Sony Group IRF303J Wireless LAN Card User Manual Installation Manual Continued
Sony Corporation Wireless LAN Card Installation Manual Continued
Contents
- 1. Installation Manual
- 2. Installation Manual Continued
Installation Manual Continued
IRF303J 2.4GHz Band Wireless LAN Transceiver Unit PRELIMINALY General Description IRF303J, Wireless LAN module, is compliant with 802.11b/g standard. IRF303J is designed for AV transmission, and it’s high performance enable 54Mbps high-bit data rate communication. Feature - Support QoS - Hardware-Based MAC Access Protocol - Low packet error rate Specifications - Host Interface - Standard - Radio Signal Type : Mini PCI Standard 1.0 : IEEE802.11b/g compliant : Direct Sequence Spread Spectrum (DSSS) Orthogonal Frequency Division Multiplexing (OFDM) - Wireless Data Rate : 802.11b=1/2/5.5/11Mbps 802.11g=6/9/12/18/24/36/48/54Mbps - Frequency Band : 2400-2483.5MHz - Channel Support : ch1-ch11 - Data Modulation Techniques : BPSK (1Mbps), QPSK (2Mbps), CCK (5.5/11Mbps) OFDM (6/9/12/18/24/36/48/54Mbps) - Operating Range : 660ft (Outdoor, Line of sight) 100ft (Indoor) - Media Access Protocol : Ad-Hoc (Peer-to-Peer) Infrastructure - Security : WEP (Key Length 40/128/256bit) / AES / WPA (PSK) - Power Voltage : 3.3V (+/- 5%) - Dimensions : 90.0 x 32.0 x 4.6mm - Weight : Approx.12g - Operating Temperature Range : -0C to +50C Sony reserves the right to change products and specifications without prior notice. This information does not convey any license by any implication or otherwise under any patents or other right. Application circuits shown, if any, are typical examples illustrating the operation of the devices. Sony cannot assume responsibility for any problems arising out of the use of these circuits. -1- IRF303J NOTIFICATION This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference with radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the use is encouraged to try to correct the interference by one or more of the following measures: Reoriented or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that t which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. FCC WARNIG Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. For customers in the United States This product contains mercury. Disposal of this product may be regulated if sold in the United States. For disposal or recycling information, please contact your local authorities or the Electronics Industries Alliance (http://eiae.org). This device complies with Part 15 of the FCC Rules. Operation is subjected to the following two conditions: (1)This device may not cause harmful interference, and (2)This device must accept any interference received, including interference that may cause undesired operation *This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. FCC Radiation Exposure Statement: For portable equipment: The available scientific evidence does not show that any health problems are associated with using low power wireless devices. There is no proof, however, that these low power wireless devices are absolutely safe. Low power Wireless devices emit low levels of radio frequency energy (RF) in the microwave range while being used. Whereas high levels of RF can produce health effects (by heating tissue), exposure to low level RF that does not produce heating effects causes no known adverse health effects. Many studies of low level RF exposures have not found any biological effects. Some studies have suggested that some biological effects might occur, but such findings have not been confirmed by additional research. IRF303J has been tested and found to comply with the Federal Communications Commission (FCC) guidelines on radio frequency energy (RF) exposures. The maximum SAR levels tested for IRF303J has been show to be 0.533 W/kg at Body. For mobile equipment: This equipment complies with FCC radiation exposure limits set forth for uncontrolled equipment and meets the FCC radio frequency (RF) Exposure Guidelines in Supplement C to OET65. This equipment should be installed and operated with at least 20cm and more between the radiator and person’s body (excluding extremities: hands, wrists, feet and legs). -2- IRF303J Electrical Characteristics Vdd=3.3V, Ta=25C Parameter Output power Supply current Center Frequency Tolerance Modulation Accuracy(64QAM) Sensitivity Symbol Pout2 Iddtx2 Iddrx ftol EVM2 Rx_Sens2 54Mbps Tx Rx 54Mbps 54Mbps -3- Min -10 Typ 17 730 390 4.3 -71 Max 400 +10 Units dBm mA mA ppm dBm IRF303J Antenna - Model Name - Type - Gain (Peak) - Connector Type : HFT18 : Film Antenna : 2.4GHz_Band : +1.9dBi(Typ) : U.FL Unit:mm -4- IRF303J Dimension 3.6 5.5 90.0 4.1 16.8 0.6 1.0 32.0 -5-
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.3 Linearized : No Modify Date : 2005:02:02 20:23:05+09:00 Create Date : 2005:02:02 20:22:44+09:00 Page Count : 5 Creation Date : 2005:02:02 11:22:44Z Mod Date : 2005:02:02 11:22:44Z Producer : Acrobat Distiller 5.0.5 (Windows) Author : cjp02280 Metadata Date : 2005:02:02 11:22:44Z Creator : cjp02280 Title : ½×²ÄÞ À²ÄÙ‚È‚µ Page Mode : UseNone Page Layout : SinglePage Tagged PDF : YesEXIF Metadata provided by EXIF.tools