Spin Master Toys Far East 44279RX49 RC Hovercraft User Manual overcraft P1

Download:
Mirror Download [FCC.gov]
Document ID	810287
Application ID	p32ASFz4e8kvKaBo25JTjA==
Document Description	User Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	65.05kB (813106 bits)
Date Submitted	2007-06-29 00:00:00
Date Available	2007-06-29 00:00:00
Creation Date	2007-06-21 11:44:54
Producing Software	QuarkXPress(R) 7.2
Document Lastmod	2007-06-21 14:05:31
Document Title	overcraft P1
Document Creator	QuarkXPress(R) 7.2

®
INSTRUCTIONS
Antenna
Charging
Indicator
Light
Propeller
ON/OFF
Switch
Charge
Button
ON/OFF
Switch
Charger
Door
Charging
Port
Charger
Cable
Contents:
• 1 R/C Hovercraft
• 1 Controller/Charger
• 1 instruction sheet
R/C Hovercraft
Left/Right
Toggle
Controller/Charger
BATTERY INSTALLATION FOR YOUR CONTROLLER/CHARGER
FLIGHT CONTROLLER
1. Use a phillips screwdriver to
loosen the screw in the
battery compartment door.
2. Remove the battery door.
3. Insert six 1.5 Volt AA alkaline
batteries (not included). Be
careful to align the positive
(+) and negative (–) polarities
with the corresponding
markings inside the battery
compartment.
4. Replace battery compartment
door and refasten the screw.
IMPORTANT BATTERY INFORMATION
Six
1.5 Volt
AA
Batteries
• Battery installation should be performed by an adult.
• Use only batteries recommended. Be careful to install the batteries
with the correct polarity as indicated.
• Do NOT mix different types of batteries or old and new batteries.
• Do NOT mix alkaline, standard or rechargeable batteries.
• Do NOT attempt to charge non-rechargeable batteries.
• Do NOT short circuit the supply terminals.
• Exhausted batteries are to be removed, as they will adversely affect
the performance.
• Caution: Hovercraft contains a rechargeable cell. If fluid leaks
from the cell, avoid fluid contact with eyes and safely dispose of
the Hovercraft.
• Only use the controller/charger supplied with this package.
• Do NOT use any other source to charge your R/C Hovercraft.
Battery
Compartment
CHARGING YOUR R/C HOVERCRAFT
STEP 1
STEP 2
ON/OFF
Switch
Make sure that
the ON/OFF
switch on the
hovercraft and
the controller/
charger is
“OFF”.
STEP 3
Open the
charge door on
the controller/
charger.
STEP 4
Push the charge button on the
controller/charger. The controller/
charger LED will flash red during
charging. Charging is complete
when the controller/charger LED
indicates a steady green.
Insert the
charge cable
into the
hovercraft’s
charge port.
STEP 6
STEP 5
Carefully remove the
charge cable from the
hovercraft charge port.
Store the charge
cable and close
the charger door.
IMPORTANT: For your first run, the charging process should be repeated before use,
completing two (2) complete charging cycles. Subsequent use requires only a single (1) charge cycle.


---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.6
Linearized                      : No
XMP Toolkit                     : 3.1-701
Modify Date                     : 2007:06:21 14:05:31+08:00
Create Date                     : 2007:06:21 11:44:54+08:00
Metadata Date                   : 2007:06:21 14:05:31+08:00
Creator Tool                    : QuarkXPress(R) 7.2
Format                          : application/pdf
Title                           : overcraft P1
Document ID                     : uuid:fc81d284-664a-4c11-8fd1-9f0859cb1520
Instance ID                     : uuid:7755e93e-ccbd-4d85-b54a-2ca700ce6092
Producer                        : QuarkXPress(R) 7.2
Has XFA                         : No
Page Count                      : 2
Creator                         : QuarkXPress(R) 7.2

EXIF Metadata provided by EXIF.tools