Supertoys Co 6237RC01TX RC Toy User Manual

Download:
Mirror Download [FCC.gov]
Document ID	448705
Application ID	JWDwfKMJYUFQDKYfiwsVkg==
Document Description	User Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	9.21kB (115105 bits)
Date Submitted	2004-07-12 00:00:00
Date Available	2004-07-12 00:00:00
Creation Date	2004-06-11 12:16:29
Document Lastmod	2004-06-11 12:44:35
Document Title	User Manual
Document Creator	HP 9100C Digital Sender
Document Author:	ITS ELECTRIC TOY

St'imrotrs
tram/Anti mraw
FOR AGES 3 AND UP
All mutt-vint- In“ its-arm
attempts u u. ruc.
zntlrtrnt rite. alum IIJNTWVDtht tttr item
Requires line 9-irdli battery and
ainnuu- rtersirnans run chiinxffirérafalfinrwg ‘ AA size batteries
3 to entry,
INSTRUCTIONS: IN THE TRANSMITTER
INSTALLING BATTERIES 1. Use a Phlllips screwdriver to loosen the screw on
the battery compartment cover, then remove the
Follow these directions mm
' 0"? 9'V0" “My W W "mm" 2, Put the battery In the compartment as indimtett
- Four'AA'lee batteries Iurttie Baby Mantis bythe polarity symbols (t and -) marked lrrside.
WARNING: Dispose BI batteries promptly arid 3 Replace the coverand secure it With the screw.
”WWW D“ "°‘ W“ “WY "m“ When the lrarismitter's range decreases. replace its
CAUTION: battery.
~ Use only rresh batteries or the required size and IN THE ”By MANTIS
recommended type. .
le need rour AA alhailne batteries to power your ON /OFF
- it you do not plan to use the Baby Mantis tor a
week or mere, remnvethe batteries "cm the
transmitter and the Baby Mantis Batteries can leak
chemicals that can damage electronic parts.
' Never leave dead or weak batteries in the Baby
Mantis br transmitter.
Baby Mantis.
1. Usea Philllvs head screwdriverto remove the
battery compartment located on the back at the
Baby Mantis.
2 insert batteries in the correct posllipn as marked
in compartment. Replace compartment cover and
secure.
3. Move power switch to the '0r|' pusillun to operate
Batty Mantis. Move swtlch to the ‘m‘ positlon
when not in use.
When the Baby Mantis moves sluwly or not all all.
replace the batteries.
T0 DRIVE YOUR BABV MANTIS
1. Slide ON/DFF switch beneath the Baby Mantis to
ON.
2. Use the transmitter buttons to drive and steer
the Baby Mantis.
a. When you linlsn driVino the Baby Mantis slide
onrorr switch on the Baby Mantis to err.
Pin: to
dtltll tnrwarit
Prue to drive
(errata) backward
Release either button to
stop the mantis
HELPFUL HINTS FOR MAINTENANCE AND
PERFORMANCE:
|, Check batteries Irequerltly,
2. Check battery terminals tor contact.
3. Always turn switch on both units ett when not in
use.
4. Run oil Smooth level surtaces.
MAINTENANCE TIPS
To errlny your Drive Baby Mantis tor a long line.
- Keep the Baby Mantis dry. it it gels wet, wipe it dry
immediately.
' Use and store the Baby Mantis only in honnal
temperature environments.
0 Handle the product gently and caretuliy. Don't drop
ll.
BATTERY WARNING
Do not trilx old and new batteries.
Do not "le alkaline, standard tcarbbri-zirtcl Wilh
rechargeable lnickelcadmium) batteries.
Non-rechargeable batteries are not to be recharged.
Rechargeable batteries are re tie remuved hunt the
toy before helng charged.
Rechargeable batteries are only to he charged under
adult supervision,
Only batteries or the same or equlvatent type as
recommended are to be used.
Batteries are to be inserted With the correct polarity,
Exhausled batteries are to be removed trim the toy
The supply terminals are nut to be short-circuited.
A WARNING:
CHOKING HAZARD-Small parts
Not for chlldren under 3 years
Warning: Changes er modtltcsbons to this unit not expressly approved by the party responsible tor compltance could void the users authoniy to operate the equipment.
NOTE: This equipment has been tested and round to comply wint the limits lot a Class B dignal devree, pursuant to Part 15 or the FCC Rules These rims are designed to
ptovtde reasonable protectlon against harmrui interterence in e teemnlial instariattori This equipment generates. uses and can radiate radii: rrequency energy and. it not
installed and used in aooordande With the instructions, may cause harrnrui intefrererice to radio communications
However. there is no guarantee that intertelence will not occur in a particular installation li this aqutpment does taause harmrui interference to radio or television reception.
vhnorl can be dstenhined by turning the equipment on and on. the user is encouraged to try to correct the interference by one or more or the roitewing measures,
Moditying or tempering vvith me nstt or transmitters internal components can cause a mairuhction and
void your FCC authorimtion to sperate them
This daihoe complies with Part is at the FCC Rules
Operation is subteet to the roiimrihg two aondrlicins
tti This device may not cause harmiui inteflelenoei and
(at This device must accept any interrerertoe received including
intent-trance that may cause undesired operation
i:| Reoriehi or relocate the receiving antenna
D Increase the separation between the equipment and reoeiver
t:i Connect tile equipment into an outlet on a circuit dilterent trom that to which the reoeiver is needed
i:i Consult the dealer or an experieroed radio/W lechntciart tor heip.

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.2
Linearized                      : No
Creator                         : HP 9100C Digital Sender
Create Date                     : 2004:06:11 12:16:29
Author                          : ITS ELECTRIC TOY
Producer                        : 
Title                           : 
Subject                         : manual
Modify Date                     : 2004:06:11 12:44:35+08:00
Page Count                      : 1

EXIF Metadata provided by EXIF.tools