Sirius XM Radio SPRCI XM/Sirius Satellite RX with FM Transmitter User Manual SIR10492 SportsterRCi GSG 101708 indd

Download:
Mirror Download [FCC.gov]
Document ID	1032837
Application ID	tp2KQhs83fIdmgyKri8uJw==
Document Description	Quick Guide Revised
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	226.4kB (2830052 bits)
Date Submitted	2008-11-19 00:00:00
Date Available	2009-01-03 00:00:00
Creation Date	2008-10-17 16:56:02
Producing Software	Adobe PDF Library 8.0
Document Lastmod	2008-10-17 16:56:15
Document Title	SIR10492 SportsterRCi_GSG_101708.indd
Document Creator	Adobe InDesign CS3 (5.0.3)

What’s in the Box?
Vehicle Installation
Radio
display
menu
mute
jump
fav
Adhesive Mount
Dash
Dash
You can adjust this screw
to adjust the tension of the
mount with a screwdriver.
Step 1: The Big Decision.
Remote
Control
4 Turn the swivel to accommodate the vehicle dock and radio. Adjust the
tension via the center screw.
To remove, push the mount into the vent, then lift up.
If your vehicle requires professional installation you will need to use either the XM SureConnect
(sold separately) or the XM FM Direct Adapter (sold separately).
Vent Mount
Pick a spot for your radio. Vent or Dashboard?
Antenna
Cover/Tail
Cassette
Adapter
Vehicle Power
Adapter
Vent
Vent
To remove, carefully lift the adhesive pad with your fingers or a spoon. Warming the
pad with a hair dryer for several minutes will help soften the adhesive.
You can use either the vent mount or the adhesive mount for your radio depending on
your particular situation.
Step 2: Mount the Interoperable Vehicle Antenna.
Install the Adhesive Mount
Interoperable
Vehicle Antenna
Aux In Cable
Alcohol Pad
Vent Mount
WARNINGS:
When using this product it is always important to keep your eyes on the road and hands on the
wheel. Not doing so could result in personal injury, death and/or damage to your SIRIUS XM Radio,
accessories and /or to your vehicle or other property.
Adhesive Mount
2 Hide the wires inside.
The best place to hide your antenna
wire depends on your vehicle. It’s
usually easiest to run the wire from
the rear of the vehicle to the front
toward the radio by routing the
cable along the interior trim where it
meets the carpet, by gently pushing
it behind the edges of the trim. Then
bring the cable out from the trim
and route it under the carpet to the
dashboard or console. Plug the cable
into the radio and coil any extra
wires under the carpet or floor mat.
TIP! Always be careful to include enough
slack in your cable to accommodate open
doors or trunk lids. Use things typically
found around the home, like electrical tape
or twist ties, to secure cables in areas so
that hinges do not pinch the cable. Hide any
excess cable in the trim.
2 Adjust the clamps to fit your vent.
IMPORTANT: Let the adhesive dry for 2 - 3 hours before attaching the vehicle dock and
radio to the mount. For best results let dry for 24 hours.
ANT IN
Plug the Antenna into the vehicle dock’s ANT IN connection.
—OR—
Aux In Cable
• Use the Aux In Cable if your vehicle has an audio input jack.
• Use the Cassette Adapter if your vehicle has a built-in cassette player.
5 Insert your radio into the dock.
SUV
•
•
Pickup Truck - Above front windshield, on the roof toward front of cab.
Centered between right and left sides.
•
Convertible - On trunk lid, at least 3” from seam. Centered between right
and left sides.
•
XM SureConnect (sold separately): You can listen to your radio through your vehicle’s stereo by
using the XM SureConnect. Simply find an unused FM frequency on the stereo and set your radio
to transmit on that same frequency. Refer to Set the FM Frequency page in your user guide for
more information.
XM FM Direct Adapter (sold separately): This option directly connects the radio to your vehicle’s
audio system and antenna.
Vehicle Power
Adapter
• On Channel 0 on either SIRIUS or XM
Cassette Adapter
• On the rear package label
• On the label on the back of your radio
Step 4: Turn on Your Radio and Test for Sound.
3 Activate your service:
Turn on your vehicle’s radio.
• Online: Go to www.sirius.com/mirge
2 Insert the cassette adapter or AUX In Cable.
OR
NOTE: If you are using the XM SureConnect or the XM FM Direct adapter, refer to Turn the FM
modulator ON/OFF on page 54 of the user guide for more information.
3 Turn ON your radio.
Make sure your radio is properly installed and receiving the
SIRIUS signal so that you can hear the audio on SIRIUS
Channel 184.
2 Make a note of your radio’s ID number. You can find it:
Interoperable
Vehicle Antenna
4 Insert the dock into the vent or adhesive mount.
NOTE! Make sure your radio is in SIRIUS mode by pressing the
SAT button. See page 26 in the user guide for more information.
Vehicle Dock
3 Plug one of the audio adapters into the vehicle dock’s AUDIO OUT connection.
NOTE: If your vehicle is not equipped with a cassette player or an audio input, you will need to
use either the XM SureConnect (sold separately) or the FM Direct Adapter (sold separately). A
professional installation is strongly recommended if you choose to use this method. Professional
installation can help improve your radio’s reception and significantly reduce the visibility of wires.
To learn more, go to www.sirius.com/mirge.
Before you can listen to any of the great channels, you must first
activate your radio.
DC IN
AUDIO OUT
2 Plug the Power Adapter into the vehicle dock’s DC IN connection.
Sedan
Magnet
Activate
Almost there!
Place the antenna outside.
Leave at least 3” of metal around the antenna.
Use the rubber tail cover to hide and protect the
exposed wire. Feed the wire under the rubber
molding around the back windshield, into the seal
around the trunk. Route the cable along trunk wall
and into the interior cabin from there.
Step 3: Connect Your Radio.
Antenna placement options for other vehicles.
SIR10492 SportsterRCi_GSG_101708.indd 1
3 Peel off the adhesive liner. Position, press, and hold the adhesive mount
in place for 30 seconds.
Locate a vent with horizontal slats sturdy
enough to hold your vehicle dock and radio.
YOU MUST USE THE INCLUDED INTEROPERABLE ANTENNA WITH THIS RADIO
Locate a flat surface for the mount. Make sure there is ample room for the
vehicle dock and radio when installed.
2 Clean the surface with the alcohol pad and let it dry thoroughly.
Install the Vent Mount
The radio should be placed in your vehicle where it will not interfere with the function of safety
features, e.g., deployment of airbags. Failure to correctly place radio may result in injury to you or
others if the unit becomes detached during an accident and/or obstructs the deployment of an airbag.
You’ll be glad you did this right.
CAUTION: The adhesive used with the adhesive mount may make it difficult to remove. Do not
install this mount on leather surfaces and make sure the air temperature is at least 60°F (15°C).
Vehicle Dock
3 Snap the mount onto the vent.
NOTE: Do it yourself with the step-by-step instructions below if your vehicle has a cassette player or
audio input. If your vehicle does not have a cassette player or audio input, professional installation is
strongly recommended.
info
19
NOTE: You may experience a brief delay while your radio powers up. If you press the power button
during this time, you will see a “Please Wait” message.
• By phone: call 1-888-539-SIRIUS (1-888-539-7474)
4 Depending on which Satellite Radio services you activated, channels will
become available about 10 to 15 minutes after activation — although it may
take up to an hour. Your radio must remain ON until activated.
10/17/08 4:56:09 PM
9
Radio Functions
10
Use Your Radio
60-Minute REPLAY Buttons
Pause, rewind and replay up
to 60 minutes of live radio.
DISPLAY
Customize the way content
on the display is shown.
11
Selecting a channel
Listen to SIRIUS or XM
Select the radio service
2 You’ll see the channel’s logo and
current artist. In a few seconds,
the current song title appears.
The currently-active radio service logo is shown in the display’s channel
information bar.
POWER Button
SELECT Button
Confirms selection for
channel and menu items, also
press and hold to TuneSelect.
2 Press the SAT button on the radio or remote to switch to the other radio
service. The radio will play the channel that was last tuned in that service.
3 Press the SELECT button to
select a channel.
< LEFT and RIGHT > Arrows
Search for channels
by category.
Channels are organized into categories to make it easier for you to find the ones
that suit your taste.
MENU
Access advanced features
and configuration options.
SATELLITE
Switches between
the SIRIUS and XM
satellite radio.
JUMP
Switches between
current channel and
previous channel.
TIP! You can configure the radio to
automatically tune to the channel you scroll
to. Refer to page 34 of the user guide for
more instructions.
View a category
5-way Navigation KNOB
Previews channels; also selects
various menu options.
NUMBER Buttons
Enter a channel
directly or select your
favorite channels.
Turn the KNOB (radio) or use the
Up/Down buttons (remote) to
scroll through the list of channels.
To view a category, press the LEFT or RIGHT arrows (
or
Getting Started Guide
).
2 Scroll through the category to find the channel you want.
FAVORITES
Choose between direct channel
entry or favorite channels mode.
3 Press the SELECT button.
SIRIUS Radio Service
XM Radio Service
12
TIP! To briefly listen to each channel in the category, select SCAN,
then press the SELECT button.
13
14
Getting Started Guide (GSG1208)
Set Your Favorite Channel
Split Screen Display Mode
You can assign up to 10 presets of your favorite channels in each satellite service to
the number buttons so you can quickly access them.
You can view multiple channels on the display to see what else is playing.
©2008 SIRIUS XM Radio Inc. “SIRIUS”, “The Best Radio on Radio”, the SIRIUS logos,
channel names and logos and related marks are trademarks of SIRIUS XM Radio Inc.
The “XM” name and related logo are trademarks of XM Satellite Radio Inc. All other
trademarks, service marks, and logos are the property of their respective owners.
Hardware and required monthly subscription sold separately. All rights reserved.
To assign a preset to a button:
1 Tune to the desired channel.
2 Be sure you are in Favorite Channels
mode. Press FAV until Favorite
Channels appears in the title bar.
Split screen showing Channel List
Split screen showing Category List
3 Press and hold the number button
you want to use for that preset.
sirius.com/mirge
To listen to a favorite channel:
Be sure you are in Favorite Channels
mode. Press FAV until Favorite
Channels appears in the title bar.
2 Press the number button assigned
to your favorite channel.
TIP! To see your list of Favorite Channels,
press
or . Select a favorite and press
the SELECT button to listen to that channel.
SIR10492 SportsterRCi_GSG_101708.indd 2
Split screen showing Previous Channel
Split screen showing Favorite Channels
To change the mode, press DISPLAY.
TIP! When in Split Screen with Channel List, you can scroll through the list of channels,
just like when it appears on the full screen. Press
or
to change categories. Press the
SELECT button to select a channel.
TIP! Press JUMP to tune to the previous channel on active service.
10/17/08 4:56:15 PM

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.3
Linearized                      : No
XMP Toolkit                     : Adobe XMP Core 4.1-c037 46.282696, Mon Apr 02 2007 18:36:56
Instance ID                     : uuid:b6db86fd-b5b3-4a40-8b13-49748a638b48
Document ID                     : adobe:docid:indd:e60fe149-9dc2-11dd-8147-ec3a0bbd6cfe
Rendition Class                 : proof:pdf
Derived From Instance ID        : 0d0bc947-9d39-11dd-8d43-cf851ad22193
Derived From Document ID        : adobe:docid:indd:f1d2a252-9d2e-11dd-8d43-cf851ad22193
Create Date                     : 2008:10:17 16:56:02-04:00
Modify Date                     : 2008:10:17 16:56:15-04:00
Metadata Date                   : 2008:10:17 16:56:15-04:00
Creator Tool                    : Adobe InDesign CS3 (5.0.3)
Thumbnail Format                : JPEG
Thumbnail Width                 : 256
Thumbnail Height                : 256
Thumbnail Image                 : (Binary data 11681 bytes, use -b option to extract)
Format                          : application/pdf
Title                           : SIR10492 SportsterRCi_GSG_101708.indd
Producer                        : Adobe PDF Library 8.0
Trapped                         : False
GTS PDFX Version                : PDF/X-3:2003
GTS PDFX Conformance            : PDF/X-3:2003
Page Count                      : 2
Creator                         : Adobe InDesign CS3 (5.0.3)

EXIF Metadata provided by EXIF.tools