Sony PM-0400 GSM/UMTS Mobile Phone with WLAN, BT, RFID User Manual User Guide Leaflet

Sony Mobile Communications Inc GSM/UMTS Mobile Phone with WLAN, BT, RFID User Guide Leaflet

Contents

User Guide Leaflet

145
Mobile Phone GSM/GPRS/EDGE 850/900/1800/1900&UMTS/HSPA
Bands1/2/5&LTE Bands1/11/18
United States
THIS PHONE MODEL HAS BEEN CERTIFIED IN COMPLIANCE
WITH THE GOVERNMENT'S REQUIREMENTS FOR EXPOSURE TO
RADIO WAVES.
The SOL22 Series mobile phones have been designed to comply with
applicable safety requirements for exposure to radio waves. Your
wireless phone is a radio transmitter and receiver. It is designed to not
exceed the limits* of exposure to radio frequency (RF) energy set by
governmental authorities. These limits establish permitted levels of RF
energy for the general population. The guidelines are based on
standards that were developed by international scientific organizations
through periodic and thorough evaluation of scientific studies. The
standards include a safety margin designed to assure the safety of all
individuals, regardless of age and health.
The radio wave exposure guidelines employ a unit of measurement
known as the Specific Absorption Rate (SAR). Tests for SAR are
conducted using standardized methods with the phone transmitting at
its highest certified power level in all used frequency bands. While
there may be differences between the SAR levels of various phone
models, they are all designed to meet the relevant guidelines for
exposure to radio waves. For more information on SAR, please refer to
the important information chapter in the User Guide.
The highest SAR value as reported to the authorities for this phone
model when tested for use by the ear is 0.97 W/kg*, and when worn on
the body is 1.47 W/kg* . For body-worn operation, the phone has been
tested when positioned a minimum of 15 mm from the body without
any metal parts in the vicinity of the phone or when properly used with
an appropriate accessory and worn on the body. For devices which
include "WiFi hotspot" functionality, SAR measurements for the device
operating in WiFi hotspot mode were taken using a separation distance
of 10mm. Use of third-party accessories may result in different SAR
levels than those reported.
** Before a phone model is available for sale to the public in the US, it
must be tested and certified by the Federal Communications
Commission (FCC) that it does not exceed the limit established by
the government-adopted requirement for safe exposure*. The tests
are performed in positions and locations (i.e., by the ear and worn on
the body) as required by the FCC for each model. The FCC has
granted an Equipment Authorization for this phone model with all
reported SAR levels evaluated as in compliance with the FCC RF
exposure guidelines. While there may be differences between the
SAR levels of various phones, all mobile phones granted an FCC
equipment authorization meet the government requirement for safe
exposure. SAR information on this phone model is on file at the FCC
and can be found under the Display Grant section of http://
www.fcc.gov/oet/fccid after searching on FCC ID PY7PM-0400.
Additional information on SAR can be found on the Cellular
Telecommunications & Internet Association (CTIA) website at http://
www.ctia.org/.
* In the United States, the SAR limit for mobile phones used by the
public is 1.6 watts/kilogram (W/kg) averaged over one gram of
tissue. The standard incorporates a margin of safety to give
additional protection for the public and to account for any variations
in measurements.
** This paragraph is only applicable to authorities and customers in the
United States.
Europe
This mobile phone model SOL22 has been designed to comply with
applicable safety requirements for exposure to radio waves. These
requirements are based on scientific guidelines that include safety
margins designed to assure the safety of all persons, regardless of age
and health.
The radio wave exposure guidelines employ a unit of measurement
known as the Specific Absorption Rate, or SAR. Tests for SAR are
conducted using standardized methods with the phone transmitting at
its highest certified power level in all used frequency bands.
While there may be differences between the SAR levels of various
phone models, they are all designed to meet the relevant guidelines for
exposure to radio waves.
For more information on SAR, please refer to the safety chapter in the
User's Guide.
SAR data information for residents in countries that have adopted the
SAR limit recommended by the International Commission of Non-
lonizing Radiation Protection (ICNIRP), which is 2 W/kg averaged over
ten (10) gram of tissue (for example European Union, Japan, Brazil
and New Zealand):
The highest SAR value for this model phone tested by Sony Mobile
Communications AB for use at the ear is 0.66 W/kg (10g).
Radio Wave Exposure and Specific
Absorption Rate (SAR) Information
L019.fm Page 145 Thursday, April 25, 2013 5:12 PM
146
This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
Any change or modification not expressly approved by Sony Mobile
Communications AB may void the user's authority to operate the
equipment.
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
We, Sony Mobile Communications AB of
Nya Vattentornet
SE-221 88 Lund, Sweden
declare under our sole responsibility that our product
Sony type PM-0400-BV
and in combination with our accessories, to which this declaration
relates is in conformity with the appropriate standards
EN 301 511:V9.0.2, EN 301 908-1:V5.2.1, EN 301 908-2:V5.2.1, EN
300 328:V1.7.1, EN 300 440-2:V1.4.1, EN 301 489-3:V1.4.1, EN 301
489-7:V1.3.1, EN 301 489-17:V2.1.1, EN 301 489-24:V1.5.1, EN 301
893:V1.6.1, EN 302 291-2:V1.1.1, EN 62 209-1:2006, EN 301 908-
13:V5.2.1 and EN 60 950-1:2006+A11:2009+A1:2010+A12:2011
following the provisions of, Radio Equipment and Telecommunication
Terminal Equipment directive 1999/5/EC.
Lund, April 2013
Pär Thuresson,
Quality Officer, SVP, Quality & Customer Services
われわれはR&TTE指令の要求事項を満たしています(1999/5/EC)
We fulfill the requirements of the R&TTE Directive (1999/5/EC)
FCC Statement for the USA Declaration of Conformity
Signature
L019.fm Page 146 Thursday, April 25, 2013 5:12 PM

Navigation menu