Sony PM-0745 GSM/UMTS/LTE Mobile Phone with WLAN, BT, RFID, ANT+ User Manual Sirius Samba SAR FCC IC leaflet 01222014
Sony Mobile Communications Inc GSM/UMTS/LTE Mobile Phone with WLAN, BT, RFID, ANT+ Sirius Samba SAR FCC IC leaflet 01222014
Sony >
Contents
- 1. User Manual
- 2. Safety Leaflet
Safety Leaflet
SAR Information FCC Statement Declaration of Conformity Sony '5503 ' UMTS HSPA Band 1 2 4 5 8 GSM GPRS/EDGE 850/900/1800/1900 LTE Band 1 2 3 4 5 7 8 20 Important Information United States & Canada THIS PHONE MODEL HAS BEEN CERTIFIED IN COMPLIANCE WITH THE GOVERNMENTâS REQUIREMENTS FOR EXPOSURE TO RADIO WAVES. The '5503 Series mobile phones have been designed to comply with applicable safety requirements for exposure to radio waves. Your wireless phone is a radio transmitter and receiver. It is designed to not exceed the limits* of exposure to radio frequency (RF) energy set by governmental authorities. These limits establish permitted levels of RF energy for the general population. The guidelines are based on standards that were developed by international scientific organizations through periodic and thorough evaluation of scientific studies. The standards include a safety margin designed to assure the safety of all individuals, regardless of age and health. The radio wave exposure guidelines employ a unit of measurement known as the Specific Absorption Rate (SAR). Tests for SAR are conducted using standardized methods with the phone transmitting at its highest certified power level in all used frequency bands. While there may be differences between the SAR levels of various phone models, they are all designed to meet the relevant guidelines for exposure to radio waves. For more information on SAR, please refer to the Important Information chapter in the User Guide. The highest SAR value as reported to the authorities for this W/kg*, :NJ phone model when tested for use by the ear is . 0.87 W/k W/kg*. :NgJ* For body-worn and when worn on the body is . operation, the phone has been tested when positioned a minimum of 15 mm from the body without any metal parts in the vicinity of the phone or when properly used with an appropriate accessory and worn on the body. For devices which include âWiFi hotspotâ functionality, SAR measurements for the device operating in WiFi hotspot mode were taken using a separation distance of 10 mm. Use of third-party accessories may result in different SAR levels than those reported. **Before a phone model is available for sale to the public in the US, it must be tested and certified by the Federal Communications Commission (FCC) that it does not exceed the limit established by the government-adopted requirement for safe exposure*. The tests are performed in positions and locations (i.e., by the ear and worn on the body) as required by the FCC for each model. The FCC has granted an Equipment Authorization for this phone model with all reported SAR levels evaluated as in compliance with the FCC RF exposure guidelines. While there may be differences between the SAR levels of various phones, all mobile phones granted an FCC equipment authorization meet the government requirement for safe exposure. SAR information on this phone model is on file at the FCC and can be found under the Display Grant section of http://transition.fcc.gov/oet/ea/fccid after searching on FCC ID ,' PY7PM-0640. 3<30 Additional information on SAR can be found on the Mobile Manufacturers Forum EMF website at http://www.emfexplained.info/. * In the United States and Canada, the SAR limit for mobile phones used by the public is 1.6 watts/kilogram (W/kg) averaged over one gram of tissue. The standard incorporates a margin of safety to give additional protection for the public and to account for any variations in measurements. **This paragraph is only applicable to authorities and customers in the United States. Renseignements importants Ătats-Unis et Canada CE MODĂLE DE TĂLĂPHONE A ĂTĂ CERTIFIĂ CONFORME AUX EXIGENCES GOUVERNEMENTALES RELATIVES Ă L'EXPOSITION AUX ONDES RADIOĂLECTRIQUES. Les tĂŠlĂŠphones mobiles de la '5503 ont ĂŠtĂŠ conçus pour rĂŠpondre aux normes de sĂŠcuritĂŠ en vigueur en matière d'exposition aux ondes radioĂŠlectriques. Votre tĂŠlĂŠphone sans fil est un ĂŠmetteur et un rĂŠcepteur radio. Il est conçu de manière Ă ne pas dĂŠpasser les limites* d'exposition Ă l'ĂŠnergie des frĂŠquences radio (RF) ĂŠtablies par les autoritĂŠs gouvernementales. Ces limites fixent les niveaux maximaux d'ĂŠnergie RF auxquels peut ĂŞtre soumis le grand public. Ces lignes directrices sont basĂŠes sur des normes qui ont ĂŠtĂŠ ĂŠlaborĂŠes par des organisations scientifiques internationales par le biais d'ĂŠvaluations pĂŠriodiques et approfondies des ĂŠtudes scientifiques. Ces normes prĂŠvoient une marge de sĂŠcuritĂŠ visant Ă assurer la protection de tous les individus, peu importe leur âge et leur ĂŠtat de santĂŠ. Les lignes directrices relatives Ă l'exposition aux ondes radioĂŠlectriques utilisent une unitĂŠ de mesure appelĂŠe ÂŤ Taux d'absorption spĂŠcifique Âť (TAS). Les tests de TAS sont effectuĂŠs selon des mĂŠthodes standardisĂŠes dans lesquelles le tĂŠlĂŠphone ĂŠmet dans toutes les bandes de frĂŠquences utilisĂŠes, Ă la plus forte puissance pour laquelle il a ĂŠtĂŠ homologuĂŠ. Bien que le TAS puisse ĂŞtre diffĂŠrent d'un modèle de tĂŠlĂŠphone Ă un autre, tous les appareils sont conçus pour respecter les lignes directrices relatives aux ondes radioĂŠlectriques. Pour en savoir plus sur le DAS, reportez-vous au chapitre sur les renseignements importants du guide de l'utilisateur. Le DAS le plus ĂŠlevĂŠ relevĂŠ par les autoritĂŠs pour ce modèle W/kg* :NJ lorsqu'il est testĂŠ en utilisation de tĂŠlĂŠphone est de . près de l'oreille, et de . W/kg* lorsqu'il est portĂŠ sur le :NJ corps. En mode dâutilisation portĂŠ sur le corps, le tĂŠlĂŠphone a ĂŠtĂŠ testĂŠ lorsquâil est Ă au moins 15 mm du corps et Ă lâĂŠcart de toute pièce en mĂŠtal, ou lorsquâil est utilisĂŠ de façon adĂŠquate avec un accessoire et portĂŠ sur le corps. Pour les appareils munis de la fonctionnalitĂŠ ÂŤ point d'accès WiFi Âť, les mesures du DAS de l'appareil en mode WiFi ont ĂŠtĂŠ prises Ă une distance de sĂŠcuritĂŠ de 10 mm. L'utilisation d'accessoires tiers peut produire des niveaux de DAS diffĂŠrents de ceux relevĂŠs. **Avant qu'un modèle de tĂŠlĂŠphone ne soit mis en vente auprès du public aux Ătats-Unis, la Commission fĂŠdĂŠrale des communications (CFC) doit le tester et certifier qu'il respecte les limites fixĂŠes dans les exigences gouvernementales d'exposition sans danger*. Pour chaque modèle, les tests sont effectuĂŠs en position et aux endroits d'usage (c.-Ă -d. près de l'oreille et portĂŠ sur le corps), tel que requis par la CFC. La CFC a accordĂŠ une autorisation d'ĂŠquipement pour ce modèle de tĂŠlĂŠphone, après que tous les niveaux de TAS indiquĂŠs aient ĂŠtĂŠ ĂŠvaluĂŠs et considĂŠrĂŠs conformes aux lignes directrices de la CFC en matière d'exposition aux radiofrĂŠquences. MĂŞme s'il peut y avoir des diffĂŠrences entre les niveaux de TAS des diffĂŠrents tĂŠlĂŠphones, tous les tĂŠlĂŠphones mobiles auxquels la CFC a accordĂŠ une autorisation d'ĂŠquipement rĂŠpondent aux normes gouvernementales en matière d'exposition sans danger. La CFC conserve dans ses dossiers l'information relative aux TAS relevĂŠs pour ce modèle de tĂŠlĂŠphone. Vous pouvez la consulter au http://transition.fcc.gov/oet/ea/fccid sous la rubrique ÂŤ Display Grant Âť, après avoir effectuĂŠ une recherche sur CFC ID ,' PY7PM-0640. 3<30 Vous trouverez des renseignements supplĂŠmentaires concernant le DAS sur le site Web du Mobile Manufacturers Forum MMF au http://www.emfexplained.info/. * Aux Ătats-Unis et au Canada, la limite de TAS des tĂŠlĂŠphones mobiles utilisĂŠs par le public est de 1,6 watt/kg (W/kg) en moyenne sur un gramme de tissus. Cette norme comporte une marge importante de sĂŠcuritĂŠ afin d'assurer une protection supplĂŠmentaire et de tenir compte de toute variation dans les mesures. **Ce paragraphe ne concerne que les autoritĂŠs et les clients des Ătats-Unis. FCC Statement This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Any change or modification not expressly approved by Sony may void the user's authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ⢠Reorient or relocate the receiving antenna. ⢠Increase the separation between the equipment and receiver. ⢠Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. ⢠Consult the dealer or an experienced radio/TV technician for help. ! " # $ % #& #' " ( % ) " # 17 Industry Canada Statement This device complies with RSS-210 of Industry Canada. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numĂŠrique de la classe B est conforme Ă la norme NMB-003 du Canada. Operation in the band 5150-5250 MHz is only for indoor use to reduce the potential for harmful interference to co-channel mobile satellite systems. Please note that high-power radars are allocated as primary users (i.e. priority users) of the bands 5250-5350 MHz and 5650-5850 MHz and that these radars could cause interference and/or damage to LE-LAN devices. Avis dâindustrie Canada Le prĂŠsent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisĂŠe aux deux conditions suivantes: (1) l'appareil ne doit pas produire de brouillage, et, and (2) l'utilisateur de l'appareil doit accepter tout brouillage radioĂŠlectrique subi, mĂŞme si le brouillage est susceptible d'en compromettre le fonctionnement. 18
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.5 Linearized : Yes Author : 22715137 Create Date : 2014:01:25 15:38:57+09:00 Modify Date : 2014:01:25 15:38:57+09:00 XMP Toolkit : Adobe XMP Core 4.2.1-c041 52.342996, 2008/05/07-20:48:00 Producer : Acrobat Distiller 9.0.0 (Windows) Creator Tool : UnknownApplication Document ID : fcf4301d-85b3-11e3-0000-3f06f2aacd69 Instance ID : uuid:e1a1fba5-53c8-452b-8cb0-e1516c1a2c61 Format : application/pdf Title : Sirius-Samba_SAR-FCC-IC-leaflet_01222014.pdf Creator : 22715137 Page Count : 7EXIF Metadata provided by EXIF.tools