Solatube SLT Touch screw remote control Purpose of User Manual 1

Solatube International Inc. Touch screw remote control Purpose of 1

User Manual

Thanks for choosing the wireless lamp products. In order to be
better to use the product, please read this operation instruction
seriously.
The Touch screw remote control adopts the latest RF technology
and digital identification technology, which makes the products
stable and high performance, as well make the system very easy
to know which one is in need of service.
Technical data
Working frequency: 433.92MHz
Working voltage: DC6V (CR2032 x 2)
Standby current: <30uA
Working current: ≤ 10mA
Encoding mode: learning code
Working temperature: -10~+50°C
Product size: 86 × 86 × 10mm
User manual of SLT-SYT100-1M
Touch screw remote control
Diagram
Figure 1
Installation
Usage method
Figure 2
Double sided
tape
①Pull out the insulation
plastic at first use. ②　
Stick the calling button on the
wall by double sided tap.
Change battery
Note: the pairing method, please refer to the user manul
of lamp.
Figure 3
3V
3V
(1) Put the screwdriver
into the disassemble
port and push it up.
(2) Take out the upper
part of the caller
from the bottom
(3) Change the battery.
Press the button, the light on, press again, the light off.
Touch button
Transmit / low power
indicator
Battery box
Glass
Wall
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
-- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition
without restriction. This device and its antenna(s) must not be co-located or operation in conjunction with any other antenna or transmitter.
&DXWLRQ$Q\FKDQJHVRUPRGLILFDWLRQVQRWH[SUHVVO\DSSURYHGE\WKHSDUW\UHVSRQVLEOH
IRUFRPSOLDQFHFRXOGYRLGWKHXVHUVDXWKRULW\WRRSHUDWHWKHHTXLSPHQW

Navigation menu