Status Audio BT-ONE Bluetooth earphone User Manual
Status Audio Inc Bluetooth earphone
User Manual
Charge
Fully charge headphones (~3 hours) until
blue LED light illuminates
Pairing
Activate Bluetooth on your device.
Turn the headphones on by holding the
Power/Multi-Function Button until you hear
“Power On”. Upon first use, the headphones
will immediately enter “discoverable” mode
(indicated by alternating red/blue flashing
light) - this means they are ready to pair to
a device.
Select “Status Audio BT One” in the
Bluetooth menu on your device.
Once paired, the red and blue light will
stop flashing and you’ll hear an audio
confirmation.
The headphone pairing procedure may vary
depending on the settings of your device. If
necessary, please contact the manufacturer of
the device for further information.
Notes On Pairing
If the headphones are on and no previously
paired devices are within range, the
headphones will automatically enter
“discoverable” mode.
If already paired and you desire to break
the connection and connect to another
Bluetooth source, simply double-tap the
Power/Multi-Function Button. This will
cancel the current connection and enter
“discoverable” mode (flashing red/blue
light).
If a streaming connection is broken by an
accidental double tap of the Power/Multi-
Function Button, one additional press of
Power/Multi-Function Button will restore
the connection to the most recently paired
source.
Cabled Connection
The BT One headphones come with a 2.5mm
to 3.5mm cable for wired use, so you can
enjoy music/audio when the battery is
depleted or Bluetooth isn’t available.
Control functionality may vary
depending on device.
Microphone
LED Light
Micro USB Charging Input
Power / Multi-function Button
Volume – / Next Track
Volume + / Prev Track
Play
The BT One headphones allow you to control
music playback and incoming phone-calls.
Controlling Your Headphones
The BT One headphones utilize simple
intuitive commands to control your music,
audio, and incoming phone calls.
and track control - a double tap of +/- will
change tracks, while holding or single-
tapping of +/- changes volume.
For minimal volume changes, we
recommend single taps of +/-. To
dramatically change volume, press and hold
+/-.
Hold
Hold
Hold / Tap
Hold / Tap
Double Tap
Double Tap
Tap
Tap
Double Tap
Power On
Volume Up
Volume Down
Track Fwd
Track Rwd
Play / Pause
Pickup / Hangup Call
Break Connection +
Re-enter discoverable mode
CommandAction
FCC STATEMENT :
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) This
device must accept any interference received, including interference
that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority to
operate the equipment.
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure
requirement. The device can be used in portable exposure condition
without restriction.
RF warning statement: