Sony Group MEXN4100BT Bluetooth Audio System User Manual

Sony Corporation Bluetooth Audio System MEX N5100BT MEX N4100BT

a href="https://usermanual.wiki/Sony-Group" itemprop="url"> Sony Group >

Contents

(Short-Term Confidential) User Manual- I

MEX-N5100BT/MEX-N4100BTF:\0918\4548379111\4548379111MEXN5100BTUC\01GB-MEXN5100BTUC\010COV.fm masterpage: Cover4-548-379-11(1)MEX-N5100BT/MEX-N4100BT4-548-379-11(1)Bluetooth® Audio SystemOwner’s RecordThe model and serial numbers are located on the bottom of the unit.Record these numbers in the spaces provided below.Refer to these numbers whenever you call upon your Sony dealer regarding this product.Model No. Serial No.                                       Operating Instructions GBMode d’emploi FRFor the connection/installation, see page 31.Pour le raccordement/l’installation, reportez-vous à la page 34.To cancel the demonstration (DEMO) display, see page 18.Pour annuler l’affichage de démonstration (DEMO), reportez-vous à la page 20.010COV.book  Page 1  Thursday, September 18, 2014  10:49 AM
2GBF:\0918\4548379111\4548379111MEXN5100BTUC\01GB-MEXN5100BTUC\020INT.fm masterpage: LeftMEX-N5100BT/MEX-N4100BT4-548-379-11(1)The nameplate indicating operating voltage, etc., is located on the bottom of the chassis.WarningThis device complies with Part 15 of the FCC Rules and Industry Canada licence-exempt RSS standard(s).Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation of the device.This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication.This equipment complies with FCC/IC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines and RSS-102 of the IC radio frequency (RF) Exposure rules. This equipment has very low levels of RF energy that it deemed to comply without maximum permissive exposure evaluation (MPE). But it is desirable that it should be installed and operated keeping the radiator at least 20 cm or more away from person’s body.CAUTIONThe use of optical instruments with this product will increase eye hazard.For the State of California, USA onlyPerchlorate Material – special handling may apply, Seewww.dtsc.ca.gov/hazardouswaste/perchlorateNote on the lithium batteryDo not expose the battery to excessive heat such as direct sunlight, fire or the like.For safety, be sure to install this unit in the dashboard of the car as the rear side of the unit becomes hot during use.For details, see “Connection/Installation” (page 31).FOR THE CUSTOMERS IN THE USA. NOT APPLICABLE IN CANADA, INCLUDING IN THE PROVINCE OF QUEBEC.POUR LES CLIENTS AUX ÉTATS-UNIS. NON APPLICABLE AU CANADA, Y COMPRIS LA PROVINCE DE QUÉBEC.This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:Reorient or relocate the receiving antenna.Increase the separation between the equipment and receiver.Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.Consult the dealer or an experienced radio/TV technician for help.You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment.Warning if your car’s ignition has no ACC positionBe sure to set the AUTO OFF function (page 19). The unit will shut off completely and automatically in the set time after the unit is turned off, which prevents battery drain. If you do not set the AUTO OFF function, press and hold OFF until the display disappears each time you turn the ignition off.010COV.book  Page 2  Thursday, September 18, 2014  10:49 AM
Download:
Mirror Download [FCC.gov]
Document ID2434702
Application IDGG4qEoSZUW7H2lhSYjpuow==
Document Description(Short-Term Confidential) User Manual- I
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize313.19kB (3914877 bits)
Date Submitted2014-11-04 00:00:00
Date Available2015-01-03 00:00:00
Creation Date2014-09-18 10:50:02
Producing SoftwareAcrobat Distiller 10.1.10 (Windows)
Document Lastmod2014-10-20 11:10:00
Document TitleMEX-N5100BT/MEX-N4100BT
Document CreatorPScript5.dll Version 5.2.2
Document Author: Sony Corporation
FCC ID Filing: AK8MEXN4100BT

Navigation menu