Sumavision Technologies MC800 Network set-top box User Manual
Sumavision Technologies Co., Ltd. Network set-top box Users Manual
User manual
HDMI cable
Packing list Remote Controller
Media center
Power adapter
Remote Controller
Ethernet cable
POWER
PREV
HOME
UP
LEFT
VOL-
RED
MENU
MUTE
GREEN
OK
PLAY/PAUSE
PERIOD
SETTING
NUMBER
INFO
DOWN
VOL+
YELLOW
NEXT
DEL
RIGHT
BACK
BLUE/CC
HDMI output
HDMI cable
Rear panel
Connect TV set
Connect the media center and your TV set with AV cable or HDMI cable.
HDMI cable is recommended for better picture quality.
Connect power socket
Connect the media center and power socket with the appendant power
adapter.
Connect network
Connect the media center and your home router with Ethernet cable.
.
If
Ethernet connection is unavailable, you can set up and use Wi-Fi
connection alternatively per the setup wizard
Front panel
Right panel
Product appearance
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct theinterference by one or more of the following measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
--Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of FCC Rules. Operation is subject to the following
two conditions: (1)This device may not cause harmful interference, and (2)This device
must accept any interference received, including interference that may cause undesired
operation.
Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.