Spin Master Toys Far East 40155TX27 RC Car User Manual

Spin Master Toys Far East Ltd. RC Car

User Manual

Download: Spin Master Toys Far East 40155TX27 RC Car User Manual
Mirror Download [FCC.gov]Spin Master Toys Far East 40155TX27 RC Car User Manual
Document ID327465
Application IDOpjdlafzimySQsOQOJPaFQ==
Document DescriptionUser Manual
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize11.85kB (148146 bits)
Date Submitted2003-05-23 00:00:00
Date Available2003-05-23 00:00:00
Creation Date2003-04-28 15:36:22
Document Lastmod2003-04-28 15:46:36
Document TitleUser Manual
Document CreatorHP 9100C Digital Sender
Document Author: ITS ELECTRIC TOY

Model 110.1 #40155 / 40151 /40152
IEportzamt! Problems? Before taking Crash ForceTMRegenerator T“RC back to the
retailer, call our friendly RC technicians at: 18006228339
REGENERATOR
Check to make sure contents are complete: 1. Crash Zone RC Regenerator SUV, 1
Controller, AA battery adaptor-r (Inside battery compartment.)
Crash Zones. (Label as on pkg.)
Wheels, battery compartment, Bumper.
Controller: Antenna, forward/reverse, right/left, regenerate.
Regenerator Storage.
The Crash Force TMRegenerator RC should be stored indoors in the box and foam tray
afler each use. _|
Installing the Batteries. Vehicle
Crash Force T"Regenerator ”RC is designed to work with standard RC 6V NiMH
batteries and chargers, sold separately. If you do not have a 6V battery and charger,
Crash Force TMRegenerator TMRC can operate with 5AA batteries.
To install the 6V battery, rotate the battery door locks to the sides of the door as shown.
Place the battery in the compartment making sure to follow the correct + and — polarity
markings.
To install AA batteries, place them in the battery tray according to the + and — markings.
Place the tray into the battery compartment.
Replace the battery door and turn the door locks over the battery door as shown
Installing the controller batteries. Controller.
Using a Philips screwdriver, remove the battery doorr Place 9V battery inside according
to the + and — markings.
Replace battiry doorr
When driving Regenerator Th} the most dramatic crashes are caused by head on
collisions at full speed It can take as many as 4 hits to fully cmmple Regenerator TMor
few as one if the speed is fast enough.
You can drive Regenerator “in the crashed state, full function, When you press the
Regeneration button, the car will return to a new state. Regenerator mean reform from
a standiflgpr moving position.
Regenerator TMis designed with break away doors, roof and rear section. If you crash
Regenerator “from certain angles you can break off these parts. To replace, simply
snap them back in as shown. j
Each break—away part has a cone shaped snap attached that fits securely into a
corresponding hole on the vehicle.
Safety information.
Always turn RegeneratorTM off before attempting to pick it up. Never touch the vehicle
during while it is regenerating or mow'ng. Do not place the controller on the ground
with the buttons facin_g_down. This could case accidental starts or en'oneous responses.
Batteries.
Crash Force TMRegenerator requires:
1 9V battery for the controller, sold separately.
1 6V rechargeable NiMH battery and charger
or
SAA batteries for vehicle, sold separately
Important battery information:
Battery installation should be performed by an adult. Use only batteries recommended
on this package and the instruction sheet. Be carefiil to install batteries with the correct
polarity as indicated.
0 Do not mix new and old batteries.
Do not mix alkaline, standard, rechargeable or different types of batteries.
Battery installation should be performed by an adult.
Non-rechargeable batteries are not to be recharged.
Rechargeable batteries are to be removed from the toy before being charged.
Rechargeable batteries are only to be charged under adult supervision.
Only batteries of the same or equivalent type as recommended are to be used.
Batteries are to be inserted with the correct polarity.
Exhausted batteries are to be removed from the toy,
The supply terminals are not to be short circuited.
Asst 40155.
Spin Master LTD. 450 Front West. Toronto, ON M5V 1B6 Canada. Phone 1 800 622
8339. Fax 416 364 8005
mspjnmastemm Email: WWW
©2003 Spin Master LTD. T'€rash Force and ‘MRegenerator are trademarks of Spin
Master LTD. All R_igl_its Reserved.
FCC Requirement.
This device complles with part 15 of the FCC rules. Operation is subject to the following
two conditions:
(1) this device may not cause harmful interference; and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
Do not attempt to repair or modify this equipment.
WARNING: Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’ s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not Installed and
used in accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment dons cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
increase the separaflon between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is needed.
Consult the dealer or an experienced radio/TV technician for help.
D EIEIE]
l_——
Troubleshooting.
Cause Solution
Car will not Start. 1. Power switch is off Tum on.
2. Batteries are installed Check the (+) and (-)
with incorrect polarities. markings to make sure the
batteries are properly
diged.
3. Batteries are drained. Charge batteries and/or
install new batteries.
Car does not respond to 1. Controller battery is Replace the 9V controller
controls. drained. batten.
Car is out of Range. Bring controller closer to
the vehicle.
Interference fi‘om Bring to a wide open space.
surrounding electrical
machinery.

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.2
Linearized                      : No
Creator                         : HP 9100C Digital Sender
Create Date                     : 2003:04:28 15:36:22
Author                          : ITS ELECTRIC TOY
Producer                        : 
Title                           : 
Subject                         : 
Modify Date                     : 2003:04:28 15:46:36+08:00
Page Count                      : 3
EXIF Metadata provided by EXIF.tools
FCC ID Filing: PQN40155TX27

Navigation menu