Skuandy 2XL20130002 Bluetooth Headphone User Manual BARREL BT USER 2 copy
Skullcandy Bluetooth Headphone BARREL BT USER 2 copy
Skuandy >
User manual
Wireless Barrel
User Guide
Power On – Press and hold the MFB unil the LED ashes
blue and the ascending tone plays through the
headphones.
Power O – Press and hold the MFB until the LED turns
RED and the descending tone plays through the
headphones.
Pairing – While power is o, hold the MFB until the LED
alternates ashing BLUE and RED.
Un-pairing – Press and hold the volume up and volume
down buttons until you hear two short tones.
Pause – Press the MFB once to pause and once again to
play.
Volume Up – Press the volume up button. A tone will sound
at maximum volume.
Volume Down – Press the volume down button. A tone will
sound at minimum volume.
Next Track – Press and hold the volume up button.
Previous Track – Press and hold the volume down button.
Answer Call – While paired, push the MFB once.
Hang Up Call – Push the MFB once.
Charging –The LED will be Red while charging and turn
Blue once fully charged.
Low Battery – The LED will ash Red and a tone will sound
4 times.
EN
®
Note: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and
can radiate radio frequency energy, and if not installed and
used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or
more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and
receiver.
– Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician
for help.
You are cautioned that changes or modifications not
expressly approved by the party responsible for compliance
could void your authority to operate the equipment.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.
This device complies with Industry Canada’s licence-exempt
RSSs. Operation is subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including
interference that may cause undesired operation of the
device.
Le présent appareil est conforme aux CNR d'Industrie
Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible
d'en compromettre le fonctionnement.