Supertoys Co 4449-RC01 RC Fire Engine User Manual

Download:
Mirror Download [FCC.gov]
Document ID	251531
Application ID	cf8DSY9ra1Bu8ucbFRoPqw==
Document Description	Users Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	5.94kB (74289 bits)
Date Submitted	2002-06-20 00:00:00
Date Available	2002-06-20 00:00:00
Creation Date	2002-06-04 19:23:18
Producing Software	Acrobat 5.0 Scan Plug-in for Windows
Document Lastmod	2002-06-04 19:23:38
Document Title	Users Manual
Document Creator	Acrobat 5.0 Scan Plug-in for Windows

i r.
ITEM/An in due
commas?“ Radio Control
Wm...m.mw
$3 macaw - - .
mm... s......c......m
“meme"me" Ire nglne W“ ump
BuPEmvs MADE IN CHINA
INSTALLING onrrenres
WARNING: Dispose of old batteries promptly and property. no not burn orbirry them.
CAUTIONS:
0 Use only fresh batteries of the required size and recommended types
- If you do not plan to use the Fire Engine fora week or more, remove the batteries from both the
transmitter and the Fire Engine. Batteries can leak chemicals that can destroy electronic pans.
CONTROLLER BATTERY INSTALLATION
Use a Phillips head screw driver to remove the battery compmm cover located on the back of
the controller. Insert 1 “9V.” alkaline battery In the correct position as marked in compartment.
Replace cover and screw.
FIRE ENGINE INSTALLATION
1. Follow all operating Instructions and precautions to charge your '6V' rechargeable battery pack.
Note: most rechargeable batteries need charging when newly purchased
2. Insert fully charged battery pack Into battery compartment the (+) and (-) ends match. Use a
coin or Philip screw to turn the battery lock and secure the battery in place.
RAOIO CONTROL DRIVING
1. Slide ON/OFF to ON underneath the Fire Engine.
2. Fully extend the antenna on the transmitter and slide OFF/ON on the
transmitter to ON. The indicator on the transmitter llghts.
3. Use the transmitter's control lovers to move and steer the Fire Engine.
4. When you finish driving the Fire Engine, slide OFF/ON on the Fire
Engine and the transmitter to OFF.
FIRE ENGINE FUNCTION CONTROLS
Install fully charged rechargeable batteries Into the Fire Engine battery compartment and
transmitter In the correct position as Indicated. Install transmitter antenna as indicated.
Move power switches located underneath the Fire Engine and frontof thetransmltter to the "on"
positions, Fully extend transmltter antenna. Place Fire Engine on afiat surfaces
- To drive the Fire Engine. move “selector switch" to the left to select FlreEngIm operations.
. Emergency lights will flash with slren sound when Fire Englne ts moving.
a To drive forward, move “loysfick A" upward.
- To drive in reverse, move ‘ioystlck A" downward.
- To turn right, move “Joystick A” upward and “joystick B“ to the right.
. To reverse left, move “ioystick A” downward and “ioystick B' to the left.
- To reverse right, move “joystick A" downward and “joystick B' to the right.
0 To operate the ladder, move “selector switch" to the right to select ladder
operations. NOTE: This equipment has been tested and found to comply with
c To extend and raise ladder, move “joystick A" to upward the limits for a Class B digital device, pursuant to Part 15 of the FCC
. To [91mm and lower “my“, move “joystick A"downward. Rules. These limits are designed to provrdc reasonable protection
, To mm ladder to the right, move "ioystick B" to the fight against harmlui interference in a rosrdential installation. This
equipment generates. uses and can radiate radio frequency energy
and. if not Installed and used In accordance with the instructions,
may cause harmful interference to radio communications,
. To rotate ladderto the left, move “joystick 8” to the left.
- To squirt water, push the water button locate on the controller.
Cautions: Do not point water pump atthe eyes.
This device complies with Part 15 of the FCC Rules. Operation is sublectlo the following two conditions: (1) This device may not cause.
harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved bythc party responsible for compliance could void the user's authority
to operate the equipment. However, there Is no guarantee that Interference will not occur in a particular Installation. If this equipment does
cause harmful interference to radio ortelevision reception, which can be determined by turning the equipment off and on. the user is
encouraged to try to correct the interference by one or more of the Mowing measures: Reorient or relocate the receiving antenna. Increase
the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver
ls needed. Consult the dealer or an experienced radiofIV technician for help.

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : No
Modify Date                     : 2002:06:04 19:23:38+08:00
Create Date                     : 2002:06:04 19:23:18+08:00
Creator                         : Acrobat 5.0 Scan Plug-in for Windows
Page Count                      : 1
Mod Date                        : 2002:06:04 19:23:38+08:00
Creation Date                   : 2002:06:04 19:23:18+08:00
Producer                        : Acrobat 5.0 Scan Plug-in for Windows
Metadata Date                   : 2002:06:04 19:23:38+08:00

EXIF Metadata provided by EXIF.tools