Sunwe Electronic Technology IHV210 Bluetooth headphone User Manual

HongKong Sunwe Electronic Technology Limited Bluetooth headphone Users Manual

User manual

No. Function Operation Voice prompt LED (Bluetooth)1 Power on Headphone is “off”Press & hold the MFB button for 3sec Power on Flash blue2 Power off Headphone is “on”Press & hold the MFB button for 5sec Power off Solid red (3sec)3Pairing (Initial pairing) Headphone is “off”Press & hold the MFB button for 7sec ->auto switch to pairing modePower onPairing Quick flash blue & red(Not initial pairing) Headphone is “off”Press & hold the MFB button for 3sec ->search mode -> after 5min if no suitabledevice ->auto power offPower onPairingFlash blue (power on)Slow flash blue (search)All LED off(Manual pairing) Headphone is “off”Press & hold the MFB button for 7sec ->pairing modePower onPairingBlue LED flash (power on)Quick flash blue & red(pairing)Paired device Your device isconnected Slow flash blue4 Volume Control Press & hold "+" or "-" button Maximum Volume5 Play Music Short press the MFB button Slow flash blue6 Pause Music Short press the MFB button Slow flash blue7 Resume Playback Short press the MFB button Slow flash blue8 Track Controls Short press “+" or "-" button once forprevious song or next song Slow flash blue9 Answer a Call Short press the MFB button Incoming call Slow flash blue10 End a Call Short press the MFB button Slow flash blue11 Auto re-connect (Out of range)resume the operation rangeYour device isconnected Slow flash blue12 Low battery alert Lower than 3.3 V Battery low Slow flash red13 Auto power off (pairing mode)if no connected, will power off after 5min Power off Flash blue -> Solid red (3sec)-> all LED off(already paired device)if no signal input, will power off after 10min Power off Flash blue-> Solid red (3sec)-> all LED offUSB cable plug in (headphone charging) Solid red (<95%)LED off (95%~100%)
Federal Communications Commission (FCC) StatementThis device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) Thisdevice may not cause harmful interference, and (2) this device must accept any interference received, includinginterference that may cause undesired operation.Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in aresidential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed andused in accordance with the instructions, may cause harmful interference to radio communications. However, there isno guarantee that interference will not occur in a particular installation. If this equipment does cause harmfulinterference to radio or television reception, which can be determined by turning the equipment off and on, the user isencouraged to try to correct the interference by one or more of the following measures:●Reorient or relocate the receiving antenna.●Increase the separation between the equipment and receiver.●Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.●Consult the dealer or an experienced radio/TV technician for help.Warning: Changes or modifications made to this device not expressly approved by HongKong Sunwe ElectronicTechnology Limited may void the FCC authorization to operate this device.Note: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to thisequipment. Such modifications could void the user’s authority to operate the equipment.

Navigation menu