Skuandy SK20130012 Bluetooth Headphones User Manual BARREL BT USER 2 copy
Skullcandy Bluetooth Headphones BARREL BT USER 2 copy
Skuandy >
User Manual
® Wireless Barrel User Guide EN Power On – Press and hold the MFB unil the LED flashes blue and the ascending tone plays through the headphones. Power Off – Press and hold the MFB until the LED turns RED and the descending tone plays through the headphones. Pairing – While power is off, hold the MFB until the LED alternates flashing BLUE and RED. Un-pairing – Press and hold the volume up and volume down buttons until you hear two short tones. Pause – Press the MFB once to pause and once again to play. Volume Up – Press the volume up button. A tone will sound at maximum volume. Volume Down – Press the volume down button. A tone will sound at minimum volume. Next Track – Press and hold the volume up button. Previous Track – Press and hold the volume down button. Answer Call – While paired, push the MFB once. Hang Up Call – Push the MFB once. Charging –The LED will be Red while charging and turn Blue once fully charged. Low Battery – The LED will flash Red and a tone will sound 4 times. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: – Reorient or relocate the receiving antenna. – Increase the separation between the equipment and receiver. – Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. – Consult the dealer or an experienced radio/TV technician for help. You are cautioned that changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause interference; and (2) This device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.5 Linearized : No Create Date : 2015:04:23 09:20:32-06:00 Creator : Adobe Illustrator CS5.1 Modify Date : 2015:05:06 15:57:39+08:00 Has XFA : No XMP Toolkit : Adobe XMP Core 5.4-c005 78.147326, 2012/08/23-13:03:03 Format : application/pdf Title : BARREL BT_USER (2) copy Metadata Date : 2015:05:06 15:57:39+08:00 Creator Tool : Adobe Illustrator CS5.1 Thumbnail Width : 256 Thumbnail Height : 188 Thumbnail Format : JPEG Thumbnail Image : (Binary data 7983 bytes, use -b option to extract) Instance ID : uuid:366764e9-51d2-47b2-8dad-05963572be48 Document ID : xmp.did:A6771744CCE9E411BBAA861A3B3B4CC8 Original Document ID : uuid:5D20892493BFDB11914A8590D31508C8 Rendition Class : proof:pdf Derived From Instance ID : uuid:e95cc385-e8bf-a049-aac0-b74082840064 Derived From Document ID : xmp.did:02801174072068118C14E172FEF7D4B4 Derived From Original Document ID: uuid:5D20892493BFDB11914A8590D31508C8 Derived From Rendition Class : proof:pdf History Action : saved, saved, saved History Instance ID : xmp.iid:01801174072068118C14E172FEF7D4B4, xmp.iid:02801174072068118C14E172FEF7D4B4, xmp.iid:A6771744CCE9E411BBAA861A3B3B4CC8 History When : 2015:04:22 15:35:24-06:00, 2015:04:22 16:31:26-06:00, 2015:04:23 09:20:25-06:00 History Software Agent : Adobe Illustrator CS6 (Macintosh), Adobe Illustrator CS6 (Macintosh), Adobe Illustrator CS5.1 History Changed : /, /, / Startup Profile : Print Has Visible Overprint : False Has Visible Transparency : False N Pages : 1 Max Page Size W : 1167.110352 Max Page Size H : 858.078125 Max Page Size Unit : Points Font Name : HelveticaNeue-Bold, AvenirLTStd-Heavy, HelveticaNeue Font Family : HelveticaNeue Bold, AvenirLTStd Heavy, HelveticaNeue Font Face : Bold, Heavy Font Type : Unknown, Unknown, Unknown Font Version : Version 2.062;PS 2.000;hotconv 1.0.57;makeotf.lib2.0.21895, Version 2.062;PS 2.000;hotconv 1.0.57;makeotf.lib2.0.21895, Version 2.062;PS 2.000;hotconv 1.0.57;makeotf.lib2.0.21895 Font Composite : False, False, False Font File Name : MyriadPro-Regular.otf, MyriadPro-Regular.otf, MyriadPro-Regular.otf Plate Names : Cyan, Magenta, Yellow, Black, PANTONE Strong Red C Swatch Groups Group Name : Default Swatch Group Swatch Groups Group Type : 0 Swatch Groups Colorants Swatch Name: PANTONE Strong Red C Swatch Groups Colorants Type : SPOT Swatch Groups Colorants Tint : 100.000000 Swatch Groups Colorants Mode : LAB Swatch Groups Colorants L : 43.921600 Swatch Groups Colorants A : 78 Swatch Groups Colorants B : 15 Producer : Adobe PDF library 9.90 Page Count : 1 For : Jason Luthman, Bounding Box : 0 0 1168 859 Container Version : 11 Creator Version : 15 Image Height : 859 Image Width : 1168 Image Size : 1168x859 Megapixels : 1.0EXIF Metadata provided by EXIF.tools