Sudio SUDIOTOLV True Wireless Earphones User Manual 15 Sudio Tolv UserMan

Sudio AB True Wireless Earphones 15 Sudio Tolv UserMan

Contents

15_Sudio Tolv UserMan

4PRECAUTIONS AND USAGEDo not use the product in other ways than described. Handle with care at all times and protect from damage. Do not expose the earphones to heat, magnetism, cold, damp environments or abnormal wear and tear e.g. by bending or pulling them. Avoid dropping, strong impact or winding the cable tightly. Clean with a slightly damp fabric.The WEEE-symbol means that the product should Not be mixed with normal house-hold waste, please return to facilities for Waste Electrical and Electronic Equipment.WARNINGNever listen to music at an uncomfort-ably high volume, this may permanently damage your hearing. Never use the ear-phones in trafc or in other places where your hearing is needed to perceive dan-gers. Always store small accessories out of small children’s range. Always lower the volume before you connect.
5SPECIFICATIONSBluetooth Version: V5.0, class IIBluetooth Prole: HFPv1.7 HSPv1.2 A2DPv1.3 AVRCPv1.6, SPP1.2Bluetooth Range: 15MMusic Time: 7 hoursTalking Time: 7 hoursCharging Time: 1.5HCharging Type: 3.7V, 50mAh (earphone) rechargeable lithium polymer battery Operating Temperature: -10 - 55°CCharging case: 500mAh (case) rechargeable lithium polymer battery
6POWER ON / PAIRING MODELift both earphones from the charging case and they will be in pairing mode.Select “Sudio Tolv” in the bluetooth list on your device.MUSIC CONTROLSPlay/Pause = Press button onceNext song = Press R button two timesPrevious song = Press L button two timesRL(1 click)(2 click)(2 click)English
7PHONE CONTROLSAnswer call = Press R onceReject call = Press and hold R for two secondsTROUBLESHOOTINGIf the earphones are behaving unexpect-edly or you’re having difculty pairing, we recommend a reset.1. Turn off both earphones by pressing and holding both buttons for six seconds.Start the earphones again by pressing and holding both sides for thirteen seconds, until the lights stop blinking.2. Put the earphones back in the case and wait for 10 seconds. They are now reset.R(1 click)(Hold 2 sec)English
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Navigation menu