Spin Master Toys Far East 14105RX4901 RC Toy User Manual

Download:
Mirror Download [FCC.gov]
Document ID	447424
Application ID	C1uiXnIzSK1QiqEF8y6VbA==
Document Description	User Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	7.66kB (95808 bits)
Date Submitted	2004-07-07 00:00:00
Date Available	2004-07-07 00:00:00
Creation Date	2004-06-17 11:10:48
Document Lastmod	2004-06-17 11:44:41
Document Title	User Manual
Document Creator	HP 9100C Digital Sender
Document Author:	ITS ELECTRIC TOY

For model: # l4l 05-49MHz-Rx-FCC test
Instructions
chencrator Mini.
Problems?
Before taking Crash Forcem RegeneratorYM
Mini RC
back to the retailer, call our friendly _
RC technicians at 1-800-622-8339
Battery installation:
Crash ForceTM l’tegeneratorTM Mini requires 4
AA batteries and one 9V battery to run. (Sold
separately.)
Vehicle:
1- Locate the battery door on the bottom
of the vehicle.
2- Rotate the lock to release the battery
door as shown.
3- Place the batteries in the tray
according to the polarity markings as
shown.
4- Replace the battery door and slide the
look back into place.
Controller:
1 - Using a Phillips screwdriver, undo the_
hold down screw and remove the battery _
compartment door.
2 - Place the 9-Volt battery in the battery _
compartment, making sure to follow the _
correct * and — polarity markings.
3 - Replace the battery compartment door_
and retasten the hold down screw,
Operating the vehicle.
When driving Regenerator'“ Mini, the most
dramatic crashes are caused by head on
collisions at full speed. It can take as
many as 5 hits to fully crumple Regenerator'“
Mini or as few as one, it the speed is fast
enough. You can drive Regenerator'“ Mini
in the crashed state, lull function. When you
press the Regeneration button, the car will
return to its original state.
Regenerator’“ Mini can retorm from a standing
or moving position.
GETTING STARTED
1 Turn the “ON-OFF" switch to the _
"ON" position.
2, Use Controller to move vehicle _
forwards or backwards, right or Iefl,
Be sure to turn the "ON-OFF" _
switch to the “OFF" position when
finished playing with the vehicle.
BREAK-AWAY PARTS
Regenerator'M is designed with
break away doors and rear window
section. If you crash Regenerator‘“ Mini on
certain angles,
you can dislodge these parts. To
replace, simply snap them back in
as shown, Each break-away part has
a snap attached that
fits securely into a corresponding
hole on the vehicle.
SAFETY INFORMATION
Atways turn Regeneratorm oft berore attempting _
to pick |t up. Never touch the Vehicle while it is
regenerating or moving Do not place the Controller
on the ground with the button facing down. __
This could cause accidental starts or erroneous
responses
BATTERIES
Crash Force” Regenerator'“ Min! requires_
with one S-Volt battery lor the Controller and 4_
AA batteries not included
IMPORTANT BATTERY INFORMATION
Battery installation should be performed by an adult.
Use only batteries
recommended on this package and the instruction
sheet Be carelul to install
batteries with the correct polarity as indicated - Do
not mix new and old
batteries. ~ Do not mix alkaline, standard.
rechargeable or difrerent types of
batteries. ~ Non-rechargeable batteries are not to be
recharged _
' Rechargeable batteries are to be removed from the
toy berore being _
charged. - Rechargeable batteries are only to be
charged under adult
supervision. - Only batteries or the same or
equivalent type as recommended
are to be used. ' Exhausted batteries are to be
removed from the toy. _
~ The supply terminals are not to be short circuited.
Please retain this information for
future reference
Trouble Shooting.
PROBLEM
Car will not Stan.
Car does not respond to controls
Car does not drive straight.
SOLUTION
1. Power switch is art Turn on 2. Batteries are
Installed with incorrect polarities. Check the + and -
markings
make sure the batteries are property aligned 3.
Batteries are drained. install new batteries.
‘. Controller battery is drained. Replace the SV
controller battery. 2. Vehicle is out 01 Range. Bring
controller
to the vehicle 3. Interterence tram surrounding
electrical machinery. Bring to a wide open space.
4. Car is in sleep mode. Turn the power oft tor 10
seconds, then turn it back on to reset
NOTE: wlth electrostatic discharge
in the environment, the vehicle may
malfunction . Reset the vehicle in
by turning the vehicle OFF and
restart agaln to resume normal
operation.
1. Adjust the steering dial underneath the front axle,
left or right. until the wheels point straight forward
FCC Requirement. This device complies with part 15
of the FCC rules. Operation is
subject to the following tut/o conditions (1) this
device may not cause harmful
interference; and (2) this device must acoept any
interference that may cause
undeswed operation. Do not attempt to repair or
modify this equipment. _
WARNING: Changes or modifications not expressly
approved by the party responsible
for its compliance could void the users authority to
operate the equipment,
Spin Master Ltd. _
450 Front Street West, Toronto, ON MSV 186
Canada_
Phone. LEGO-6228339 Fax: 416~364~8005_
Web' www spinmaster com Email:
toys@spinmster.com
©2004 Spin Master Ltd. TM Crash Force and _
TM Regeneraior are trademarks of Spin Master Ltd.
in Rights Reserved
Assortment # 14103
UPC 7 7898814103 3
Item t 14105

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.3
Linearized                      : No
Creator                         : HP 9100C Digital Sender
Create Date                     : 2004:06:17 11:10:48
Author                          : ITS ELECTRIC TOY
Producer                        : 
Title                           : 
Subject                         : manual
Modify Date                     : 2004:06:17 11:44:41+08:00
Page Count                      : 3

EXIF Metadata provided by EXIF.tools