Sure Wave CQL1416-B Bluetooth Speaker User Manual
Sure Wave (HongKong) Limited Bluetooth Speaker
User Manual
CQL1416-B Bluetooth Speaker
Instruction Manual (Read before proceeding)
Power:
Works on internal rechargeable Lithium battery. Please charge your speaker fully
before first use. To charge the battery :
Using a Micro USB cable (included), insert the jack into ”Charging” jack located at the
back of the unit and then plug the USB connecter into the USB port on a computer for
charging.
A red light aside will indicate the charging situation. When battery is full, the red light
will turn off automatically.
Bluetooth Speaker Operation
Turn switch “Off/ /Aux” at the back to “ /Aux” position, a Blue light aside will start
blinking to indicate the speaker is in paring mode and searching for your Bluetooth
mobile device.
Bluetooth speaker device name is “SB-01”, connect it via the option menu of your
mobile device, pairing mode is 0000 if any is required. The Blue light will begin to
flash slowly after pair is completed.
Start playing music on your device. Keep your device within 33feet (10m) of your
speaker.
Adjust the volume of your device to a comfortable level.
Turn off the unit when not in used.
Universal Speaker Operation
For other music devices without Bluetooth, use the attached audio input cable. Insert
the 3.5 mm jacks into the “Aux-in” jack at back and into the earphone jack on your
device.
Turn on the unit and start playing music.
Turn off the unit when not in used.
Caution:
This is not a toy. Please keep away from small children.
Please keep away from water / heat.
Low power may cause poor connection even no working of Bluetooth.
Do not over charge the battery.
FCC Statement
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help
This device complies with part 15 of the FCC rules. Operation is subject to the
following two conditions (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation