Sony Group BTLS1 Bluetooth Module User Manual Short Term Confidential

Download:
Mirror Download [FCC.gov]
Document ID	2801792
Application ID	kuAlFFxxxTBhh/woozT0vQ==
Document Description	(Short-Term Confidential) User Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	6.13kB (76595 bits)
Date Submitted	2015-11-04 00:00:00
Date Available	2016-05-03 00:00:00
Creation Date	2015-10-22 19:08:01
Producing Software	Adobe PDF Library 11.0
Document Lastmod	2015-10-27 21:20:30
Document Title	(Short-Term Confidential) User Manual
Document Author:	Kamimura, Hidekazu

Since this module is not sold to general end users directly, there is no user manual of
module.
For the details about this module, please refer to the specification sheet of module.
This module should be installed in the host device according to the interface
specification (installation procedure).
2.
2.1.
Regulatory information described in the manual of the end product
FCC
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
FCC CAUTION
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
This transmitter must not be co-located or operated in conjunction with any other
antenna or transmitter.
Confidential
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment and meets the FCC radio frequency (RF) Exposure
Guidelines. This equipment has very low levels of RF energy that is deemed to
comply without maximum permissive exposure evaluation (MPE).
2.2.
IC
This device complies with Industry Canada’s licence-exempt RSSs. Operation is
subject to the following two conditions: (1) This device may not cause interference;
and (2) This device must accept any interference, including interference that may
cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux
appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions
suivantes : 1) l’appareil ne doit pas produire de brouillage; 2) l’utilisateur de l’appareil
doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.
This equipment complies with IC radiation exposure limits set forth for an
uncontrolled environment and meets RSS-102 of the IC radio frequency (RF)
Exposure rules. This equipment has very low levels of RF energy that is deemed to
comply without maximum permissive exposure evaluation (MPE).
Cet équipement est conforme aux limites d’exposition aux rayonnements énoncées
pour un environnement non contrôlé et respecte les règles d’exposition aux
fréquences radioélectriques (RF) CNR-102 de l’IC. Cet équipement émet une
énergie RF très faible qui est considérée comme conforme sans évaluation de
l’exposition maximale autorisée (MPE).
3.
3.1.
Labelling
FCC
FCC ID is printed on BT-LSP1 module as below.
FCC ID: AK8BTLS1
If FCC ID on BT-LSP1 is not visible from outside of the end product, the product shall
be labelled outside of it as below.
Contains FCC ID: AK8BTLS1
3.2.
IC
IC number is printed on BT-LSP1 module as below.
Confidential
IC: 409B-BTLS1
If IC number on BT-LSP1 is not visible from outside of the end product, the product
shall be labelled outside of it as below.
Contains IC: 409B-BTLS1
Confidential

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.6
Linearized                      : No
Author                          : Kamimura, Hidekazu
Create Date                     : 2015:10:22 19:08:01+09:00
Modify Date                     : 2015:10:27 21:20:30+09:00
Has XFA                         : No
Tagged PDF                      : Yes
XMP Toolkit                     : Adobe XMP Core 5.2-c001 63.139439, 2010/09/27-13:37:26
Metadata Date                   : 2015:10:27 21:20:30+09:00
Creator Tool                    : Word 用 Acrobat PDFMaker 11
Document ID                     : uuid:7998e8ed-232a-4e91-8d20-a82a6265632b
Instance ID                     : uuid:c5c98e9a-1023-415e-a40f-63f82204a6a3
Subject                         : 6
Format                          : application/pdf
Creator                         : Kamimura, Hidekazu
Producer                        : Adobe PDF Library 11.0
Source Modified                 : D:20151022100754
Company                         : Sony
Page Layout                     : OneColumn
Page Count                      : 3

EXIF Metadata provided by EXIF.tools