Sony Group LSPXA1R REMOTE COMMANDER User Manual 000COV indb
Sony Corporation REMOTE COMMANDER 000COV indb
Contents
- 1. 06 SHORT-TERM CONFIDENTIAL_User Manual-1
- 2. 06 SHORT-TERM CONFIDENTIAL_User Manual-2
06 SHORT-TERM CONFIDENTIAL_User Manual-2
WARNING To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture. To avoid electrical shock, do not open the cabinet. Refer servicing to qualified personnel only. WARNING THIS APPARATUS MUST BE EARTHED. CAUTION Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the manufacturer. When you dispose of the battery, you must obey the law in the relative area or country. Caution Two size AAA (R03) batteries are required for Remote Control. To avoid risk of explosion, use size AAA (R03) manganese or alkaline batteries. For the customers in the U.S.A. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are GB designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off WARNING and on, the user is encouraged to try to correct the When installing the unit, incorporate a readily accessible interference by one or more of the following measures: disconnect device in the fixed wiring, or connect the –– Reorient or relocate the receiving antenna. power plug to an easily accessible socket-outlet near –– Increase the separation between the equipment and the unit. If a fault should occur during operation of the unit, operate the disconnect device to switch the power supply off, or disconnect the power plug. CAUTION About the LAN connector For safety, do not connect the connector for peripheral device wiring that might have excessive voltage to this port. WARNING 1. Use the approved Power Cord (3-core mains lead) / Appliance Connector / Plug with earthing-contacts that conforms to the safety regulations of each country if applicable. 2. Use the Power Cord (3-core mains lead) / Appliance Connector / Plug conforming to the proper ratings (Voltage, Ampere). If you have questions on the use of the above Power Cord / Appliance Connector / Plug, please consult a qualified service personnel. receiver. –– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. –– Consult the dealer or an experienced radio/TV technician for help. You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. All interface cables used to connect peripherals must be shielded in order to comply with the limits for a digital device pursuant to Subpart B of part 15 of FCC Rules. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. If you have any questions about this product, you may call; Sony Customer Information Service Center 1-800-222-7669 or http://www.sony.com/ 3GB Sony LSPX-A1 4-732-088-11(1) Declaration of Conformity Trade Name: SONY Model: LSPX-A1 Responsible party: Sony Electronics Inc. Address: 16535 Via Esprillo, San Diego, CA 92127 U.S.A. Telephone Number: 858-942-2230 For the customers the U.S.A. and Canada CAUTION Use of controls or adjustments or performance of procedures other than those specified herein may Ca pr result in hazardous radiation exposure. This product is classified as a CLASS 2 LASER PRODUCT. Only This device complies with part 15 of the FCC Rules. perso Operation is subject to the following two conditions: at the (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. For the customers the U.S.A. and Canada Radiated Exposure Statement: This equipment complies with FCC/IC radiation WARNING LASER RADIATION DO NOT STARE INTO BEAM CLASS 2 LASER PRODUCT CAUTION Do not look into the lens while in use. exposure limits set forth for an uncontrolled CAUTION environment and meets the FCC radio frequency (RF) Do not allow children to operate this product without Exposure Guidelines and RSS-102 of the IC radio supervision. frequency (RF) Exposure rules. This equipment has very low levels of RF energy that is deemed to comply without maximum permissive exposure evaluation (MPE). For the customers in Canada • The –– The use of optical instruments with this product will increase eye hazard. For the customers in other countries IEC 60825-1:2014 CLASS 1 LASER PRODUCT conditions: As with any bright light source, do not stare into the beam, RG2 IEC 62471-5:2015. (2) This device must accept any interference, including interference that may cause undesired operation of the device. CAUTION Use of controls or adjustments or performance of procedures other than those specified herein may When you connect the LAN cable of the unit to peripheral device, use a shielded-type cable to prevent malfunction due to radiation noise. result in hazardous radiation exposure. CAUTION Do not look into the lens while in use. CAUTION The use of optical instruments with this product will increase eye hazard. 4GB Sony LSPX-A1 4-732-088-11(1) –– • Do • Use the mo (1) This device may not cause interference; and CAUTION –– it. I exempt RSSs. Operation is subject to the following two CAN ICES-3 (B)/NMB-3(B) avo • It m pro CAUTION This device complies with Industry Canada’s licence- For the customers in Canada Note
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.3 Linearized : No Has XFA : No XMP Toolkit : Adobe XMP Core 5.2-c001 63.139439, 2010/09/27-13:37:26 Create Date : 2017:11:24 15:13:41+09:00 Metadata Date : 2018:01:19 13:39:38+09:00 Modify Date : 2018:01:19 13:39:38+09:00 Creator Tool : Adobe InDesign CC 2014 (Windows) Instance ID : uuid:e85a2e88-84f1-4690-91e9-35a556b11362 Original Document ID : xmp.did:88542315DA76E1118E89BF5966DF4709 Document ID : xmp.id:fc6deb77-5d3a-2448-b4e4-6a2bbb556f82 Rendition Class : proof:pdf Version ID : 1 Derived From Instance ID : xmp.iid:3bb2f5f9-c252-9b42-ba0f-3541d05d98cc Derived From Document ID : xmp.did:02663bbf-15bc-9445-89e6-c8993be09477 Derived From Original Document ID: xmp.did:88542315DA76E1118E89BF5966DF4709 Derived From Rendition Class : default History Action : converted History Parameters : from application/x-indesign to application/pdf History Software Agent : Adobe InDesign CC 2014 (Windows) History Changed : / History When : 2017:11:24 15:13:41+09:00 Format : application/pdf Title : 000COV.indb Producer : Adobe PDF Library 11.0 Trapped : False GTS PDFX Version : PDF/X-1:2001 GTS PDFX Conformance : PDF/X-1a:2001 Page Count : 2 Creator : Adobe InDesign CC 2014 (Windows)EXIF Metadata provided by EXIF.tools