Spin Master Toys Far East 14105TX4901 RC Toy User Manual

Download:
Mirror Download [FCC.gov]
Document ID	448079
Application ID	a8AYBLeBChDsslMpTpbrig==
Document Description	User Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	7.68kB (95938 bits)
Date Submitted	2004-07-08 00:00:00
Date Available	2004-07-08 00:00:00
Creation Date	2004-06-17 14:32:07
Document Lastmod	2004-06-17 14:59:23
Document Title	User Manual
Document Creator	HP 9100C Digital Sender
Document Author:	ITS ELECTRIC TOY

For model: #14105-49MHz-Tx-FCC test
Instructions
Regenerator Mini.
Problems?
Before taking Crash ForceWI RegeneratorrM
Mini RC
back to the retailer, call our friendly _
RC technicians at: 1-800v622-8339
Battery installation:
Crash ForceTM RegeneratorYM Mini requires 4
AA batteries and one 9V battery to run. (Sold
separately.)
Vehicle'
1- Locate the battery door on the bottom
of the vehicle.
2- Rotate the lock to release the battery
door as shown.
3- Place the batteries in the tray
according to the polarity markings as
shown.
4» Replace the battery door and slide the
look back into place,
Controller:
1 - Using a Phillips screwdriver, undo the_
hold down screw and remove the battery _
compartment door.
2 - Place the 9-Volt battery in the battery _
compartment, making sure to follow the _
correct + and - polarity markings.
3 v Replace the battery oompartment door_
and retasten the hold down screw,
Operating the vehicle.
When driving Regenerator’" Mini, the most
dramatic crashes are caused by head on
collisions at full speed. It can take as
many as 5 hits to fully crumple l-‘x‘egeneratorw
Mini or as few as one. if the speed is fast
enough. You can drive Regenerator'“ Mini
in the crashed state, full function, When you
press the Regeneration button, the car will
return to its original state.
Regeneratorm Mini can reform from a standing
or moving position.
GETTING STARTED
1. Turn the “ON-OFF" switch to the _
“ON“ position.
2. Use Controller to move vehicle _
forwards or backwards, right or left.
Be sure to turn the “ON-OFF” _
switch to the "OFF" position when
finished playing with the vehicle.
BREAK~AWAY PARTS
Regenerator'“ is designed with
break away doors and rear window
section. If you crash Regenerator'“ Mini on
certain angles,
you can dislodge these parts. To
replace, simply snap them back in
as shown. Each break-away part has
a snap attached that
fits securely into a corresponding
hole on the vehicle,
SAFETY INFORMATION
Always tum Regenerator'" off before attempting _
to pick it up. Never touch the vehicle while it is
regenerating or moving. Do not place the Controller
on the ground with the button facing down. _
This could cause accidental starts or erroneous
responses
BATTERIES
Crash Force” Regenerator'" Mini requires_
with one 9-Voit battery for the Controller and 4_
AA batteries not included,
IMPORTANT BATTERY INFORMATION
Battery installation should be performed by an adult.
Use only batteries
recommended on this package and the instruction
sheet Be careful to install
batteries with the correct polarity as indicated ~ Do
not mix new and old
batteries ~ Do not mix alkaline, standard.
rechargeable or different types of
batteries, ~ Non-rechargeable batteries are not to be
recharged _
~ Rechargeable batteries are to be removed from the
toy before being _
charged . Rechargeable batteries are only to be
charged under adult
supervision . Only batteries oiine same or
equivalent type as recommended
are to be used ~ Exhausted batteries are to be
removed Irom the toy. _
- The supply terminals are not to be short clrcuited,
Please retain this information for
future reference
Trouble Shooting.
PROBLEM
Car will not Start
Car does not respond to controls.
Car does not drive straight.
SOLUTION
1. Power switch is off, Turn on 24 Batteries are
installed with inmnect polarities. Check the + and -
markings
make sure the batteries are properly aligned 3.
Batteries are drained. Install new batteries
14 Controller battery Is drained. Replace the 9V
controller battery 2. Vehicle Is out of Range. Bring
controller
to the vehicle. 3. Interference from surrounding
electrical machinery Bring to a Wide open space,
4. Car is In sleep mode, Turn the power of! for 10
seconds, then turn it back on to reset,
NOTE: With electrostatic discharge
in the env1ronment , the vehicle may
malfunction t Reset the vehicle in
by turnlng the vehxcle OFF and
restart again to resume normal
operamon .
1A Adjust the steering dial underneath the lront axle,
left or right until the wheels point straight iorward
FCC Requirement. This device complies with part 15
of the FCC rules, Operation is
subject to the lollowing two conditions: (1) this
device may not cause harmful
interference; and (2) this device must accept any
interference that may cause
undesired operation. Do not attempt to repair or
modify this equipment __
WARNING: Changes or modifications not expressly
approved by the party responSible
for its compliance could void the users authority to
operate the equipment.
Spin Master Ltd. _
450 Front Street West, Toronto, ON MSV 186
Canada__
Phone" 1-300-622-8339 Fax: 416-364-8005_
Web' www.spinmaster.com Email:
toys@spinmster,com
©2004 Spin Master Ltd. TM Crash Force and _
TM Regenerator are trademarks of Spin Master Ltd
in Rights Reserved.
Assortment # [4103
UPC 7 78988 14103 8
Item ll 14105

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.2
Linearized                      : No
Creator                         : HP 9100C Digital Sender
Create Date                     : 2004:06:17 14:32:07
Author                          : ITS ELECTRIC TOY
Producer                        : 
Title                           : 
Subject                         : manual
Modify Date                     : 2004:06:17 14:59:23+08:00
Page Count                      : 3

EXIF Metadata provided by EXIF.tools