Smarfid Security Equipment REB3040 Remote Transmitter User Manual
Shanghai Smarfid Security Equipment Co., Ltd. Remote Transmitter
User Manual
上海思慧德安防设备有限公司
中国上海闵行区外环路 358 号A2 栋
-----------------------------------------------------------------------------------------------------------------------------------------------------------
Shanghai Smarfid Security Equipment Co., Ltd.
Building A2, No.358 Waihuan Road, Xinzhuang Town, Minhang District, Shanghai 201199
Tel: +86-021-54260132 MOB: +86-13636369638 Website: www.smarfid.com
User Manual
Model No. : REB3040
Operating specifications : Products picture :
Operating voltage : DC6V。
Operating current : 0.2mA。
Standby current : 0mA。
Operating Frequency : 433MHz。
Encode Chip : EV1527。
Oscillating resistance : 270KΩ。
Transmission distance : 30 Meter (on open site)。
Button : Independent key。
Operating:
Press button : 433MHz signal send out to receiver.
Release button : 433MHz signal isn’t send out.
FCC Regulatory Statements
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
NOTE : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the Federal
Communication Commission (FCC) rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•Consult the dealer or an experienced radio/TV technician for help.
NOTE : ANY CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY THE PARTY RESPONSIBLE FOR
COMPLIANCE COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.
Button