SolidLabs INTF001 Interface User Manual 1 of 6

Download:
Mirror Download [FCC.gov]
Document ID	3145748
Application ID	+ufwm2djZa0OZYnVaMvedA==
Document Description	Users Manual - 1 of 6
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	21.01kB (262613 bits)
Date Submitted	2016-09-24 00:00:00
Date Available	2016-12-23 00:00:00
Creation Date	2016-06-21 14:52:33
Producing Software	Mac OS X 10.11.5 Quartz PDFContext
Document Lastmod	2016-06-21 14:52:33
Document Title	Users Manual - 1 of 6
Document Creator	Adobe InDesign CC 2015 (Macintosh)

Instruction Guide
Book 0
BE CAREFUL!
EN
Warning! Not suitable for children under 3 years. Small parts. Choking Hazard. Only
operate the toy indoors under adult supervision. Assemble and set up with an adult
too. Do not open your Cubetto, remove internal components, operate if damaged,
and/or if broken. Rechargeable batteries can be used, but may not last long. Do not
mix old and new batteries. Insert batteries using the correct polarity. Remove
batteries after long periods of inactivity.
IT
Avvertimento! Non adatto a bambini sotto i 3 anni. Piccole parti. Rischio di
soffocamento. Far funzionare il giocattolo in casa sotto supervisione di un adulto.
Assemblare e impostare con un adulto. Non aprire Cubetto, non rimuovere i
componenti interni, non utilizzarlo se danneggiato, e/o in caso di rottura. Possono
essere utlilizzate batterie ricaricabili, per le quali non garantiamo lunga durata. Non
mischiare batterie vecchie e nuove. Inserire le batterie con la polarità corretta.
Rimuovere le batterie dopo lunghi periodi di inattività.
FR
Attention! Non adapté aux enfants de moins de 3 ans. Petites pièces. Small parts.
Risque d’étouffement. Seulement utiliser le jouet en intérieur sous la supervision d’un
adulte. Assember et configurer également avec un adulte. Ne pas ouvrir
Cubetto, enlever les composants intérieurs, utiliser si endommangé, et/ou si cassé.
Des piles rechargeables peuvent être utilisées, mais peuvent ne pas tenir longtemps.
Ne pas mélanger des piles neuves et des piles usagées. Insérer les piles en utilisant
la bonne polarité. Enlever les piles après de longues périodes d’inactivité.
DE
Achtung! Nicht geeignet für Kinder unter 3 Jahren. Erstickungsgefahr auf Grund von
Kleinteilen. Darf nur unter Aufsicht von Erwachsenen verwendet und
zusammengesetzt werden. Cubetto darf nicht geöffnet werden, Innenteile nicht
herausgenommen werden und nicht bedient werden falls beschädigt.
Wiederaufladbare Batterien dürfen verwendet werden aber können möglicherweise
nicht lange halten. Die Verwendung von alten zusammen mit neuen Batterien wird
nicht empfohlen. Beim Einsetzten der Batterien bitte auf die korrekten Polaritäten
achten. Bei langer Nichtbenutzung wird das Austauschen der Batterien empfohlen.
ES
Atención! No apto para niños menores de 3 años. Piezas pequeñas. Riesgo de
asfixia. Debe utilizarse únicamente en interiores, bajo la supervisión de un adulto. El
montaje, también debe ser supervisado por un adulto. No abra su Cubetto o retire
los componentes internos, en caso de daños o rotura. Pueden utilizarse baterías
recargables, pero es posible que no duren. No mezclar baterías nuevas con antiguas.
Asegurese de insertar las baterías usando la polaridad correcta. En caso de largos
periodos de inactividad, se recomienda sacar las baterías.
JP
3歳以下のお子様のご使用はおやめください。パーツの中には口に入る小さなサイズが
あり、飲み込みの危険があります。口の中に絶対にいれないでください。大人の見てい
るところでの使用とし、室内で使用してください。組み立ては大人と一緒に行います。
壊れたり、不具合のある場合に、キュベット（箱型ロボット）の中を開けたり、中身
の部品を取り出したりしないでください。リチャージャブル（充電式電池）電池を使う
ことはできますが、電池が長持ちすることはありません。また、使用済みの電池と新し
い電池を一緒に使うことはお避けください。電池は極を正しい位置に設置します。長期
間、使用しない場合、使用しなかった場合は電池をとりはずしてください。お子様が顔
をキュベット（箱型ロボット）に近づけないようにして遊ばせてください。
Hi!
I’m Cubetto, the little wooden robot who
loves to explore and play, but I need your
help!
Will you be my friend and help me find my
way?
Let’s get started!
In my box you will find:
1. Me! - Cubetto the wooden robot
2. Interface Board - My control panel
3. 16 Blocks - My commands
4. World Map - My playground for adventure!
1
Cubetto
I’m always ready for adventure. Take
me out of the box so we can meet!
As you can see, I have two wheels.
Each wheel has one motor.
My shell is wood, my bones are plastic,
and my brain is a computer.
All that’s missing is you to give me
directions.
5
Queue
Board
My Board is very
important. It’s how you
talk to me.
Use it with my colourful blocks
and tell me where to go.
On my Board are my Queue, my
Function Line, and a Go button.
Go
Function Line
3
Blocks
My blocks come in different shapes and
colours. Each one gives me a different
instruction.
When you place a block into my Board
and hit Go I will make my move.
A series of blocks in a row is called a
program.
These are my basic commands:
Green - moves me forward 15 cm
Red - turns me right 90º
Yellow - turns me left 90º
Blue - executes a function
Forward
Right
90°
Left
90°
Function
4
World Map
My maps are playgrounds for our
adventures. There are many exciting
places we can go explore together.
Do you see how it is made up of lots of
squares? This is called a grid. It will
help you see where I can go.
I love new experiences and have several
maps to collect. Whenever you’re ready
for something new, just grab a new
map!
WE
10
11
5
Power and pair
To get me started I need six AA
batteries, three for me, and three for
my Board.
Flip us upside down and insert the
batteries. Once done, switch us both
ON. I will beep and my Board’s lights
will flash.
12
Next, we need to be paired. Do this
by placing one green block on the first
space of the board and hit Go.
I should move forward. If I don’t, turn us
both off, then try again.
13
6
Programming Cubetto
To write a program, place the blocks in
a sequence on my Board.
Notice how my Queue curves like a
snake? This is the order you must
follow.
Once you’ve written your program, hit
the Go button and watch me head off.
14
15
7
Function Line
Remember the Function Line? It can do
some really cool things.
Let me teach you...
If you want to give the same set of
directions more than once, put that
sequence in the Function Line.
Now you can use the blue block in the
Queue every time you want to recall
that sequence.
This is called a subroutine..
16
17
Now that you know all about me, let’s play!
When you are ready, open Cubetto’s First Day
to learn a little more and see if you’re up to
some challenges!
18
Need help?
Want it in your school? edu@primotoys.com
Want to chat with us? support@primotoys.com
FCC Statement: This device complies with Part 15 of the FCC Rules and Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired operation.
Changed or modifications not expressly approved by the part responsible for compliance could void the user’s authority to
operate equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction, may cause harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different form that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
RSS-Gen & RSS-210 statement:
This device complies with Industry Canada licence-exempt RSS standard(s)
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation of the device.
Le present appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de
l’appareil doit accepter tout brouillage radioélectrique subi, meme si le brouillage est susceptible d’en compromettre le
fonctionnement.
RSS-102 Statement:
This equipment complies with Industry Canada radiation exposure limits set forth for an uncontrolled environment.
Cet équipement est conforme à l’exposition aux rayonnements Industry Canada limites établies pour un environement non
contrôlé.
19
Made with love by Primo Toys
Designed in London, printed in China
2016 © Solid Labs LTD
ALL RIGHTS RESERVED
Primo Toys is a trademark of Solid Labs LTD
primotoys.com

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.3
Linearized                      : No
XMP Toolkit                     : XMP Core 5.4.0
Creator Tool                    : Adobe InDesign CC 2015 (Macintosh)
Metadata Date                   : 2016:06:21 14:49:57+01:00
Create Date                     : 2016:06:21 14:49:56+01:00
Modify Date                     : 2016:06:21 14:49:57+01:00
Format                          : application/pdf
Original Document ID            : xmp.did:FB7F11740720681191098526F92BD1B3
History Software Agent          : Adobe InDesign CC 2015 (Macintosh)
History Parameters              : from application/x-indesign to application/pdf
History Changed                 : /
History When                    : 2016:06:21 14:49:56+01:00
History Action                  : converted
Instance ID                     : uuid:f990ba8f-19b7-8d45-a7b8-4e09cba1ca0d
Document ID                     : xmp.id:fff461f8-4c99-40b2-9244-4b51b4f647bc
Derived From Rendition Class    : default
Derived From Document ID        : xmp.did:701D90B67320681191098526F92BD1B3
Derived From Instance ID        : xmp.iid:589be9ea-6942-460f-82e7-6ac3ff027b00
Derived From Original Document ID: xmp.did:FB7F11740720681191098526F92BD1B3
Rendition Class                 : proof:pdf
Trapped                         : False
Producer                        : Adobe PDF Library 15.0
Page Count                      : 20
Creator                         : Adobe InDesign CC 2015 (Macintosh)

EXIF Metadata provided by EXIF.tools