User Manual
LK-3004H/LK-3004 Bluetooth speaker manual
Speaker Setup
Power on/off Speaker:
To power on, hold power button down until sound is heard.
To power off, hold power button down until sound is heard.
To Use Speaker:
1. When device is powered on, it automatically goes into pairing mode. A
green light will blink quickly.
2. When pairing is successful, green light will blink slowly.
3. Press play/pause button to play sound, green light will be steady on.
4. To pair another device, press and hold play/pause button down.
To Charge Speaker:
1. Use provided USB cable and plug into speaker and USB device.
2. Low Battery Indicator sound will sound when charging is needed.
3. A red light will be displayed when speaker is charging. Red light will
turn off when speaker is fully charged. Effective charging is when
speaker is powered off. CAUTION: Danger of explosion if battery is
incorrectly replaced. Replace only with the same or equivalent type.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.