Sonicwall 083 Access Point 802.11 a/b/g/n User Manual SonicPoint N GSG

Sonicwall, Inc. Access Point 802.11 a/b/g/n SonicPoint N GSG

Contents

User Manual

Safety and Regulatory Information for the SonicWALL SonicPoint Wireless ApplianceMounting the SonicWALL•Mount in a location away from direct sunlight and sources of heat. A maximum ambient temperature of 104º F (40º C) is recommended.•Route cables away from power lines, fluorescent lighting fixtures, and sources of noise such as radios, transmitters, and broadband amplifiers•The included power cord is intended for use in North America only. For European Union (EU) customers, a power cord is not included.• Ensure that no water or excessive moisture can enter the unit.•Allow unrestricted airflow around the unit and through the vents on the side of the unit. A minimum of 1 inch (25.44mm) clearance is recommended.•Consideration must be given to the connection of the equipment to the supply circuit and the effect of over-loading the circuits has minimal impact on overcurrent protection and supply wiring. Appropriate consideration of equipment nameplate ratings must be used when addressing this concern.Cable ConnectionsAll Ethernet and RS232 (Console) cables are designed for intra-building connection to other equipment. Do not connect these ports directly to communication wiring or other wiring that exits the building where the SonicWALL is located. Power Supply InformationIf the power supply is missing from your SonicWALL product package, please contact SonicWALL Technical Support at 408-752-7819 for a replacement. This product should only be used with a UL listed power supply marked “Class 2” or “LPS”, with an output rated 48 VDC, minimum 0.35 A.Regulatory Model/Type Product NamesAPL21-083 SonicPoint-Ni
SonicWALL SonicPoint Wireless Appliance Sicherheit und gesetzliche VorschriftenWeitere Hinweise zur Montage•Wählen Sie für die Montage einen Ort, der keinem direkten Sonnenlicht ausgesetzt ist und sich nicht in der Nähe von Wärmequellen befindet. Die Umgebungstemperatur darf nicht mehr als 40 °C betragen.•Führen Sie die Kabel nicht entlang von Stromleitungen, Leuchtstoffröhren und Störquellen wie Funksendern oder Breitbandverstärkern.•Das beigefügte Netzkabel ist nur für den Betrieb in Nordamerika vergesehen. Für Kunden in der Europäischen Union ist kein Kabel beigefügt.•Stellen Sie sicher, dass das Gerät vor Wasser und hoher Luftfeuchtigkeit geschützt ist.•Stellen Sie sicher, dass die Luft um das Gerät herum zirkulieren kann und die Lüftungsschlitze an der Seite des Gehäuses frei sind. Hier ist ein Belüftungsabstand von mindestens 26 mm einzuhalten.• Vergewissern Sie sich, dass das Gerät sicher im Rack befestigt ist. KabelverbindungenAlle Ethernet- und RS232-C-Kabel eignen sich für die Verbindung von Geräten in Innenräumen. Schließen Sie an die Anschlüsse der SonicWALL keine Kabel an, die aus dem Gebäude herausgeführt werden, in dem sich das Gerät befindet.Informationen zur StromversorgungSollte das Netzteil nicht im Lieferumfang der SonicWALL enthalten sein, wenden Sie sich diesbezüglich an den technischen Support von SonicWALL (Tel.: +1-408-752-7819). Dieses Produkt darf nur in Verbindung mit einem nach den Normen der Underwriter Laboratories, USA als „UL-gelistet“ zugelassenen Netzteil der Kategorie „Class 2“ oder „LPS“ verwendet werden. Ausgang: 48 VDC Gleichsspannung, mind. 0,35 A.
FCC Part 15 Class B Notice for the SonicWALL SonicPoint Wireless ApplianceNOTE: This equipment was tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy. And, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If the equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try and correct the interference using one or more of the following measures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and the receiver.• Connect the equipment into an outlet on a circuit different from the receiver connection.• Consult SonicWALL for assistance.Complies with EN55022 Class B and CISPR22 Class B.*Refer to the label on the bottom of the unit for device information including Class A or Class B FCC information.FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment.For operation within 5.15 ~ 5.25GHz frequency range, it is restricted to indoor environment.FCC and IC RF Radiation Exposure StatementThis equipment complies with FCC and IC RF radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20 centimeters (7.9 inches) between the radiator (antenna) and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. For more information regarding the above statement, please contact SonicWALL, Inc. at:1143 Borregas AvenueSunnyvale, CA, 94089-13061-408-745-9600North American Authorized ChannelsSonicWALL declares that the APL21-083 (FCC ID: QWU-083) (IC: 4408A-083) when sold in US or Canada is limited to CH1~CH11 by specified firmware controlled in the USA.Canadian Radio Frequency Emissions StatementThis Class B digital apparatus complies with Canadian ICES-003.Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.Industry Canada StatementThis device complies with RSS-210 of the Industry Canada Rules. Operation is subject to the following two conditions:FCC and IC(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.Caution:The device for the band 5150-5250 MHz is only for indoor usage to reduce potential for harmful interference to co-channel mobile satellite systems. This device has been designed to operate with an antenna having a maximum gain of 4 dBm. Antenna having a higher gain is strictly prohibited per regulations of Industry Canada. The required antenna impedance is 50 ohms.
This device is a 2.4 GHz wideband transmission system (transceiver), intended for use in all EU member states and EFTA countries, except in France and Italy where restrictive use applies.In Italy the end-user should apply for a license at the national spectrum authorities in order to obtain authorization to use the device for setting up outdoor radio links and/or for supplying public access to telecommunications and/or network services.This device may not be used for setting up outdoor radio links in France and in some areas the RF output power may be limited to 10 mW EIRP in the frequency range of 2454 – 2483.5 MHz. For detailed information the end-user should contact the national spectrum authority in France.Declaration of ConformityCertificate #: EU00170-AI, the undersigned, hereby declare that the equipment specified above conforms to the above Directives and Standards. Quality control procedures will ensure series production of equipment will be compliant.Application of council Directive2004/108/EC (EMC) 2006/95/EC (LVD)1999/5/EC (R&TTE)Standard(s) to which conformity is declaredEN 55022 (1998) +A1 +A2 Class BEN 55024 (1998) +A2 +A2EN 61000-3-2 (2000) +A2EN 61000-3-3 (1995) A2EN 60950-1 (2001) +A11National Deviations: AR, AT, AU, BE, CA, CH, CN, CZ, DE, DK, FI, FR, GB, GR, HU, IL, IN, IT, JP, KE, KR, MY, NL, NO, PL, SE, SG, SI, SK, USEN 300 328-1/-2 (2003)EN 301 893 1.3.1EN 301 893 1.4.1EN50385 : (2002)Manufacturer/Responsible PartySonicWALL, Inc.1143 Borregas AvenueSunnyvale, CA 94089 USAType of Equipment Information Technology EquipmentInternet Security (Firewall/VPN) Appliance, with 802.11b/g/n Wireless Router Tabletop with external power supply. Type Numbers APL21-083May be Marketed as SonicPoint-NiSignature /s/ Larry Wagner__________ Sr. Engineering DirectorDate _TBD_
SonicWALL tímto prohlašuje, že tento APL21-083 je ve shodě se základními požadavky a dalšími příslušnými ustanoveními směrnice 1999/5/ES.Undertegnede SonicWALL erklærer herved, at følgende udstyr APL21-083 overholder de væsentlige krav og øvrige relevante krav i direktiv 1999/5/EF.Hiermit erklärt SonicWALL, dass sich das Gerät APL21-083 in Übereinstimmung mit den grundlegenden Anforderungen und den übrigen einschlägigen Bestimmungen der Richtlinie 1999/5/EG bendet.Käesolevaga kinnitab SonicWALL seadme APL21-083 vastavust direktiivi 1999/5/EÜ põhinõuetele ja nimetatud direktiivist tulenevatele teistele asjakohastele sätetele.Hereby, SonicWALL, declares that this APL21-083 is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC.Por medio de la presente SonicWALL declara que el APL21-083 cumple con los requisitos esenciales y cualesquiera otras disposiciones aplicables o exigibles de la Directiva 1999/5/CE.ΜΕ ΤΗΝ ΠΑΡΟΥΣΑ SonicWALL ΔΗΛΩΝΕΙ ΟΤΙ APL21-083 ΣΥΜΜΟΡΦΩΝΕΤΑΙ ΠΡΟΣ ΤΙΣ ΟΥΣΙΩΔΕΙΣ ΑΠΑΙΤΗΣΕΙΣ ΚΑΙ ΤΙΣ ΛΟΙΠΕΣ ΣΧΕΤΙΚΕΣ ΔΙΑΤΑΞΕΙΣ ΤΗΣ ΟΔΗΓΙΑΣ 1999/5/ΕΚ.Par la présente SonicWALL déclare que l'appareil APL21-083 est conforme aux exigences essentielles et aux autres dispositions pertinentes de la directive 1999/5/CE.Con la presente SonicWALL dichiara che questo APL21-083 è conforme ai requisiti essenziali ed alle altre disposizioni pertinenti stabilite dalla direttiva 1999/5/CE.Ar šo SonicWALL deklarē, ka APL21-083 atbilst Direktīvas 1999/5/EK būtiskajām prasībām un citiem ar to saistītajiem noteikumiem.Šiuo SonicWALL deklaruoja, kad šis APL21-083 atitinka esminius reikalavimus ir kitas 1999/5/EB Direktyvos nuostatas.Hierbij verklaart SonicWALL dat het toestel APL21-083 in overeenstemming is met de essentiële eisen en de andere relevante bepalingen van richtlijn 1999/5/EG.Hawnhekk, SonicWALL, jiddikjara li dan APL21-083 jikkonforma mal-ħtiġijiet essenzjali uma provvedimenti oħrajn relevanti li hemm d-Dirrettiva 1999/5/EC.Alulírott, SonicWALL nyilatkozom, hogy a APL21-083 megfelel a vonatkozó alapvetõ követelményeknek és az 1999/5/EC irányelv egyéb elõírásainak.Niniejszym SonicWALL oświadcza, że APL21-083 jest zgodny z zasadniczymi wymogami oraz pozostałymi stosownymi postanowieniami Dyrektywy 1999/5/EC.SonicWALL declara que este APL21-083 está conforme com os requisitos essenciais e outras disposições da Directiva 1999/5/CE.SonicWALL izjavlja, da je ta APL21-083 v skladu z bistvenimi zahtevami in ostalimi relevantnimi določili direktive 1999/5/ES.SonicWALL týmto vyhlasuje, že APL21-083 spĺňa základné požiadavky a všetky príslušnéustanovenia Smernice 1999/5/ES.SonicWALL vakuuttaa täten että APL21-083 tyyppinen laite on direktiivin 1999/5/EY oleellisten vaatimusten ja sitä koskevien direktiivin muiden ehtojen mukainen.Härmed intygar SonicWALL att denna APL21-083 står I överensstämmelse med de väsentliga egenskapskrav och övriga relevanta bestämmelser som framgår av direktiv 1999/5/EG.

Navigation menu