interface Manual DIN Gateway SignalFire Part Numbers: GW-DIN, GW-DIN-STATICIP  The SignalFire DIN Gateway has the following features: - RS485 connection to Modbus master device - Optional Modbus-TCP Ethernet gateway module - Wide range DC power input. 6 to 36VDC - Two open collector digital outputs  - DIN rail mount - Collects and caches Modbus data from all SignalFire remote nodes - Provides configuration and status registers for remote configuration and status monitoring - RP-SMA antenna port for connection to external 900MHz antenna - Stores up to 4700 register values from any combination of remote nodes - Supports transparent Modbus mode - Internal Remote Shut Down (RSD) logic control option - Slave register re-mapping - Remote configuration of SignalFire devices through an Ethernet gateway connection - Remote sensor configuration (PACTware and RadarMaster)  - Radio is FCC and IC approved  - Class 1 Division 2 Area certification pending
 Rev 1.3  SignalFire Telemetry   2 Connections and Components  DIN Gateway Connections The DIN Gateway has a 6-position pluggable terminal block for power and serial communications. The connections are as follows:  Terminal Name Connection 6-36VDC (RED) Positive Power (6 to 36 VDC) GROUND (BLK) Ground RS232 TX (ORG) RS-232 Debug TX, 9600 Baud (Only used with Ethernet GW module) RS232 RX (YEL) MODBUS A (GRN) RS-232 Debug RX, 9600 Baud (Only used with Ethernet GW module) RS-485 “A”, 9600 Baud MODBUS B (BRN) RS-485 “B”, 9600 Baud In addition, a RS232 DB9 port is available for connection to the SignalFire Toolkit for configuration and diagnostics.  Gateway Hardware revision 2 also has a 3-position pluggable terminal block with two open collector digital outputs for signaling or alarm functions.  Each output is rated to 30VDC and 1 Amp.    Optional Ethernet Gateway Connections When used with a SignalFire Ethernet Gateway module, the 6-potition screw terminal block should be connected to the color coded “Gateway Stick Connection” connector on the Ethernet Gateway.  Power can be supplied either to the Power Input terminals on the Ethernet Gateway or via power over Ethernet (PoE).    NOTE:  when used with an Ethernet Gateway module the DB9 on the Ethernet module must be used for ToolKit access.
Download:
Mirror Download [FCC.gov]
Document ID2979143
Application ID4pXaDtKTr0Udkf2t1vWd0A==
Document DescriptionUser Manual.pdf
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize72.69kB (908680 bits)
Date Submitted2016-05-04 00:00:00
Date Available2016-05-04 00:00:00
Creation Date2016-04-14 08:11:41
Document Lastmod2016-04-14 09:48:26
Document TitleUser Manual.pdf
Document Author: Doug
FCC ID Filing: W8V-GWDIN

Navigation menu