126760 01K IN

126760-01K In 126760-01K_IN 126760-01K_IN 4219 instructions part uploads sonnax-dev

2015-08-04

: Sonnax 126760-01K In 126760-01K_IN 1951 file instruction uploads

Open the PDF directly: View PDF PDF.
Page Count: 2

Ford 6R140
1. Determine if Vehicle is
Equipped with OE Shield
a. If OE shield is present (Figure 1),
proceed to step 2, "Disassembly".
b. If no OE shield is equipped, skip to
step 3, "Installation & Assembly".
2. Disassembly
a. Position selector lever in "D" position.
b. Disconnect selector lever cable from
manual control lever.
c. Remove and discard OE selector lever
cable retaining clip (Figure 1).
d. Remove selector lever cable from
shield bracket.
e. Detach fuel line bracket and wiring
harness from OE shift selector shield.
f. Remove OE shift selector shield
retaining bolts. Remove shield from
transmission (Figure 1).
Shift Selector
Shield Kit
Part No.
126760-01K
Shift Selector Shield, Upper
Shift Selector Shield, Lower
Shield Bolt M6 x 20mm
• Locknut M6
Retaining Bolts (2) 3/8" x 3/4"
Retaining Clip
NOTE: Fits non-PTO units only.
Shift Selector Shield,
Upper
Retaining
Clip
Shield
Bolt
Locknut
Retaining Bolts
Figure 1
Shift Selector Shield,
Lower
OE Selector Lever
Cable Retaining Clip
OE
Retaining
Bolts
OE Shield installed on
Ford 6R140 case.
©2015 Sonnax Industries, Inc. 126760-01K-IN 07-28-15
800-843-2600 • 802-463-9722 • F: 802-463-4059 • www.sonnax.com Page 1
TRANSMISSION PARTS
Instructions
3. Installation & Assembly
a. Ensure selector lever is in "D" position.
b. Assemble both pieces of Sonnax shield together using supplied
shield bolt and locknut (Figure 2).
c. Install Sonnax shift selector shield and secure with supplied Sonnax
retaining bolts (Figure 3). Tighten to 48 Nm (35 ft-lbs).
d. Attach fuel line bracket and wiring harness to shift selector shield.
e. Move selector lever into "Low" position, then move it three (3)
detents rearward.
f. Install the selector lever cable into shield bracket and secure with
Sonnax retaining clip (Figure 3). Ensure the selector lever cable lock-
ing tabs are locked in place.
g. Connect selector lever cable to manual control lever.
h. Slide the adjuster tab in place to lock the selector lever cable.
i. Ensure manual lever travels freely through full range.
Figure 2
Shift Selector
Shield, Upper
Shield Bolt
& Locknut
Set
Shift Selector
Shield, Lower
Sonnax shift selector shield kit installed
on Ford 6R140 case.
Figure 3
Retaining
Clip Retaining
Bolts
©2015 Sonnax Industries, Inc. 126760-01K-IN 07-28-15
800-843-2600 • 802-463-9722 • F: 802-463-4059 • www.sonnax.com Page 2
TRANSMISSION PARTS
Instructions
SHIFT SELECTOR SHIELD KIT 126760-01K

Navigation menu