SkyHawke Technologies SX500 SkyCaddie SX500 User Manual
SkyHawke Technologies, LLC SkyCaddie SX500
users manual
NOTE: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of
the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
RF Exposure Information:
FCC RF Exposure requirements: The highest SAR value reported under this
standard during product certification for use next to the head with the minimum
separation distance of 0mm is 0.337 W/Kg and 0mm to the body is 0.691 W/Kg.
This transmitter must not be collocated or operating in conjunction with any
other antenna or transmitter.
This product is compliance to FCC RF Exposure requirements and refers to
FCC website https://apps.fcc.gov/oetcf/eas/reports/GenericSearch.cfm
search for FCC ID: X8F-SX500
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1)this device may not
cause interference, and(2) this device must accept any interference, including
interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables
auxappareils radio exempts de licence. L'exploitation est autorisée aux deux
conditions suivantes :(1) l'appareil ne doit pas produire de brouillage, et(2)
l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre lefonctionnement.
This EUT is compliance with SAR for general population/uncontrolled
exposure limits in IC RSS-102 and had been tested in accordance with the
measurement methods and procedures specified in IEEE 1528 and IEC 62209.
This equipment should be installed and operated with minimum distance 0mm
between the radiator and your head, 0mm between the radiator and your body.
This device and its antenna(s)must not be co-located or operating in
conjunction with any other antenna or transmitter.
Cet appareil est conforme aux limites d'exposition DAS incontrôlée pour la
population générale de la norme CNR-102 d'Industrie Canada et a été testé en
conformité avec les méthodes de mesure et procédures spécifiées dans IEEE
1528 et IEC 62209. Cet équipement doit être installé et utilisé à une distance
minimale de 0mm entre le radiateur et votre tête, 0 mm entre le radiateur et
votre corps. Cet appareil et son (ses) antenne (s) ne doivent pas être
co-localisés ou fonctionner conjointement avec une autre antenne ou un autre
émetteur.