Sorenson Communications SR3000001 wireless n router User Manual Sorenson SR 300 USER GUIDE draft
Sorenson Communications, Inc. wireless n router Sorenson SR 300 USER GUIDE draft
Manual
1
WIRELESS N ROUTER
SR-300
USER’S GUIDE
2
TABLE OF CONTENT
1. Setup .....................................................................3
2. Specification ..........................................................4
3. FCC / IC statement ................................................5
3
1. Setup
SR-300 will be installed in a common network configuration, such as that
shown in Figure 1. The Sorenson Videophone will connect via common
cabling (e.g., Cat-5 or Cat-5e) to SR-300. Other devices may be connected
via cabling to the router as well. Optionally, wireless devices can also
connect to SR-300. SR-300 will connect to a cable or DSL modem connected
to the Internet via an ISP.
Figure 1 - Basic Network Configuration
VideoPhone
Wireless Router
Computer
Internet
Cable or DSL Modem
Laptop computer
SR
-
300
4
2. Specification
Specification
IEEE 802.11n (draft 2.0)
IEEE 802.11g
IEEE 802.3
Standards
IEEE 802.3u
4 10/100 LAN Ports
Device Interface 1 10/100 WAN Port
Antenna Type 2 Fixed Antennas
Security Wi-Fi® Protected Access (WPA™, WPA2™)
Network Address Translation (NAT)
Stateful Packet Inspection (SPI)
Advanced Firewall Features
VPN Pass-through / Multi-sessions PPTP / L2TP / IPSec
Device Management Internet Explorer® v6 or Later; Mozilla Firefox® v1.5 or Later;
or other Java-enabled Browsers
Power and Status
WAN (10/100)
WLAN (Wireless Connection)
LEDs
LAN (10/100)
FCC Class B
IC
Certifications
Wi-Fi®
Item (WxDxH): 5.7" x 4.2" x 1.2"
Dimensions Packaging (WxDxH): 10.8" x 8" x 2.6"
Item: 0.5 lbs
Weight Packaging: 1.5 lbs
Cable or DSL Modem
Computer with:
Windows® Vista**, Windows® XP SP2**, or Windows® 2000
SP4**, or Mac OS® X (v10.4)***
Internet Explorer v6 or Mozilla Firefox v1.5
Network Interface Card
For Internet Access:
Cable or DSL Modem
Minimum System
Requirements
Subscription with an Internet Service Provider (ISP)
Wireless N Router with 2 Attached Antenna
CAT5 Ethernet Cable
Package Contents
Power Adapter
5
3. FCC / IC statement
Industry Canada statement
This device complies with RSS-210 of the Industry Canada Rules. Operation is
subject to the following two conditions:
1) This device may not cause harmful interference, and
2) This device must accept any interference received, including interference that
may cause undesired operation.
Règlement d’Industry Canada
Les conditions de fonctionnement sont sujettes à deux conditions:
1) Ce périphérique ne doit pas causer d’interférence et.
2) Ce périphérique doit accepter toute interférence, y compris les interférences
pouvant perturber le bon fonctionnement de ce périphérique.
IMPORTANT NOTE:
Radiation Exposure Statement:
This equipment complies with IC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator & your body.
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution:
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
6
(2) This device must accept any interference received, including interference that
may cause undesired operation.
IMPORTANT NOTE:
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator & your body.
This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
The availability of some specific channels and/or operational frequency bands
are country dependent and are firmware programmed at the factory to match the
intended destination. The firmware setting is not accessible by the end user.