Sky Light Imaging MPC03G Car Camcorder User Manual Motor Argo
Sky Light Imaging Limited Car Camcorder Motor Argo
User Manual
Motor + Argo MPC03G User Manual 11 12 13 Wi-Fi Button Capture a photo during recording Manually trigger an Event Protection Video Recording Turn on/off Wi-Fi function 3. Installing the Windshield Mount & Argo in a Vehicle 1. 2. 3. Clean the area on the windshield. Peel off the protective membrane of the 3M adhesive and stick the Windshield Mount to the front windshield inside the car. Slip the socket on the top of the Argo into Windshield Mount until it is latched. 1. Key Features 125 Wide Angle Lens. Event Video Recording for prior and after for sudden external impact. Continuous loop of scenery capture for unexpected incidents. Geo-information capture in photo or video files with the built-in GPS sensor. High quality video recording up to 1296p high quality videos. Photo capture during recording. Voice Prompt. Wi-Fi Function. 7. 4. 2. Functional Parts 5. Press the Windshield Mount side to release and slide the Argo off the mount. The lens of Argo should be at the center of the front windshield and be aware not to block the driver’s visibility. Adjust the nut on the Windshield Mount for suitable direction and orientation. 4. LED Indication “RED” Status LED ON “RED” Status LED Flashes continuously “PURPLE” Status LED ON “BLUE“ Status LED ON 6. Micro USB Port DC in Port microSD Slot Wide Angle Lens Reset Button Speaker Vent Mounting Socket 10 Wi-Fi LED Indicator Status LED Indicator GPS LED Indicator Connect to PC for file browsing and file transfer Connect to the provided DC in to USB cable for charging microSD card storage location Capture a wide angle view Reset the Argo Output the sound Install the windshield mount. You can detach the socket on the top of the Argo to mount the Argo on the other optional mounting accessories Wi-Fi status indication Operation status indication GPS status indication Connect the Argo to the DC Power jack with included DC in to USB cable and the Dual USB CLA. Secure the cable with the cable holder to avoid from interference of driver's motion. Blue & Red status LED alternating flash “ORANGE” GPS LED ON “ORANGE” GPS LED Flashes “GREEN” Wi-Fi LED ON “GREEN” Wi-Fi LED Flashes slowly “GREEN” Wi-Fi LED Flashes rapidly Argo is under Normal Looping Recording. Counting down and the Argo is going to turn off due to the power source is removed. Argo is under Event Protection Recording. Argo is connecting to PC through USB cable. 1. No memory card is installed 2. Memory card is less than 8GB 3. Card error GPS signal is received. No GPS signal or GPS signal is weak. Wi-Fi is initializing. Wi-Fi is ready for connection or enabled. Data is transferring in Wi-Fi mode. 5. Using Your Argo 5.1. Inserting a microSD Memory Card (not included) Insert a microSD card (not included) to the slot before using the Argo. Assure that the Argo power is turned OFF before inserting the card. A min 8GB, Class 6 or above card is recommended. 4. Open your Motor+ app. You may conduct relevant operations in accordance with specific Application interface. 7 Connecting the Argo to a Computer Notes: 1. 2. The correct direction should be followed to insert the microSD card into the slot. You may also connect the Argo to your computer and view videos and pictures on the computer monitor. 1. Connect the Argo to your computer with a USB cable to enter into USB mode. 2. Your computer will recognize the Argo as a “Removable Disk”. The Blue Status LED will light up. Open the disk and go to relevant file folder to view, import, copy, transfer or delete the videos or photos. A new microSD card should be formatted before using. You can format the microSD card through the Motor+ software. 5.2 Turning on/off Argo The Argo will automatically turn on and start Normal Looping Recording after the ignition. 5.3 Video Recording and Photo Taking Normal Looping Recording The Argo will start Normal Looping Recording once turned on. The Red status LED lights up during Normal Looping recording. Video recording is repeatedly creating successive files of 3 min, 5 min or 10 min. The most outdated file will be replaced if the memory is full for continuous recording. Event Protection Recording Files will be protected from the auto deletion if an impact is detected. The sensitivity of impact detection can be adjusted through the Motor+ software. By pressing during normal recording can also enter the Event Protection Recording mode to protect your video files. The Purple status LED lights up during Event Protection recording. You can store up to 30 Event protection videos to the Argo. Each Protected video file length will be 20 sec. Photo Taking Press once during recording for taking a photo. The Status LED will flash each time a photo is taken. You can store up to 500 photos to the Argo. 8 Specifications 6.1 Enabling the Wi-Fi Function 1. 2. 3. 4. Connect the Argo to an external power supply with the included DC in to USB cable. The Wi-Fi mode will turn on automatically. The Green Wi-Fi LED lights up to indicate the Wi-Fi is warming up. Wait for Wi-Fi to initialize. The Wi-Fi LED will flash when the WiFi is active or connected. To turn off Wi-Fi, press and hold or disconnect Argo from the external power supply. 6.2 Connecting the Argo to your Computer or Smart Device 1. 2. 3. Turn on the Wi-Fi mode on Argo. Go to network setting on your computer or Smart Device to enable the Wi-Fi setting. Search for the “MOTORPLUS” network. Enter password “123456789” to connect to the Argo. 6.3 Using the Free App 1. 2. 3. Search for Motor+ app via the Google Play Store or App Store. Download and install the app to your smart device. Connect the Argo to your Smart Device by following the steps in section 6.2. Problem 125 Wide Angle Lens 3MP on 1296p Still Image Resolution 2MP on 1080p on Recording 1MP on 720p 1296P: 2304x1296 P30 Video Resolution 1080P: 1920x1080 P30 720P: 1280x720 P30 Video Format MPEG4 (H.264) .MOV File Photo Format JPG GPS Sensor Yes G Sensor Yes Wi-Fi Yes Power Microphone Speaker Language Cause Solution Low battery power Connect the Argo with power source by DC or USB cable Cannot find removable disk after connecting the Argo to the computer Connection failure 1. Make sure all cable connections are secured 2.Restart the computer if necessary Blurry images 1. The Argo has not been installed steadily 2. The lens of Argo is dirty 1. Reinstall the Argo 2. Clean the lens with soft and dry cloth Cannot turn on the Argo FCC Statement Lens At least 256MB USB port 4x speed CD ROM or above 10 Troubleshooting Note : If the Removable Device Window did not launch automatically, go to your “My Computer” and find the device under Removable Disk. USB Port 6. Connecting the Argo via Wi-Fi RAM Interface CD Micro USB DC in Yes Yes English Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply w ith the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. How ever, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or televis ion reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiv er. • Connect the equipment into an outlet on a circuit different from that to whic h the receiver is connected. 185mAh Operation Temperature -20 to 60 degree • Consult the dealer or an experienced radio/ TV technician for help. This device complies w ith Part 15 of the FCC Rules. Operation is subject to the follow ing two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference receiv ed, including interference that may cause undesired operation. Storage Temperature -40 to 80 degree Dimension (L x W x H) 63X43X21 mm Shielded cables must be used with this unit to ensure compliance w ith the Class B FCC limits. Voice Language Wi-Fi English, Mandarin Yes Battery Weight 66.3g 9 Computer System Minimum Requirements Operating System CPU Windows 7&8 / Vista / XP and Mac OS 10.5 or above Pentium Ⅲ or above4 / 3.0G or faster recommended AM-MPC03G-GB-STD-3
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.5 Linearized : Yes Author : Zhu Pei Create Date : 2014:12:02 16:25:27+08:00 Modify Date : 2014:12:02 16:25:29+08:00 Subject : Tagged PDF : Yes XMP Toolkit : Adobe XMP Core 5.4-c005 78.147326, 2012/08/23-13:03:03 Metadata Date : 2014:12:02 16:25:29+08:00 Creator Tool : Acrobat PDFMaker 11 for Word Document ID : uuid:9bbce48b-ed71-44cc-a7d2-afc8df697664 Instance ID : uuid:8f4da101-fa59-4724-99f1-138e1abe9895 Format : application/pdf Title : Motor + Argo Description : Creator : Zhu Pei Producer : Adobe PDF Library 11.0 Keywords : Source Modified : D:20141028025316 Company : Comments : Page Layout : OneColumn Page Count : 2EXIF Metadata provided by EXIF.tools