Smart Systems T6210 Occupancy Sensor User Manual Operation Manual T6210 revised

Smart Systems International Occupancy Sensor Operation Manual T6210 revised

Users Manual

Download: Smart Systems T6210 Occupancy Sensor User Manual Operation Manual T6210 revised
Mirror Download [FCC.gov]Smart Systems T6210 Occupancy Sensor User Manual Operation Manual T6210 revised
Document ID605661
Application IDBvArrjdT29qJH+ll2JZetg==
Document DescriptionUsers Manual
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize0.76kB (9472 bits)
Date Submitted2005-11-24 00:00:00
Date Available2005-11-24 00:00:00
Creation Date2005-11-23 12:04:09
Producing SoftwareAcrobat PDFWriter 5.0 for Windows NT
Document Lastmod2005-11-23 12:05:40
Document TitleOperation Manual T6210-revised.doc
Document CreatorOperation Manual T6210-revised.doc - Microsoft Word
Document Author: jsanchez

T6210 Motion Sensor Manual
Operation Manual-T6210 Motion Sensor
The T6210 motion sensor unit works in conjunction with the T6510
thermostat to enable total management of all the functions of the HVAC unit.
Working together, they give you a greater measure of control over how your
HVAC unit will operate in varying conditions.
Install the unit by first removing the base. Grasp the base and twist
it counter-clockwise. Use two screws to affix the base to the ceiling or the top of a
wall that provides the unit with an unobstructed view of the area to be under
motion sensing.
Install four (4) AA batteries in the sensor unit. The proper
orientation of the batteries is shown on symbols next to the battery holders.
Placing the ridges on the base above the battery holders, slip the
teeth of the motion sensor unit into the base, and rotate the base clockwise until
it locks into place.
T6210 Motion Sensor Manual
Installation Considerations
When installing the T6210 in a “Hard Wired configuration a Ferrite
Bead (Fair-Rite 0431167281) or equivalent must be used.
To install the bead, thread the cable from the AC unit through the
bead, loop the cable around the bead once and thread it back through. Ensure
that the bead is as close to the sensor as possible .
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause interference, and (2) this
device must accept any interference, including interference that may cause
undesired operation of the device. Changes or modifications not expressly
approved by Smart Systems International could void the user's authority to
operate the equipment.
This product has been tested and complies with the specifications for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used according to the instructions, may cause
harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which is found by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving a ntenna
Increase the separation between the equipment or devices
Connect the equipment to an outlet other than the receiver's
Consult a dealer or an experienced radio/TV technician for assistance
This Class B digital apparatus complies with Canadian ICES003. Cet appareil numérique de la classe B est conforme à la
norme NMB-003 du Canada.
Smart Systems International
3271 S. Highland Drive Ste. 715
Las Vegas, NV 89109

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : No
Create Date                     : 2005:11:23 12:04:09Z
Modify Date                     : 2005:11:23 12:05:40-08:00
Page Count                      : 2
Creation Date                   : 2005:11:23 12:04:09Z
Author                          : jsanchez
Producer                        : Acrobat PDFWriter 5.0 for Windows NT
Mod Date                        : 2005:11:23 12:05:40-08:00
Metadata Date                   : 2005:11:23 12:05:40-08:00
Title                           : Operation Manual T6210-revised.doc
Creator                         : jsanchez
EXIF Metadata provided by EXIF.tools
FCC ID Filing: LG4T6210

Navigation menu