Sun Cupid Technology NUUX4 LTE mobile phone User Manual X4 Quick Start Guide FCC

Sun Cupid Technology (HK) Ltd. LTE mobile phone X4 Quick Start Guide FCC

Users Manual

X4 Overview X4X4
Google Play™Google Chrome™Google Play is a trademark of Google Inc.The Google Play store allows you to download apps, music, movies, and games directly to your device.Browse the web with Google Chrome by tapping the Google Chrome icon. Type an address or search term into the Omnibox to get started. store©2015 Google Inc., used with permission. Google and the Google logo are registered trademarks of Google Inc.X4IC statementThis device complies with Industry Canada licence-exempt RSS standard(s).Operation is subject to the following two conditions:(1) This device may not cause interference, and.(2) This device must accept any interference, including interference that may cause undesired operation of the device.This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.End user must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.The mobile device is designed to meet the requirements for exposure to radio waves established by the Federal Communi-cationsCommission (USA). These requirements set a SAR limit of 1.6 W/kg, averaged over one gram of tissue.The highest SAR value reported under. This standard during product certification for use when properly worn on the head is W/kg and when worn on the body is W/Kg.The maximum scaled SAR in hotspot mode is W/KgIC Radiation Exposure StatementThis device was tested for typical body-worn operations. To comply with RF exposure requirements, a minimum separation distance of 10mm must be maintained between the user’s body and the handset, including the antenna. Third-party belt-clips,holsters, and similar accessories used by this device should not contain any metallic components. Body-worn accessories that do not meet these requirements may not comply with RF exposure requirements and should be avoided. Use only the supplied or an approved antenna.Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes:(1) l'appareil ne doit pas produire de brouillage, et(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage estsusceptible d'en compromettre le fonctionnement.Cet équipement est conforme aux limites d'exposition aux rayonnements de la FCC définies pour un environnement non contrôlé. L'utilisateur final doit respecter les instructions de fonctionnement spécifiques pour satisfaire la conformité aux expositions RF. Cet émetteur ne doit pas être co-localisées ou opérant en conjonction avec une autre antenne ou émetteur.L'appareil mobile est conçu pour répondre aux exigences en matière d'exposition aux ondes radio établies par la Federal CommunicationsCommission (Etats-Unis). Ces exigences définissent la valeur SAR limite à 1.6 W/kg, en moyenne pour un gramme de tissu. La valeur SAR la plus élevée pour ce modèle de téléphone testé à l'oreille est W/Kg et lorsque porté sur le corps est W/Kg. L'échelle maximale SAR en mode hotspot est W/KgCet appareil a été testé pour des opérations portés sur le corps typiques. Pour se conformer aux exigences d'exposition auxradiofréquences, une distance minimale de 10 mm doit être maintenue entre le corps de l'utilisateur et le combiné, y compris l'antenne. Les pinces de ceinture, les étuis et autres accessoires similaires utilisés par cet appareil ne doivent pas contenir de composants métalliques. Les accessoires portatifs qui ne répondent pas à ces exigences peuvent ne pas se conformer aux exigences d'exposition RF et doit être évitée. Utilisez uniquement l'antenne fournie ou une antenne approuvée.SAR Information StatementYour wireless phone is a radio transmitter and receiver. It is designed and manufactured not to exceed the emission limits for exposure to radiofrequency (RF) energy set by the Federal Communications Commission of the U.S. Government. These limits are part of comprehensive guidelines and establish permitted levels of RF energy for the general population. The guidelines are based on standards that were developed by independent scientific organizations through periodic and thorough evaluation of scientific studies. The standards include a substantial safety margin designed to assure the safety of all persons, regardless of age and health. The exposure standard for wireless mobile phones employs a unit of measurement known as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6 W/kg. * Tests for SAR are conducted with the phone transmitting at its highest certified power level in all tested frequency bands. Although the SAR is determined at the highest certified power level, the actual SAR level of the phone while operating can be well below the maximum value. This is because the phone is designed to operate at multiple power levels so as to use only the power required to reach the network. In general, the closer you are to a wireless base station antenna, the lower the power output. Before a phone model is available for sale to the public, it must be tested and certified to the FCC that it does not exceed the limit established by the government adopted requirement for safe exposure. The tests are performed in positions and locations (e.g., at the ear and worn on the body) as required by the FCC for each model. The highest SAR value for this model phone when tested for use at the ear is W/Kg and when worn on the body, as described in this user guide, is W/K-g(Body-worn measurements differ among phone models, depending upon available accessories and FCC requirements). The maximum scaled SAR in hotspot mode is W/Kg. While there may be differences between the SAR levels of various phones and at various positions, they all meet the government requirement for safe exposure. The FCC has granted an Equipment Authorization for this model phone with all reported SAR levels evaluated as in compliance with the FCC RF exposure guidelines. SAR information on this model phone is on file with the FCC and can be found under the Display Grant section of http://www.fcc.gov/ oet/fccid after searching on FCC ID: 2ADINNUUX4 Additional information on Specific Absorption Rates (SAR) can be found on the Cellular Telecommunications Industry Asso-ciation (CTIA) web-site at http://www.wow-com.com. * In the United States and Canada, the SAR limit for mobile phones used by the public is 1.6watts/kg (W/kg) averaged over one gram of tissue. The standard incorporates a sub-stantial margin of safety to give additional protection for the public and to account for any variations in measurements.Body-worn OperationThis device was tested for typical body-worn operations. To comply with RF exposure requirements, a minimum separation distance of 10mm must be maintained between the user’s body and the handset, including the antenna. Third-party belt-clips, holsters, and similar accessories used by this device should not contain any metallic components. Body-worn accessories that do not meet these require-ments may not comply with RF exposure requirements and should be avoided. Use only the supplied or an approved antenna.

Navigation menu