Sony Group IRF303U 2.4GHz/5GHz Band Wireless LAN Transceiver User Manual Manual revised
Sony Corporation 2.4GHz/5GHz Band Wireless LAN Transceiver Manual revised
Contents
Manual revised
IRF303U 2.4GHz/5GHz Band Wireless LAN Transceiver Unit PRELIMINALY General Description IRF303U, Dual band triple mode Wireless LAN module, is compliant with 802.11a/b/g standard. IRF303U is designed for AV transmission, and it’s high performance enable 54Mbps high-bit data rate communication. Feature - Support QoS - Hardware-Based MAC Access Protocol - Low packet error rate Specifications - Host Interface - Standard - Radio Signal Type : Mini PCI Standard 1.0 : IEEE802.11a/b/g compliant : Direct Sequence Spread Spectrum (DSSS) Orthogonal Frequency Division Multiplexing (OFDM) - Wireless Data Rate : 802.11b=1/2/5.5/11Mbps 802.11g/a=6/9/12/18/24/36/48/54Mbps - Frequency Band : 2400-2483.5MHz / 5150-5350MHz / 5725-5825MHz - Channel Support : ch1-ch11 / ch34-ch64ch / ch149-ch161 - Data Modulation Techniques : BPSK (1Mbps), QPSK (2Mbps), CCK (5.5/11Mbps) OFDM (6/9/12/18/24/36/48/54Mbps) - Operating Range : 660ft (Outdoor, Line of sight) 100ft (Indoor) - Media Access Protocol : Ad-Hoc (Peer-to-Peer) Infrastructure - Security : WEP (Key Length 40/128/256bit) / AES / WPA (PSK) - Power Voltage : 3.3V (+/- 5%) - Dimensions : 90.0 x 32.0 x 4.6mm - Weight : Approx.12g - Operating Temperature Range : -0C to +50C Sony reserves the right to change products and specifications without prior notice. This information does not convey any license by any implication or otherwise under any patents or other right. Application circuits shown, if any, are typical examples illustrating the operation of the devices. Sony cannot assume responsibility for any problems arising out of the use of these circuits. -1- IRF303U NOTIFICATION This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference with radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the use is encouraged to try to correct the interference by one or more of the following measures: Reoriented or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that t which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. FCC WARNIG Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. For customers in the United States This product contains mercury. Disposal of this product may be regulated if sold in the United States. For disposal or recycling information, please contact your local authorities or the Electronics Industries Alliance (http://eiae.org). This device complies with Part 15 of the FCC Rules. Operation is subjected to the following two conditions: (1)This device may not cause harmful interference, and (2)This device must accept any interference received, including interference that may cause undesired operation *This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. *When using the unit with 802.11a (5GHz), use in doors. FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for at uncontrolled equipment. This equipment should be installed and operated with minimum distance at least 20cm between the radiator and persons body (excluding extremities: hands, wrist, feet and legs) and must not be co-located or operated with any other antenna or transmitter. -2- IRF303U Electrical Characteristics Vdd=3.3V, Ta=25C Parameter Output power 2.4GHz (54Mbps) 5GHz (54Mbps) Supply current Tx 2.4GHz 5GHz Rx Center Frequency Tolerance Modulation Accuracy 2.4GHz (54Mbps) (64QAM) 5GHz (54Mbps) Sensitivity 2.4GHz (54Mbps) 5GHz (54Mbps) Packet Error Rate 2.4GHz (54Mbps) (-65dBm input) 5GHz (54Mbps) Symbol Pout2 Pout5 Iddtx2 Iddtx5 Iddrx ftol EVM2 EVM5 Rx_Sens2 Rx_Sens5 PER2 PER5 -3- Min -10 Typ 20 18 650 760 370 4.3 5.0 -71 -70 Max 400 +10 Units dBm dBm mA mA mA ppm dBm dBm IRF303U Antenna Antenna1 - Model Name - Type - Gain (Peak) - Connector Type : EA5800 : Chip Antenna : 2.4GHz_Band : +3.5dBi(Typ) 5GHz_Band : +3.5dBi(Typ) : U.FL 13.0 14.0 16.5 10.0 35.0 Unit:mm Antenna2 - Model Name - Type - Gain (Peak) - Connector Type : HFT18 : Film Antenna : 2.4GHz_Band : +1.0dBi(Typ) 5GHz_Band : +1.9dBi(Typ) : U.FL Unit:mm -4- IRF303U Dimension 3.6 5.5 90.0 4.1 16.8 0.6 1.0 32.0 -5-
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.3 Linearized : No Modify Date : 2004:06:30 18:50:47+09:00 Create Date : 2004:06:30 18:50:38+09:00 Page Count : 5 Creation Date : 2004:06:30 09:50:38Z Mod Date : 2004:06:30 09:50:38Z Producer : Acrobat Distiller 5.0.5 (Windows) Author : cjp02280 Metadata Date : 2004:06:30 09:50:38Z Creator : cjp02280 Title : ½×²ÄÞ À²ÄÙ‚È‚µ Page Mode : UseNone Page Layout : SinglePage Tagged PDF : YesEXIF Metadata provided by EXIF.tools