Sunwoda Electronic SPENSAM01 Active Stylus User Manual Lawrence 15RVR Win10 QSG ENG indb

Sunwoda Electronic Co.,Ltd. Active Stylus Lawrence 15RVR Win10 QSG ENG indb

User Manual

7Q"A
$FWLYH3HQ8VHUGuide
www.samsung.com
Active Stylus Model: SPEN-SAM-01
Using Active Pen
Install battery in the Active Pen
1 Turning upper part of the active pen
2 Put battery inside as (+) polarity located
in bottom side, then turning upper part again
Upper Button
Lower Button
Must check battery polarity(+/-)
Do not recharge provided battery
(AAAA)
Press Upper Button
Press Lower Button
Select folder of files with pressing upper button of
Active Pen, can show short cut menu as mouse
right button
When you use application(ex. "Sketchbook"),
by pressing lower button of Active pen, user can
erase selected area
This function can be different from some application
USA Only
For battery recycling go to
call2recycle.org
;
or call 1-800-822-8837
Appendix
English
Appendix
91
This equipment has been tested and found to comply
with the limits for a Class B digital device pursuant to Part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses,
and can radiate radio frequency energy. If not installed
and used in accordance with the instructions, it may
cause harmful interference. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and
receiver.
•
Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV
technician for help.
The Part 15 radio device operates on a non-interference
basis with other devices operating at this frequency. Any
changes or modification to said product not expressly
approved by Intel could void the user’s authority to
operate this device.
Unintentional emitter per FCC Part 15
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.

Navigation menu