Skytech II 4001TX Remote Control Transmitter User Manual SKY 4001

Download:
Mirror Download [FCC.gov]
Document ID	538250
Application ID	KW/j84rCDksBepgYzKOlrA==
Document Description	Users Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	1.5kB (18727 bits)
Date Submitted	2005-05-02 00:00:00
Date Available	2005-04-29 00:00:00
Creation Date	2005-04-19 18:43:23
Producing Software	Acrobat PDFWriter 5.0 for Windows NT
Document Lastmod	2005-04-28 14:07:51
Document Title	SKY-4001 USER MANUAL.doc
Document Creator	SKY-4001 USER MANUAL - Microsoft Word
Document Author:	Debby

(SKY-4001)
INSTALLATION AND OPERATING INSTRUCTIONS
INTRODUCTION
SKYTECH’S remote control system was developed to provide a safe, reliable and
user-friendly remote control system for gas heating appliances. Its battery operation
allows the system to operate independently of household current. The system operates
on radio frequencies with non-directional signals. The SYSTEM’s operating range is
approximately 20 feet. The system operates on one of 255 security codes programmed
at the factory.
COMPONENTS
WARNING
THE SKYTECH SKY-4001 MUST BE INSTALLED EXACTLY AS OUTLINED IN
THESE INSTRUCTIONS. FOLLOW INSTRUCTIONS CAREFULLY DURING
INSTALLATION. ANY MODIFICATION OF THE SKYTECH SKY-4001 OR ANY
OF ITS COMPONENTS WILL VOID THE WARRANTY AND MAY POSE A FIRE
HAZARD.
TRANSMITTER
ON
OFF
The transmitter operates on a 3v battery
(included) made specifically for remote
controls and electronic lighters. Before using
the transmitter, remove the insulation tab
protecting one end of the battery in the battery
compartment.
The transmitter has ON and OFF functions that
are activated by pressing either button on the
face of the transmitter. When a button on the transmitter is pressed, a signal light on
the transmitter illuminates briefly to verify that a signal has been sent. Upon initial
use, there may be a delay of five seconds before the remote receiver will respond to
the transmitter. This is part of the system’s design. If the signal light does not
illuminate, check the position of the transmitter’s battery.
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
Important Note:
FCC Radiation Exposure Statement:
This equipment complies with FCC RF radiation exposure limits set forth for a n
uncontrolled environment. To maintain compliance with FCC RF exposure
compliance requirements, please avoid direct contact to the transmitting
antenna during transmitting.
This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : No
Encryption                      : Standard V1.2 (40-bit)
User Access                     : Print, Copy, Fill forms, Extract, Assemble, Print high-res
Create Date                     : 2005:04:19 18:43:23Z
Modify Date                     : 2005:04:28 14:07:51+08:00
Page Count                      : 2
Creation Date                   : 2005:04:19 18:43:23Z
Author                          : Debby
Producer                        : Acrobat PDFWriter 5.0 for Windows NT
Mod Date                        : 2005:04:28 14:07:51+08:00
Metadata Date                   : 2005:04:28 14:07:51+08:00
Title                           : SKY-4001 USER MANUAL.doc
Creator                         : Debby

EXIF Metadata provided by EXIF.tools